Investigation of optimal conditions needed for the production of indigo and subsequent dyeing using CO2/O2 sensors and a cellphone camera.

An investigation of the process involved in the production of and dyeing with indigo based on a CO2/O2 sensor device and a cellphone-camera is reported. The former involves transforming indican to indigo, and the latter the process by which indigo and indigo-white are produced. During the process of indigo production, a clear and positive correlation can be observed between the concentration of gas levels (either the production of CO2 or the consumption of O2) and the final yield. The authors found that for the first time that the change in the concentration levels of CO2/O2 can be used as important parameters for indigo dyeing. The optimal time required to produce indigo can be decided by the change of CO2/O2 concentration level. It is no long should depending on the experience of a craftsperson. Furthermore, the optimal time needed to produce indigo also can be decided by the concentration levels of glucose. The color analysis of indigo dyeing can be performed by using a camera and by calculating the RGB and HSV (hue, saturation, value) values.

Photodissociation dynamics of fluorobenzene (C6H5F) at 157 and 193 nm: Branching ratios and distributions of kinetic energy.

Following photodissociation of fluorobenzene (C6H5F) at 193 and 157 nm, we detected the products with fragmentation-translational spectroscopy by utilizing a tunable vacuum ultraviolet beam from a synchrotron for ionization. Between two primary dissociation channels observed upon irradiation at 193 (157) nm, the HF-elimination channel C6H5F --> HF + C6H4 dominates, with a branching ratio of 0.94+/-0.02 (0.61+/-0.05) and an average release of kinetic energy of 103 (108) kJ mol(-1); the H-elimination channel C6H5F --> H + C6H4F has a branching ratio of 0.06+/-0.02 (0.39+/-0.05) and an average release of kinetic energy of 18.6 (26.8) kJ mol(-1). Photofragments H, HF, C6H4, and C6H4F produced via the one-photon process have nearly isotropic angular distributions. Both the HF-elimination and the H-elimination channels likely proceed via the ground-state electronic surface following internal conversion of C6H5F; these channels exhibit small fractions of kinetic energy release from the available energy, indicating that the molecular fragments are highly internally excited. We also determined the ionization energy of C6H4F to be 8.6+/-0.2 eV.

Molecular elimination in photolysis of o- and p-fluorotoluene at 193 nm: Internal energy of HF determined with time-resolved Fourier transform spectroscopy.

Following the photodissociation of o-fluorotoluene [o-C(6)H(4)(CH(3))F] at 193 nm, rotationally resolved emission spectra of HF(1< or =v< or =4) in the spectral region of 2800-4000 cm(-1) are detected with a step-scan Fourier transform spectrometer. HF(v< or =4) shows nearly Boltzmann-type rotational distributions corresponding to a temperature approximately 1080 K; a short extrapolation from data in the period of 0.5-4.5 mus leads to a nascent rotational temperature of 1130+/-100 K with an average rotational energy of 9+/-2 kJ mol(-1). The observed vibrational distribution of (v=1):(v=2):(v=3)=67.6: 23.2: 9.2 corresponds to a vibrational temperature of 5330+/-270 K. An average vibrational energy of 25+/-(3) (12) kJ mol(-1) is derived based on the observed population of HF(1< or =v< or =3) and estimates of the population of HF (v=0 and 4) by extrapolation. Experiments performed on p-fluorotoluene [p-C(6)H(4)(CH(3))F] yielded similar results with an average rotational energy of 9+/-2 kJ mol(-1) and vibrational energy of 26+/-(3) (12) kJ mol(-1) for HF. The observed distributions of internal energy of HF in both cases are consistent with that expected for four-center elimination. A modified impulse model taking into account geometries and displacement vectors of transition states during bond breaking predicts satisfactorily the rotational excitation of HF. An observed vibrational energy of HF produced from fluorotoluene slightly smaller than that from fluorobenzene might indicate the involvement of seven-membered-ring isomers upon photolysis.

Photodissociation dynamics of formyl fluoride (HFCO) at 193 nm: branching ratios and distributions of kinetic energy.

Following photodissociation of formyl fluoride (HFCO) at 193 nm, we detected products with fragmentation translational spectroscopy utilizing a tunable vacuum ultraviolet beam from a synchrotron for ionization. Among three primary dissociation channels observed in this work, the F-elimination channel HFCO-->HCO+F dominates, with a branching ratio approximately 0.66 and an average release of kinetic energy approximately 55 kJ mol(-1); about 17% of HCO further decomposes to H+CO. The H-elimination channel HFCO-->FCO+H has a branching ratio approximately 0.28 and an average release of kinetic energy approximately 99 kJ mol(-1); about 21% of FCO further decomposes to F+CO. The F-elimination channel likely proceeds via the S1 surface whereas the H-elimination channel proceeds via the T1 surface; both channels exhibit moderate barriers for dissociation. The molecular HF-elimination channel HFCO-->HF+CO, correlating with the ground electronic surface, has a branching ratio of only approximately 0.06; the average translational release of 93 kJ mol(-1), approximately 15% of available energy, implies that the fragments are highly internally excited. Detailed mechanisms of photodissociation are discussed.