RESUMEN
Oceanic lithosphere moves over a mechanically weak layer (asthenosphere) characterized by low seismic velocity and high attenuation. Near mid-ocean ridges, partial melting can produce such conditions because of the high-temperature geotherm. However, seismic observations have also shown a large and sharp velocity reduction under oceanic plates at the lithosphere-asthenosphere boundary (LAB) far from mid-ocean ridges. Here, we report the effect of water on the seismic properties of olivine aggregates in water-undersaturated conditions at 3 GPa and 1,223 to 1,373 K via in-situ X-ray observation using cyclic loading. Our results show that water substantially enhances the energy dispersion and reduces the elastic moduli over a wide range of seismic frequencies (0.5 to 1,000 s). An attenuation peak that appears at higher frequencies (1 to 5 s) becomes more pronounced as the water content increases. If water exists only in the asthenosphere, this is consistent with the observation that the attenuation in the asthenosphere is almost constant over a wide frequency range. These sharp seismic changes at the oceanic LAB far from mid-ocean ridges could be explained by the difference in water content between the lithosphere and asthenosphere.
RESUMEN
To understand mantle dynamics, it is important to determine the rheological properties of bridgmanite, the dominant mineral in Earth's mantle. Nevertheless, experimental data on the viscosity of bridgmanite are quite limited due to experimental difficulties. Here, we report viscosity and deformation mechanism maps of bridgmanite at the uppermost lower mantle conditions obtained through in situ stress-strain measurements of bridgmanite using deformation apparatuses with the Kawai-type cell. Bridgmanite would be the hardest among mantle constituent minerals even under nominally dry conditions in the dislocation creep region, consistent with the observation that the lower mantle is the hardest layer. Deformation mechanism maps of bridgmanite indicate that grain size of bridgmanite and stress conditions at top of the lower mantle would be several millimeters and ~105 Pa to realize viscosity of 1021-22 Pa·s, respectively. This grain size of bridgmanite suggests that the main part of the lower mantle is isolated from the convecting mantle as primordial reservoirs.
RESUMEN
The 660-km seismic discontinuity, which is a significant structure in the Earth's mantle, is generally interpreted as the post-spinel transition, as indicated by the decomposition of ringwoodite to bridgmanite + ferropericlase. All precise high-pressure and high-temperature experiments nevertheless report 0.5-2 GPa lower transition pressures than those expected at the discontinuity depth (i.e. 23.4 GPa). These results are inconsistent with the post-spinel transition hypothesis and, therefore, do not support widely accepted models of mantle composition such as the pyrolite and CI chondrite models. Here, we present new experimental data showing post-spinel transition pressures in complete agreement with the 660-km discontinuity depth obtained by high-resolution in situ X-ray diffraction in a large-volume high-pressure apparatus with a tightly controlled sample pressure. These data affirm the applicability of the prevailing mantle models. We infer that the apparently lower pressures reported by previous studies are experimental artefacts due to the pressure drop upon heating. The present results indicate the necessity of reinvestigating the position of mantle mineral phase boundaries previously obtained by in situ X-ray diffraction in high-pressure-temperature apparatuses.
RESUMEN
We developed methods to use synthesized boron-doped diamond (BDD) as a heater in a multi-anvil high-pressure apparatus. The synthesized BDD heater could stably generate an ultra-high temperature without the issues (anomalous melt, pressure drop, and instability of heating) arising from oxidation of boron into boron oxide and graphite-diamond conversion. We synthesized BDD blocks and tubes with boron contents of 0.5-3.0 wt. % from a mixture of graphite and amorphous boron at 15 GPa and 2000 °C. The electrical conductivity of BDD increased with increasing boron content. The stability of the heater and heating reproducibility were confirmed through repeated cycles of heating and cooling. Temperatures as high as â¼3700 °C were successfully generated at higher than 10 GPa using the BDD heater. The effect of the BDD heater on the pressure-generation efficiency was evaluated using MgO pressure scale by in situ X-ray diffraction study at the SPring-8 synchrotron. The pressure-generation efficiency was lower than that using a graphite-boron composite heater up to 1500 tons. The achievement of stable temperature generation above 3000 °C enables melting experiments of silicates and determination of some physical properties (such as viscosity) of silicate melts under the Earth's lower mantle conditions.
RESUMEN
Seismic shear wave anisotropy is observed in Earth's uppermost lower mantle around several subducted slabs. The anisotropy caused by the deformation-induced crystallographic preferred orientation (CPO) of bridgmanite (perovskite-structured (Mg,Fe)SiO3) is the most plausible explanation for these seismic observations. However, the rheological properties of bridgmanite are largely unknown. Uniaxial deformation experiments have been carried out to determine the deformation texture of bridgmanite, but the dominant slip system (the slip direction and plane) has not been determined. Here we report the CPO pattern and dominant slip system of bridgmanite under conditions that correspond to the uppermost lower mantle (25 gigapascals and 1,873 kelvin) obtained through simple shear deformation experiments using the Kawai-type deformation-DIA apparatus. The fabrics obtained are characterized by [100] perpendicular to the shear plane and [001] parallel to the shear direction, implying that the dominant slip system of bridgmanite is [001](100). The observed seismic shear- wave anisotropies near several subducted slabs (Tonga-Kermadec, Kurile, Peru and Java) can be explained in terms of the CPO of bridgmanite as induced by mantle flow parallel to the direction of subduction.
RESUMEN
Seismological observations show that, in some regions of the lower mantle, an increase in bulk sound velocity, interestingly, occurs in the same volume where there is a decrease in shear velocity. We show that this anti-correlated behavior occurs on cation substitution in bridgmanite by making single crystal elasticity measurements of MgSiO3 and (Mg,Fe,Al)(Si,Al)O3 using inelastic x-ray scattering in the ambient conditions. Cation substitution of ferrous iron and aluminum may explain large low shear velocity provinces in the lower mantle.
RESUMEN
A system for stress measurement under high pressure has been developed at beamline BL04B1, SPring-8, Japan. A Kawai-type multi-anvil apparatus, SPEED-1500, was used to pressurize polycrystalline KCl to 9.9 GPa in a mechanically anisotropic cell assembly with the KCl sample sandwiched between dense Al(2)O(3) pistons. The variation of deviatoric stress was determined from the lattice distortion measured using two-dimensional X-ray diffraction with monochromatic synchrotron X-rays. The low-pressure B1 phase transformed to the high-pressure polymorph B2 during compression. The deviatoric stress increased with increasing pressure in both the B1 and B2 phases except for the two-phase-coexisting region at a pressure of 2-3 GPa. This new system provides one of the technical foundations for conducting precise rheological measurements at conditions of the Earth's lower mantle.
