RESUMEN
Internationally, respirable crystalline silica (RCS) occupational exposure limits (OELs) are being reassessed and, in some jurisdictions, lowered, putting pressure on the capabilities of the analytical techniques used to achieve robust analyses and reliable detection limits. In preparation of a lower OEL, options for lowering the limit of detection (LoD) for RCS analysis have been assessed. Using a Direct-on-Filter X-Ray Diffraction (XRD) analysis under reduced scan speeds in combination with low-noise RCS sampling filters, an LoD of 0.25 µg/filter and a limit of quantification (LoQ) of 0.82 µg/filter can be achieved. Both limits would translate in an LoD of 0.24 µg/m3 and LoQ of 0.78 µg/m3 when sampling respirable dust for 8 h at 2.2 L/min, providing a technical solution to monitor exposures at the proposed OEL of 0.025 mg/m3 (25 µg /m3) and below, with general sampling conditions as typically applied in Australia. This is the first report showing that the OEL of 0.025 mg/m3 (25 µg /m3) is measurable by one of the standardized, direct-on-filter XRD methods.
RESUMEN
Silicosis, caused by silica exposure, is the most widespread and deadliest occupational disease. However, effective treatments are lacking. Therefore, it is crucial to elucidate the mechanisms and targets involved in the development of silicosis. We investigated the basic processes of silicosis development and onset at different exposure durations (2 or 4 weeks) using various techniques such as histopathology, immunohistochemistry, Enzyme linked immunosorbent assay(ELISA),16â¯S rRNA, and untargeted metabolomics.These results indicate that exposure to silica leads to progressive damage to lung tissue with significant deterioration observed over time. Time-dependent cytokines such as the IL-4, IL-13, and IL-6 are detected in lung lavage fluid, the model group consistently exhibited elevated levels of these cytokines, indicating a persistent and worsening inflammatory response in the lungs. Meanwhile, HE and Masson results show that 4-week exposure to silica causes more obvious lung injury and pulmonary fibrosis. Besides, the model group consistently exhibited a distinct lung bacterial population, known as the Lachnospiraceae_NK4A136_group, regardless of exposure duration. However, with increasing exposure duration, specific temporal changes were observed in lung bacterial populations, including Haliangium, Allobaculum, and Sandaracinus (at 4 weeks; p < 0.05). Furthermore, our study revealed a strong correlation between the mechanism of silica-induced lung injury and three factors: oxidative stress, impaired lipid metabolism, and imbalanced amino acid metabolism. We observed a close correlation between cytokine levels, changes in lung microbiota, and metabolic disturbances during various exposure periods. These findings propose that a possible mechanism of silica-induced lung injury involves the interplay of cytokines, lung microbiota, and metabolites.
Asunto(s)
Citocinas , Lesión Pulmonar , Pulmón , Microbiota , Dióxido de Silicio , Dióxido de Silicio/toxicidad , Animales , Pulmón/microbiología , Pulmón/efectos de los fármacos , Pulmón/patología , Microbiota/efectos de los fármacos , Lesión Pulmonar/inducido químicamente , Lesión Pulmonar/microbiología , Lesión Pulmonar/patología , Citocinas/metabolismo , Masculino , Silicosis/metabolismo , Líquido del Lavado Bronquioalveolar/químicaRESUMEN
Personal air monitoring using a TSI SidePak AM520 personal aerosol monitor was performed on a northern Colorado construction site during five tasks from the OSHA Table 1: Specified Exposure Control Methods When Working With Materials Containing Crystalline Silica to estimate silica dust concentrations in real time. Photometric measurements were modified using a gravimetric correction factor and a % respirable crystalline silica adjustment. Each task was sampled once; sample time ranged from 14 min to 40 min, with a mean sample time of 27 min. The mean silica dust concentration estimates (µg/m3) (standard deviation [SD]) for the five tasks computed from the TSI SidePak AM520 respirable dust measurements were core drilling 12 µg/m3 [2.46], grinding 918 µg/m3 [1134.08], cutting with a walk-behind saw 36 µg/m3 [79.67], jackhammering 27 µg/m3 [23.24], and dowel drilling 66 µg/m3 [77.65]. Silica exposure estimates from real-time monitoring can be used to identify exposures that may be related to inadequate controls or worker behaviors that contribute to peak exposures. Respirable crystalline silica exposure estimates presented here are likely not generalizable to other construction sites or tasks.
Asunto(s)
Contaminantes Ocupacionales del Aire , Polvo , Monitoreo del Ambiente , Exposición por Inhalación , Exposición Profesional , Dióxido de Silicio , Exposición Profesional/análisis , Dióxido de Silicio/análisis , Contaminantes Ocupacionales del Aire/análisis , Exposición por Inhalación/análisis , Humanos , Polvo/análisis , Monitoreo del Ambiente/métodos , Industria de la Construcción , Colorado , Materiales de Construcción/análisis , Aerosoles/análisis , Factores de TiempoRESUMEN
Early detection of pulmonary responses to silica aerosol exposure, such as lung inflammation as well as early identification of silicosis initiation, is of great importance in disease prevention of workers. In this study, to early screen the health condition of the workers who are exposed to respirable silica dusts, an immunoassay lab on a chip (LOC) was designed, developed and fully characterized for analyzing Clara cell protein 16 (CC16) in serum which has been considered as one of the potential biomarkers of lung inflammation or lung damage due to the respirable silica dusts. Sandwich immunoassay of CC16 was performed on the LOC developed with a custom-designed portable analyzer using artificial serums spiked with CC16 protein first and then human serums obtained from the coal mine workers exposed to the respirable silica-containing dusts. The dynamic range of CC16 assay performed on the LOC was in a range of 0.625-20 ng/mL, and the achieved limit of detection (LOD) was around 0.35 ng/mL. The assay results of CC16 achieved from both the developed LOC and the conventional 96 well plate showed a reasonable corelation. The correlation between the conventional reader and the developed portable analyzer was found to be reasonable, resulting in R2 ~ 0.93. This study shows that the LOC developed for the early detection of CC16 can be potentially applied for the development of a field-deployable point-of-care testing (POCT) for the early monitoring of the field workers who are exposed to silica aerosol.