RESUMEN
Effect of puffing on conversion of gingerols to shogaols, physicochemical properties as well as antioxidant and anti-inflammatory activities of puffed ginger was investigated. Puffing significantly increased extraction yield and the highest value was 12.52% at 980 kPa. The significant decrease in gingerols and increase in shogaols were occurred after puffing, respectively. Especially, 6-shogaol was dramatically increased from 4.84 to 99.10 mg/g dried ginger. Puffed ginger exhibited the higher antioxidant activities (analyzed by DPPH, ABTS, TPC, and TFC) than those of control, and they were significantly increased with increasing puffing pressure. In case of anti-inflammatory activity, puffed ginger did not inhibit NO production, but significantly inhibited TNF-α and IL-6 productions. Among gingerols and shogaols, 6-shogaol showed significantly strong correlations with both antioxidant and anti-inflammatory activities. Consequently, puffed ginger can be applied to functional food industry, which dramatically increased the contents of 6, 8, 10-shogaols, the main bioactive compounds in ginger.
Asunto(s)
Antiinflamatorios , Antioxidantes , Catecoles , Alcoholes Grasos , Extractos Vegetales , Zingiber officinale , Zingiber officinale/química , Catecoles/química , Catecoles/análisis , Antioxidantes/química , Antiinflamatorios/química , Antiinflamatorios/farmacología , Alcoholes Grasos/química , Alcoholes Grasos/análisis , Alcoholes Grasos/farmacología , Extractos Vegetales/química , Extractos Vegetales/farmacología , Animales , RatonesRESUMEN
Corn starch was gelatinized by high hydrostatic pressure (HHP) and spray drying to make amorphous granular starch (AGS), and their physicochemical properties were compared with the conventionally prepared (heat-gelatinized and spray dried) AGS to devise a novel AGS preparation methodology. Pressure-induced (PAGS) and heat-induced AGS (HAGS) maintained their granular shape but lost their birefringence indicating that both methods could prepare AGS. DSC (differential scanning calorimeter) and XRD (X-ray diffraction) analysis confirmed the complete loss of amylopectin double helices and crystallinity of both PAGS and HAGS. However, their swelling power, solubility, RVA pasting properties, acid/shear stability, gel forming ability and textural properties were completely different. PAGS exhibited constrained swelling, suppressed amylose leaching, and reduced viscosity. Notably, HAGS formed a gel without heating, whereas PAGS yielded a viscous paste with water-soluble attributes. Even after reheating, PAGS maintained its granular structure with comparably less swelling and weaker gel strength than HAGS. Consequently, newly developed PAGS exhibited distinctive characteristics compared to the conventional HAGS, such as lower solubility and swelling power, viscosity, textural properties, and high acid and shear stabilities, rendering it a viable option for various applications within the food industry.
Asunto(s)
Secado por Pulverización , Almidón , Almidón/química , Presión Hidrostática , Amilosa/química , Amilopectina/química , ViscosidadRESUMEN
Starch is an abundant natural, non-toxic, biodegradable polymer. Due to its low price, it is used for various purposes in various fields such as the cosmetic, paper, and construction industries as well as the food industry. Due to recent consumer interest in clean label materials, physically modified starch is attracting attention. Manufacturing methods of physically modified starch include pregelatinization, hydrothermal treatment such as heat moisture treatment and annealing, hydrostatic pressure treatment, ultrasonic treatment, milling, and freezing. In this study, toward development of clean label materials, manufacturing methods and characteristics of physically modified starches were discussed.
RESUMEN
Self-assembly (formation and crystallization) kinetics of short-chain glucan aggregates (SCGAs) prepared at isothermal conditions (4, 20, 40, and 60â) with or without nucleation (4â, 1 h) were investigated. The fastest formation and crystallization rates of SCGA were observed when short-chain glucan was stored at 4â and 20â, respectively. SCGA was not formed at 60â. However, nucleation resulted in SCGA forming-ability at 60â. Moreover, nucleation increased the yield in all temperature conditions. SCGA with nucleation decreased the crystal melting transition temperature range. All SCGAs had nanosized particles (<500 nm) with B-type crystal patterns regardless of temperature and nucleation. Consequently, self-assembly temperature and presence of nucleation step could change the physicochemical characteristics of SCGA, and manipulation of the nucleation step is expected to be an effective method to increase the yield of SCGA and produce SCGA at high temperature.
Asunto(s)
Glucanos , Cinética , Cristalización , Temperatura , Temperatura de TransiciónRESUMEN
The effects of concentration, temperature, and time on infusion of fluorescein into corn and waxy rice starches and their controlled release pattern were investigated. At low fluorescein concentration (1 µM), temperature significantly affected infusion efficiency. At high fluorescein concentration (50-150 µM), temperature showed little effect; fluorescein concentration significantly affected infusion efficiency. Corn starch showed relatively higher infusion efficiency than waxy rice starch at high concentration. During controlled release, 50% and 81% of infused fluorescein were released from corn and waxy rice starches, respectively, after bacterial α-amylase treatment. However, 61% and 68% of infused fluorescein were released from corn and waxy rice starches, respectively, after pancreatic α-amylase treatment. The dextrose equivalent (DE) value revealed similar patterns, suggesting that degradation of starch by different α-amylases is a major factor affecting release of fluorescein from starch granules. Moreover, granule size of starch greatly affected enzymatic hydrolysis and controlled release in this system. Supplementary Information: The online version contains supplementary material available at 10.1007/s10068-022-01059-2.
RESUMEN
Fluorescein isothiocyanate-dextrans (FDs) of different molecular weights were infused into corn, waxy rice, tapioca, and potato starches under atmospheric and high hydrostatic pressures (HHP). FD4, FD10, FD20, and FD40 (Mw 4000, 10,000, 20,000, and 40,000, respectively) were used as infusion materials. Confocal laser scanning microscopy confirmed that all FDs except FD40 infused into corn, waxy rice, and tapioca starches. However, no FDs infused into potato starch. Corn starch had the highest amounts of infused FDs. As molar mass increased, the amount of infused FD decreased in all starches. The infused amounts of FDs in corn starch were similar at 200-300 MPa and atmospheric pressure. Infusion of FDs at 400 MPa was reduced due to partial gelatinization. These results confirm that infusion efficiency is inversely proportional to the molecular weight of the infused material and large materials (Mw > 40,000) cannot be infused into starch granules under atmospheric pressure or HHP. SUPPLEMENTARY INFORMATION: The online version contains supplementary material available at 10.1007/s10068-021-00972-2.
RESUMEN
In this study, the rheological properties of several commercial rice noodle strands were investigated. In the bending test, failure stress decreased as the cooking temperature increased from 80 to 90 °C, and the cooking time increased from 3 to 4 min for higher rice content noodles (>60%). The stress-relaxation test and sensory tests were carried out with bundles of noodles to investigate correlations with the bending test. The modulus of elasticity was higher at 80 than 90 °C. However, no correlation was found between cooking temperature and the rheological properties of lower rice content noodles. In the stress relaxation test, the deviation was larger due to the empty space in the bundle. In the correlation analysis, sensory stickiness was correlated with a modulus of elasticity in the bending test. Comparing the bending and stress-relaxation tests, each instrumental variable showed differences in the rheological properties of rice noodles in strands and bundles. However, the bending test measured with noodle strands seemed to be most suitable as a method of measuring the rheological properties of rice noodles.
RESUMEN
Using restructuring technology, A- or B-type crystalline granular potato starch was produced from amorphous granular potato starch (AGPS). AGPS was prepared using ethanol-heat processing, and hydrothermal treatments were performed with different moisture contents (18, 29, 200% d.b.) and temperatures (4, 25, 40, 60, 80 °C) for 3 weeks. AGPS showed no endothermic peak in a DSC thermogram, while hydrothermally treated AGPS (HAGPS) revealed endothermic peaks. In X-ray diffraction, AGPS displayed an amorphous pattern, and HAGPS displayed A- or B-type crystalline patterns depending on treatment temperature and moisture content. Neither AGPS nor HAGPS had typical RVA pasting curves, and their viscosities gradually increased. Raman spectroscopy and FT-IR confirmed that ordered structure and crystalline regions increased in HAGPS. Resistant starch (RS) and slowly digestible starch (SDS) contents of HAGPS increased but rapidly digestible starch (RDS) content decreased compared to AGPS. These results elucidated that hydrothermal treatment could change the physicochemical properties of AGPS and produce an identical material, such as granular potato starch with A-type and B-type crystalline granular potato starch.
Asunto(s)
Etanol/química , Solanum tuberosum/química , Almidón/química , Cristalografía por Rayos X , Calor , Hidrólisis , Espectroscopía Infrarroja por Transformada de Fourier , Viscosidad , Difracción de Rayos XRESUMEN
Physicochemical properties of acetylated (AC), cross-linked (CL), and hydroxypropylated (HP) chestnut starches were investigated. Modified chestnut starch showed low RS and amylose contents. AC revealed the highest solubility and HP showed the highest swelling power at 60 °C. CL showed the lowest solubility and swelling power at both 60 and 90 °C. AC and HP showed a lower pasting temperature and higher peak viscosity than native chestnut starch (NC). Modified chestnut starch formed gels at higher solid content than NC. CL had the lowest freeze-thaw stability, and AC and HP showed the strongest tolerance to freeze-thaw cycles. Amylopectin melting enthalpy of NC dramatically increased over the first 2 days and continued increasing gradually until day 24. On the other hand, all the modified chestnut starches showed a slight increase in amylopectin melting enthalpy, indicating retarded retrogradation. CL showed the lowest degree of retrogradation, followed by HP, AC, and NC.
RESUMEN
The objective of this study was to develop new drug delivery systems (DDS) and nutrient delivery systems (NDS), using starch as a carrier material for infusion technology. Corn, waxy rice, non-waxy rice, and potato starches were used as carrier materials. Sodium fluorescein was used as an infusion material for easy detection. Each starch suspension with sodium fluorescein was reacted in a water bath at 40, 50, and 60 °C for 30 min. After each reaction, the concentration of sodium fluorescein in the supernatant was measured using a fluorescence detector. Precipitated starch was observed using fluorescence microscopy. About 70% of sodium fluorescein infused in waxy rice and corn starches at 60 °C. Additionally, the granules of these two starches were luminous by green light when exposed to a fluorescence detector, suggesting that corn and waxy rice starches can be used as carrier materials in infusion technology for DDS and NDS.