Polyethyleneimine in designed nanocomposite based magnetic halloysite nanotubes for extraction and determination of gallic acid in green tea.

An innovative and simple nanocomposite denoted as MHNTs@PEI was synthesized for gallic acid (GA) analytical sample pretreatment. Polyethyleneimine (PEI) functionalized was binded onto magnetic halloysite nanotubes (MHNTs) to inhence adsorption capacity. MHNTs@PEI was obtained only through two steps modification (amination and PEI modification). Characterizations showed that there are layers of synthetic PEI on the tubular structure of the material and magnetic spheres on its surface, both indicating successful synthesis of the nanocomposite. Furthermore, the adsorption isotherms and kinetic modeling showed that the Langmuir model and pseudo-first-order model fit the adsorption data, respectively. MHNTs@PEI achieved an adsorption capacity of 158 mg·g-1. Overall, the abundant adsorption sites significantly improved the adsorption performance of the MHNTs@PEI. Regeneration tests demonstrated that the MHNTs@PEI exhibits effective adsorption, even after undergoing five consecutive cycles. Optimization of key parameters (ratio, volume of elution, elution time and frequency) in the process of adsorption and desorption was also conducted. The limit of detection (LOD) and that of the quantification (LOQ) were 0.19 and 0.63 µg·mL-1, respectively, and the recoveries were 95.67-99.43 %. Finally, the excellent magnetism (43.5 emu·g-1) and the adsorption feature of MHNTs@PEI enabled its successful utilization in analytical sample pretreatment through the extraction of GA from green tea.

Portable paper-based probe for on-site ratiometric fluorescence determination of total flavonol glycosides in plant extract using smartphone imaging.

A smartphone-assisted, paper-based ratio fluorescence probe is presented for the rapid, low-cost and on-site quantification of total flavonol glycosides in Ginkgo biloba extracts (GBE). The Al3+/Eu-MOF/paper-based probe utilizes lanthanide metal-organic framework (Ln-MOF) nanoparticles immobilized on Whatman filter paper along with Al3+ for detecting flavonols, which are the hydrolyzed products of flavonol glycosides. The color change of the paper-based fluorescence image from red to orange depends on the concentration of the target analyte in the sample solution. The smartphone equipped with a red, green, blue (RGB) color detector measured the fluorescence signal intensity on the paper substrate after adding flavonol. The analytical variables affecting the performance of the probe, including the addition sequence of the aluminum nitrate solution, its concentration, that of the Ln-MOF solution, the drying time of the paper probe, the reaction time and the sensitivity parameters of the mobile phone camera (ISO), were optimized. Under optimal conditions, the Al3+/Eu-MOF/paper-based probe has good linear response in the concentration range 7 ~ 80 µg mL- 1 and a lower detection limit of 2.07 µg mL- 1. The results obtained with the paper-based ratio fluorescence probe and smartphone combination were validated by comparing them with high-performance liquid chromatography (HPLC) measurements. This study provides a potential strategy for fabricating Al3+/Eu-MOF/paper-based probe used for total flavonol glycosides determination.