Nano-optical designs for high-efficiency monolithic perovskite-silicon tandem solar cells.

Perovskite-silicon tandem solar cells offer the possibility of overcoming the power conversion efficiency limit of conventional silicon solar cells. Various textured tandem devices have been presented aiming at improved optical performance, but optimizing film growth on surface-textured wafers remains challenging. Here we present perovskite-silicon tandem solar cells with periodic nanotextures that offer various advantages without compromising the material quality of solution-processed perovskite layers. We show a reduction in reflection losses in comparison to planar tandems, with the new devices being less sensitive to deviations from optimum layer thicknesses. The nanotextures also enable a greatly increased fabrication yield from 50% to 95%. Moreover, the open-circuit voltage is improved by 15 mV due to the enhanced optoelectronic properties of the perovskite top cell. Our optically advanced rear reflector with a dielectric buffer layer results in reduced parasitic absorption at near-infrared wavelengths. As a result, we demonstrate a certified power conversion efficiency of 29.80%.

Photosynthetic production of biodiesel in Synechocystis sp. PCC6803 transformed with insect or plant fatty acid methyltransferase.

Biodiesel contains methyl or ethyl esters of long-chain fatty acids and has recently attracted increasing attention. Microalgae have emerged as a sustainable biodiesel production system owing to their photosynthetic potential. However, the conversion of microalgal biomass to biodiesel requires high energy and is costly. This study aimed to overcome the high cost of the pretreatment process by generating cyanobacteria converting fatty acids to fatty acids methyl ester (FAME) in vivo by introducing the fatty acid methyl ester transferase (FAMT) gene. Two FAMT genes from Drosophila melanogaster and Arabidopsis thaliana were selected and their codons were optimized for insertion in the Synechocystis sp. PCC6803 genome through homologous recombination, respectively. FAMT mRNA and protein expression levels were confirmed through reverse-transcription PCR and western blot analysis, respectively. Furthermore, heterologous expression of the FAMT genes yielded FAME, which was analyzed by gas chromatography. We found that FAMT transformants can be further metabolically optimized and applied for commercial production of biodiesel.

Characterization and Control of Nanoparticle Emission during 3D Printing.

This study aimed to evaluate particle emission characteristics and to evaluate several control methods used to reduce particle emissions during three-dimensional (3D) printing. Experiments for particle characterization were conducted to measure particle number concentrations, emission rates, morphology, and chemical compositions under manufacturer-recommended and consistent-temperature conditions with seven different thermoplastic materials in an exposure chamber. Eight different combinations of the different control methods were tested, including an enclosure, an extruder suction fan, an enclosure ventilation fan, and several types of filter media. We classified the thermoplastic materials as high emitter (>1011 #/min), medium emitters (109 #/min -1011 #/min), and low emitters (<109 #/min) based on nanoparticle emissions. The nanoparticle emission rate was at least 1 order of magnitude higher for all seven filaments at the higher consistent extruder temperature than at the lower manufacturer-recommended temperature. Among the eight control methods tested, the enclosure with a high-efficiency particulate air (HEPA) filter had the highest removal effectiveness (99.95%) of nanoparticles. Our recommendations for reducing particle emissions include applying a low temperature, using low-emitting materials, and instituting control measures like using an enclosure around the printer in conjunction with an appropriate filter (e.g., HEPA filter) during 3D printing.