Three-Dimensional Morphometry of the Canine Pelvis: Implications for Total Hip Replacement Surgery.

OBJECTIVES: Two-dimensional measurements of acetabular geometry are widely used for the assessment of acetabular component orientation following total hip replacement (THR). With the increasing availability of computed tomography scans, there is an opportunity to develop three-dimensional (3D) planning to improve surgical accuracy. The aim of this study was to validate a 3D workflow for measuring angles of lateral opening (ALO) and version, and to establish reference values for dogs. METHODS: Pelvic computed tomography scans were obtained from 27 skeletally mature dogs with no radiographic evidence of hip joint pathology. Patient-specific 3D models were built, and ALO and version angles were measured for both acetabula. The validity of the technique was determined by calculating intra-observer coefficient of variation (CV, %). Reference ranges were calculated and data from left and right hemipelves were compared using a paired t-test and symmetry index. RESULTS: Measurements of acetabular geometry were highly repeatable (intra-observer CV 3.5-5.2%, inter-observer CV 3.3-5.2%). Mean (± standard deviation) values for ALO and version angle were 42.9 degrees (± 4.0 degrees) and 27.2 degrees (± 5.3 degrees) respectively. Left-right measurements from the same dog were symmetrical (symmetry index 6.8 to 11.1%) and not significantly different. CONCLUSIONS: Mean values of acetabular alignment were broadly similar to clinical THR guidelines (ALO of 45 degrees, version angle of 15-25 degrees), but the wide variation in angle measurements highlights the potential need for patient-specific planning to reduce the risk of complications such as luxation.

Kinematics of a Novel Canine Cervical Fusion System.

OBJECTIVE: The aim of this study was to determine the biomechanical behaviour of a novel distraction-fusion system, consisting of an intervertebral distraction screw, pedicle locking screws and connecting rods, in the canine caudal cervical spine. STUDY DESIGN: Biomechanical study in cadaveric canine cervicothoracic (C3-T3) spines (n = 6). Cadaveric spines were harvested, stripped of musculature, mounted on a four-point bending jig, and tested using non-destructive four-point bending loads in extension (0-100 N), flexion (0-60 N) and lateral bending (0-40 N). Angular displacement was recorded from reflective optical trackers rigidly secured to C5, C6 and C7. Data for primary and coupled motions were collected from intact spines and following surgical stabilization (after ventral annulotomy and nucleotomy) with the new implant system. RESULTS: As compared with the intact spine, instrumentation significantly reduced motion at the operated level (C5-C6) with a concomitant non-significant increase at the adjacent level (C6-C7). CONCLUSION: The combination of a locking pedicle screw-rod system and intervertebral spacer provides an alternative solution for surgical distraction-stabilization in the canine caudal cervical spine and supports the feasibility of using this new implant system in the management of disc-associated cervical spondylomyelopathy in dogs. The increase in motion at C6-C7 may suggest the potential for adjacent level effects and clinical trials should be designed to address this.

Evaluating Stiffness of Fibreglass and Thermoplastic Splint Materials and Inter-fragmentary Motion in a Canine Tibial Fracture Model.

OBJECTIVES: Various materials are used to construct splints for mid-diaphyseal tibial fracture stabilization. The objective of this study was to compare construct stiffness and inter-fragmentary bone motion when fibreglass (FG) or thermoplastic (TP) splints are applied to either the lateral or cranial aspect of the tibia in a mid-diaphyseal fracture model. METHODS: A coaptation bandage was applied to eight cadaveric canine pelvic limbs, with a custom-formed splint made of either FG or TP material applied to either the lateral or cranial aspect of the osteotomized tibia. Four-point bending tests were performed to evaluate construct stiffness and inter-fragmentary motion in both frontal and sagittal planes. RESULTS: For a given material, FG or TP, construct stiffness was not affected by splint location. Construct stiffness was significantly greater with cranial FG splints than with cranial TP splints (p < 0.05), but this difference was not significant when comparing splints applied laterally (p = 0.15). Inter-fragmentary motions in the sagittal and frontal planes were similar across splint types for cranial splints, but for lateral splints there was a 64% reduction in frontal plane motion when FG was used as the splint material (p = 0.03). CLINICAL SIGNIFICANCE: FG produces a stiffer construct, but the difference is not reflected in a reduction in inter-fragmentary motion. For lateral splints, FG splints are associated with reduced inter-fragmentary motion as compared with TP and may therefore have slight superiority for this application.

Kinematic behavior of a novel pedicle screw-rod fixation system for the canine lumbosacral joint.

OBJECTIVE: To determine the biomechanical behavior of a novel distraction-stabilization system, consisting of an intervertebral distraction bolt, polyaxial screws, and connecting rods, in the canine lumbosacral spine. STUDY DESIGN: Biomechanical study. SAMPLE POPULATION: Cadaveric canine lumbosacral spines (L4-Cd3) (N = 8). METHODS: Cadaveric lumbosacral spines were harvested, stripped of musculature, mounted on a 4-point bending jig, and tested in extension, flexion, and lateral bending using nondestructive compressive axial loads (0-150 N). Angular displacement was recorded from reflective optical trackers rigidly secured to L6, L7, and S1. Data for primary and coupled motion were collected from intact spines, after destabilization at L7-S1, and following surgical stabilization with the new implant system. RESULTS: As compared with the intact spine, laminectomy resulted in a modest increase in angular displacement at L6-L7 and a marked increase at L7-S1. Instrumentation significantly reduced motion at the operated level (L7-S1) with a concomitant increase at the adjacent level (L6-L7). CONCLUSION: The combination of a polyaxial pedicle screw-rod system and intervertebral spacer provides a versatile solution of surgical stabilization of the lumbosacral joint following surgical decompression in the canine lumbosacral spine. The increase in motion at L6-L7 may suggest the potential for adjacent level effects and clinical trials should be designed to address this question. CLINICAL RELEVANCE: These results support the feasibility of using this new implant system for the management of degenerative lumbosacral disease in dogs. The increase in motion at L6-L7 may suggest the potential for adjacent level effects and clinical trials should be designed to address this question.

EFFECTS OF IMAGE PLANE, PATIENT POSITIONING, AND FORAMINAL ZONE ON MAGNETIC RESONANCE IMAGING MEASUREMENTS OF CANINE LUMBOSACRAL INTERVERTEBRAL FORAMINA.

Degenerative lumbosacral stenosis has been suspected to have a dynamic component, especially regarding encroachment of the L7 nerve roots exiting the lumbosacral foramina. Angled cross-sectional imaging of the neuroforamina has been found improve the accuracy of the diagnosis of stenosis in humans. In this anatomic study, foraminal apertures were evaluated by MRI at the entry, middle, and exit zones of the nerve roots in 30 dogs that were clinically affected by lumbosacral disease. Standard vs. oblique planar orientation and neutral vs. hyperextended positioning of the lumbosacral area were compared by measuring the median values for entry, middle, and exit zones. The neuroforaminal area acquired using oblique plane acquisition was significantly smaller than standard parasagittal measurements. Furthermore, standard parasagittal neuroforaminal dimensions in the hyperextended position were significantly smaller than standard parasagittal measurements in the neutral position. This statistical difference was even more pronounced for neuroforaminal dimension evaluated in the oblique plane and hyperextended position. Positioning of the dog during imaging has a significant effect on neuroforaminal dimension, corroborating the notion that spinal position may influence neural claudication in clinically affected patients. Reductions in neuroforaminal dimension are more evident on oblique planar image acquisition, suggesting that this approach may be more useful than parasagittal imaging as a tool for identifying subtle changes in L7 neuroforaminal dimensions in cases of canine lumbosacral stenosis.