Bolometric IR photoresponse based on a 3D micro-nano integrated CNT architecture.

A new 3D micro-nano integrated M-shaped carbon nanotube (CNT) architecture was designed and fabricated. It is based on vertically aligned carbon nanotube arrays composed of low-density, mainly double-walled CNTs with simple lateral external contacts to the surroundings. Standard optical lithography techniques were used to locally tailor the width of the vertical block structure. The complete sensor system, based on a broadband blackbody absorber region and a high-resistance thermistor region, can be fabricated in a single chemical vapor deposition process step. The thermistor resistance is mainly determined by the high junction resistances of the adjacent aligned CNTs. This configuration also provides low lateral thermal conductivity and a high temperature coefficient of resistance (TCR). These properties are advantageous for new bolometric sensors with high voltage responsivity and broadband absorption from the infrared (IR) to the terahertz spectrum. Preliminary performance evaluations have shown current and voltage responsivities of 2 mA/W and 30 V/W, respectively, in response to IR (980 nm) absorption for a 20 × 20 µm2 device. The device exhibits an exceptionally fast response time of ≈0.15 ms, coupled with a TCR of -0.91 %/K. These attributes underscore its high operating speed and responsivity, respectively. In particular, the device maintains excellent thermal stability and reliable operation at elevated temperatures in excess of 200 °C, extending its potential utility in challenging environmental conditions. This design allows for further device miniaturization using optical lithography techniques. Its unique properties for mass production through large-scale integration techniques make it important for real-time broadband imaging systems.

Direct Near-Field Observation of Surface Plasmon Polaritons on Silver Nanowires.

Surface plasmon polaritons on (silver) nanowires are promising components for future photonic technologies. Here, we study near-field patterns on silver nanowires with a scattering-type scanning near-field optical microscope that enables the direct mapping of surface waves. We analyze the spatial pattern of the plasmon signatures for different excitation geometries and polarization and observe a plasmon wave pattern that is canted relative to the nanowire axis, which we show is due to a superposition of two different plasmon modes, as supported by electromagnetic simulations including the influence of the substrate. These findings yield new insights into the excitation and propagation of plasmon polaritons for applications in nanoplasmonic devices.

Synthesis, characterization, electronic and gas-sensing properties towards H2 and CO of transparent, large-area, low-layer graphene.

Low-layered, transparent graphene is accessible by a chemical vapor deposition (CVD) technique on a Ni-catalyst layer, which is deposited on a <100> silicon substrate. The number of graphene layers on the substrate is controlled by the grain boundaries in the Ni-catalyst layer and can be studied by micro Raman analysis. Electrical studies showed a sheet resistance (R(sheet)) of approximately 1435 Ω per □, a contact resistance (R(c)) of about 127 Ω, and a specific contact resistance (R(sc)) of approximately 2.8×10(-4) â€…Ω cm(2) for the CVD graphene samples. Transistor output characteristics for the graphene sample demonstrated linear current/voltage behavior. A current versus voltage (I(ds)-V(ds)) plot clearly indicates a p-conducting characteristic of the synthesized graphene. Gas-sensor measurements revealed a high sensor activity of the low-layer graphene material towards H(2) and CO. At 300 °C, a sensor response of approximately 29 towards low H(2) concentrations (1 vol %) was observed, which is by a factor of four higher than recently reported.

A self-supporting monolith of highly aligned carbon nanotubes as device structure for sensor applications.

A novel approach towards fabricating free-standing and self-supporting highly aligned CNT arrays with integrated top and bottom contacts for the design and implementation of future CNT-based sensor devices is reported.