RESUMEN
In Henan, strawberry cultivation occurs on approximately 10,000 hectares, with annual production approaching 230,000 tons. In April 2022, a root rot disease with a 10% incidence rate was observed on the strawberry cultivars 'Ningyu' and 'Sweet Charlie' grown in plastic greenhouses (0.7 ha) located in Xingyang (113.39°E, 34.79°N), Henan, China. Disease symptoms included yellowing of the outer mature leaves, stunted growth, and subsequent wilting of the entire plant. The roots developed dark brown spots, which gradually turned necrotic (Figures 1a, 1b). To determine the causal agent, four symptomatic plants (two plants per cultivar) were collected. Twelve symptomatic root tissues (three root tissue samples per plant) were surface sterilized with 75% ethanol and 0.1% mercuric chloride, washed thrice in sterile water, air dried, and then placed on PDA at 25°C for 3 days. Eight pure isolates were obtained by hyphal-tip isolation (Fang 2007). Each colony had a dark olivaceous green to brown, cottony appearance with a round margin, and the reverse side was grey-black near the center (Figure 1c). Conidia were ellipsoidal, aseptate, with rounded ends, and 3.1 to 4.8 µm × 1.0 to 2.5 µm in size (Figure 1d). Chlamydospores were ellipsoidal, pale brown, and 7.9 to 11.9 µm × 7.6 to 10.7 µm in size (Figure 1e). A representative fungus isolate, designated as Z5, was selected for further molecular identification. Genomic DNA was extracted from the mycelia of isolate Z5, and four gene partial regions (ITS, TUB2, RPB2, and LSU) were amplified using the primer pairs ITS1/ITS4, Bt-2a/Bt-2b, RPB2-5F/RPB2-7CR and LROR/LR5, respectively (White et al.1990, O'Donnell et al.1997, Reeb et al. 2004, Rehner and Samuels 1994). PCR products were sequenced and submitted to GenBank with the following accession numbers OQ130480 (ITS), OQ190093 (TUB2), OQ190092 (RPB2), and OQ255570 (LSU). BLASTn search revealed that the ITS, TUB2, RPB2, and LSU gene sequences of isolate Z5 showed 99.42% (513/516 bp), 99.69% (320/321 bp), 100% (1071/1071 bp), and 100% (857/857 bp) identity with those of ex-type S. pogostemonis stain ZHKUCC 21-0001 (Dong et al. 2021), respectively. A phylogenetic tree was constructed showing that Z5 clustered with S. pogostemonis (Figure 2). The isolates in this study were identified as S. pogostemonis based on morphological and molecular evidence. To confirm pathogenicity, five one-month-old 'Ningyu' cultivar strawberry seedlings were planted in sterilized nursery soil mixed with wheat grains (0.5% w/w) coated with Z5 mycelia (Fang 2007). An equal number of strawberry seedlings were placed in pots filled with non-infected potting mix to serve as controls. The seedlings were kept in a greenhouse under a 12 h light/dark photoperiod at 25°C. After two weeks, the inoculated seedlings displayed symptoms such as leaf wilting and root necrosis, similar to those observed in the greenhouses, while the control seedlings showed no symptoms (Figures 1f, 1g). The experiment was performed thrice. The identical fungus was re-isolated from the symptomatic roots and identified as S. pogostemonis based on morphological characteristics and molecular analysis, thus fulfilling Koch's postulates. This is the first report of S. pogostemonis causing root rot on strawberries worldwide. Our findings will contribute to a more comprehensive study on investigating and managing this disease.
RESUMEN
Two-dimensional (2D) membrane materials are widely employed for the accurate sieving of ionic contaminants and are of great importance for water reuse. However, 2D membrane materials often suffer from uneven thickness and surface defects, which severely limit their application prospects. Herein, a continuous 2D membrane (LCUM/D) was prepared using cellulose nanofibrils (CNFs) as the support backbone for the assembled layered double hydroxides (LDHs) and dopamine (DA) as the adhesive. The results demonstrated that LDHs could be uniformly distributed in the network structure of CNFs, and the defects on the membrane surface could be effectively compensated by DA. Simultaneously, the continuous LCUM/D showed excellent rejection (97.18%) and selectivity of ionic contaminants tellurium. Dopamine not only compensated for the surface defects of the 2D membrane and enhanced the rejection of tellurium, but also caused no significant loss of water permeance. Moreover, the LCUM/D exhibited stability, which facilitated its long-term application. In addition, the improved hydrophilicity allowed LCUM/D satisfactory anti-fouling properties. This study provides new dimensional insights into the fabrication of continuous 2D membranes for the removal of ionic contaminant and enhances their application prospects in wastewater treatment.
RESUMEN
Tellurium is massively used as the main light-absorbing layer component in the manufacturing of CdTe thin-film solar cells, a critical component in the photovoltaic industry. However, the process of manufacturing and renewing components has produced large amounts of tellurium-containing wastewater that is difficult to degrade and poses a serious threat to the aquatic ecosystem and human health. Hence, to achieve the recovery of tellurium resources for reducing their damages, a win-win approach was employed to utilize waste lignin to construct functional copper-doped activated lignin (CAL) adsorbents for selective separation and recovery of tellurium from wastewater. CAL exhibited superior adsorption properties towards tellurium (248.45 mg/g), mainly attributed to the adsorption mechanism of coordination interactions. Kinetic and isotherm results elucidated that monolayer chemisorption dominated CAL adsorption process. Besides, CAL had a satisfactory regeneration capability with minimal loss adsorption capacity after six consecutive cycles, which also exhibited high antifouling properties. Meanwhile, CAL achieved high selectivity for tellurium adsorption under the simulated wastewater, revealing the potential of CAL for practical application in wastewater. Therefore, this work provides a promising environmental strategy for exploring the application of lignin-based materials for tellurium recovery from wastewater.
