Production of Polyhydroxybutyrate by halotolerant Halomonas cerina YK44 using sugarcane molasses and soybean flour in tap water.

As environmental pollution intensifies, the interest in bioplastics is growing. The bioplastic polyhydroxyalkanoates (PHAs), which are produced and degraded by microorganisms, have received considerable attention. However, the production cost of PHA is still high, and several ways to increase economy of PHA production have been studied. Therefore, as one way of solution, Halomonas species were screened and evaluated with cheap substrates such as molasses and soybean flour. Among tested strains, Halomonas cerina YK44 was selected and used for polyhydroxybutyrate (PHB) production with molasses and soybean flour together, whose combination was not evaluated well before, in tap water. The medium composition optimization showed maximum PHB production at 4 % sugarcane molasses, 2 % NaCl, 0.05 % soybean flour, and pH 8 in tap water (9.2 g/L DCW, 7.3 g/L PHB, and 79.7 % PHB contents). However, cell growth of halotolerant H. cerina YK44 was disturbed by 0.2 % furfural, which existed in biomass based sugars as inhibitors. Physical and thermal analyses revealed that PHB film started from sugarcane molasses and soybean flour was no different from that initiated from simple sugars (Tm was 175.8 °C and 176.2 °C, PDI was 1.29, and 1.31, respectively).

Characterization of gluten-free cupcakes without sucrose based on defatted soybean flour and monk fruit.

This study aimed to produce and characterize a novel gluten-free cupcake for celiac and diabetes people. For this purpose, wheat flour and sugar in the cupcake formulation were fully replaced with soy flour and monk fruit. Also, samples containing wheat flour with sugar and monk fruit were prepared for comparison. The gluten-free cupcake without sucrose had a less specific volume and porosity index. To improve these properties, Cydonia oblonga (Cydonia Vulgaris) and Plantago ovata (Plantago genus) were used individually and in combination at concentrations of 1 and 2%. The cake containing no gum was made as a control as well. It was observed that addition of gums had positive effects on the specific volume, porosity index, and weight loss of cakes, but their incorporation increased their hardness. Based on the results, the fabrication of a novel and successful gluten-free cupcake replaced with soy flour, monk fruit, and gum is possible.

Safety Assessment of Soy-Derived Ingredients as Used in Cosmetics.

The Expert Panel for Cosmetic Ingredient Safety (Panel) reviewed the safety of 28 soy-derived ingredients as used in cosmetic products. These ingredients are reported to primarily function as antioxidants, skin protectants, skin-conditioning agents, and hair-conditioning agents. The Panel considered the available data relating to the safety of these ingredients in cosmetic formulations, and concluded that 24 of the 28 soy-derived ingredients are safe in cosmetics in the present practices of use and concentration described in this safety assessment. The Panel also concluded that the available data are insufficient to make a determination that Glycine Max (Soybean) Callus Culture, Glycine Max (Soybean) Callus Culture Extract, Glycine Max (Soybean) Callus Extract, and Glycine Max (Soybean) Phytoplacenta Conditioned Media are safe under the intended conditions of use in cosmetic formulations.

Partial substitution of wheat flour with soybean and gluten powder: impact on flavor characteristics of Pixian Douban-Meju and its quality.

BACKGROUND: In this study, different proportions of soybean flour and gluten flour were used as partial replacements for wheat flour for the fermentation of Pixian Douban-Meju (PXDB). The aim was to study the effects of soybean flour/gluten flour on the quality improvement of PXDB. RESULTS: In comparison with the control group (CT) (0% substitution of wheat flour), substitution of wheat flower with 12.5% soybean flour (the H2 group), 7.5% gluten flour (G2), and 10% gluten flour (G3) improved the amino acid nitrogen content by 3.8%, 5.6%, and 9.4% respectively. The mixtures of wheat flour and gluten flour (G2 or G3) increased the organic acid and free amino acid content. The results of two-dimensional gas chromatography mass spectrometry (GC × GC-MS) showed that the amount of key aroma substances increased about sixfold in comparison with the CT group (194.61 g.kg-1 ), achieving 1283.67, 1113.883, and 1160.19 g.kg-1 in the H2, G2, and G3 groups, respectively. There were also more aldehydes and pyrazines in all the substitution groups. Quantitative descriptive analysis indicated that the G3 sample presented the best organoleptic quality with a reddish-brown color and a more mellow aroma than the control sample. CONCLUSION: In conclusion, the fermentation of G3 resulted in higher quality PXDB-meju, showing that partial substitution of wheat flour with gluten improved the quality of PXDB. © 2023 Society of Chemical Industry.

Dough Rheological Behavior and Bread Quality as Affected by Addition of Soybean Flour in a Germinated Form.

This study analyzes the possibility of using soybeans as an addition to the main ingredients used to make bread, with the aim of improving its quality characteristics. To maximize the nutritional profile of soybeans they were subjected to the germination and lyophilization process before being used in bread making. The addition levels of 5%, 10%, 15%, and 20% germinated soybean flour (GSF) on dough rheology and bread quality were used. From the rheology point of view, the GSF addition had the effect of decreasing the values of the creep and recovery parameters: JCo, JCm, µCo, Jmax, JRo, JRm, and Jr. At the same time, the rheological parameters λC and λR increased. The GSF addition did not affect dough homogeneity as may be seen from EFLM analysis. Regarding the quality of the bread, it may be concluded that a maximum of 15% GSF addition in wheat flour had a desirable effect on loaf volume, porosity, elasticity, and sensory properties of the bread. The bread samples with GSF additions showed a higher brightness and a less pronounced red and yellow tint. When the percentage of GSF in wheat flour increased, the value of the firmness parameter increased and the value of the gumminess, cohesiveness, and resilience parameters decreased. The addition of GSF had a desirable influence on the crumb structure of the bread samples. Thus, taking into account the results of the determinations outlined above, it can be stated that GSF addition in wheat flour leads to bread samples with good quality characteristics.

Influence of calcium sulfate incorporated with gluconolactone coagulant on the quality of whole soybean flour tofu.

This work proposes a novel method for whole soybean flour tofu preparation by combining calcium sulfate (CS) and glucose-delta-lactone (GDL) coagulation. Importantly, the characteristics of the synthesized gel and the quality were studied. MRI and SEM results showed that the whole soybean flour tofu possessed satisfactory water holding capacity and water content at a CS to GDL ratio of 3:2, significantly improving the cross-linking network gel in tofu and accounting for its similar color to soybeans. Furthermore, GC-IMS analysis showed that the whole soybean flour tofu prepared at a 3:2 ratio had more flavor components (51 types) than commercially available ones (CS or GDL tofu) and exhibited satisfactory results during consumer sensory evaluation. Overall, this method is effective and applicable for the industrial preparation of whole soybean flour tofu.

Effect of Heat-Moisture Treatment on the Physicochemical Properties and Starch Digestibility of Mix Powder (Wheat Flour-Black Soybean Flour) and Corresponding Cookies.

In order to improve the nutritional value and reduce starch the digestibility of black soybean cookies, superfine black soybean flour was modified by heat-moisture treatment (HMT). The physicochemical properties, structure analysis of the flour samples and corresponding dough, and nutritional, physical, and textural properties of the cookies were investigated. After HMT, the water and lactic acid retention capacity and the oil binding capacity of mix powder dramatically increased, being almost twice the value of the untreated sample. HMT increased gelatinization temperature by about 10 °C but decreased gelatinization enthalpy. HMT had no apparent effect on the morphology and size of granules, but some cracks and pores appeared on the HMT-mix powder granules and corresponding dough. Fourier transform infrared spectroscopy analysis showed that the ordered structure of dough was unaffected during HMT. After HMT, the thickness, density, and baking loss of the cookies increased, and the spread ratio decreased. HMT dramatically increased the chemical score of cookies from 12.35% in mix powder cookies to 19.64% in HMT-mix powder cookies. HMT decreased the rapidly digestible starch content, while the slowly digestible starch increased from 45.97% in mix powder cookies to 49.31% in HMT-mix powder cookies, and RS increased from 21.64% to 26.87%. Overall, HMT did not have a negative effect on the processing properties and microstructure and secondary structure of the dough, or the physical properties and quality of the cookies, but significantly improved the nutritional properties and decreased the starch digestibility of the cookies.

Preservation of Aloe vera and soybean flour fortified Granny Smith apple through optimised quartz-halogen radiated vacuum drying: kinetics and quality evaluation.

BACKGROUND: Granny Smith (GS) apple has low protein content and poor antimicrobial properties; hence it has been blended with Aloe vera (AV; high ascorbic acid, antimicrobial and antioxidant properties) and soybean flour (SF; rich in phenols, flavonoids, ascorbic acid, total antioxidant and protein) in different proportions to obtain fortified GS, i.e. GSAVSF. Moreover, GS being a perishable fruit, its moisture content should be reduced to enhance shelf life. Accordingly, this GSAVSF was osmotically pre-dehydrated and finally dried through energy-efficient quartz-halogen radiation (QHR) assisted vacuum-drying (QHRVD) to produce dried GSAVSF i.e. (DGSAVSF) under optimized conditions. RESULTS: The optimally dehydrated DGSAVSF product resulted in minimum moisture (4.85% w/w) and maximum protein (6.24 g kg-1 ) content. The application of osmotic dehydration and QHRVD afforded acceptable colour of DGSAVSF compared to GSAVSF (ΔEI * = 10.07 ± 0.21). A parametric drying model was formulated that corroborated well with Fick's equation. QHRVD rendered high moisture diffusivity (1.49 × 10-8 m2 s-1 ) and low activation energy (27.64 kJ mol-1  K-1 ). Appreciable quality improvements with respect to fresh GS concerning ascorbic acid (176.05%), total phenolic (579.07%), total flavonoid (333.33%) contents and 2,2'-diphenyl-1-picrylhydrazyl radical scavenging activity (446.71%) could be achieved. The product demonstrated satisfactory shelf life (1 × 104 CFU g-1 : aerobic mesophilic; 1 × 104 CFU g-1 : mould and yeast) and high rehydration ratio (4.25 ± 0.1). CONCLUSION: The enrichment of GS with AV and SF along with optimal drying protocols could provide a quality fortified DGSAVSF through an energy-proficient sustainable process. The highly nutritious product with suitable colour, microbial stability and rehydration ratio also satisfied a 9-point hedonic scale, thus confirming consumer acceptability. © 2020 Society of Chemical Industry.

Calcium Bioavailability of Tempe and Boiled Soybean Flours and Its Effect on Osfemurs in Experimental Rats.

Tempe is a nutritious food that contains both macronutrients and micronutrients in an adequate amount. Tempe contains a high amount of calcium, so it is an affordable food product that can be purchased by most people in Indonesia. Calcium deficiency can lead to several diseases and disorders such as osteoporosis, hypertension, heart disease, and nerve damage. This study was aimed to evaluate: (1) the calcium bioavailability (absorption and retention) of tempe and boiled soybean flours compared to casein (control), (2) the effect of tempe and boiled soybean flours on blood calcium and osfemurs in rats. This study was conducted using rats as a model. The rats were divided into four treatment groups based on the sources and protein concentrations in the diet; tempe flour 10% protein, tempe flour 20% protein, boiled soybean flour 10% protein, and casein 10% protein as a control. This experiment was conducted for over than 90 d. The results showed that the sources of protein (casein, tempe flour, and boiled soybean flour) and protein level in the diet (10% and 20%) had no significantl effect (p>0.05) to the calcium absorption, calcium retention, calcium content in serum, calcium content in osfemurs, and total calcium in osfemurs. Tempe flour and boiled soybean flour can be consumed as a calcium source to substitute the consumption of calcium from dairy products.

Structural and Techno-Functional Properties of BovineCollagen and Its Application in Hamburgers.

The objective of this work is to characterize two types of bovine collagen (fibre and powder), evaluating its application in mixed hamburger formulations, as well as the quality characteristics of the products. The collagen fibre had a fibrillar structure, molecular mass 100 kDa and greater gel strength (146 315 Pa) and protein content (97.81%) than the powdered collagen, which had molecular mass from 50 to 100 kDa, greater hydroxyproline content, and a morphological structure with spherical microparticles more amorphous than the collagen fibre. In this study we found that the addition of 1.5% powdered collagen and 2.5% flocculated soybean flour and/or 0.75% powdered collagen and 3.5% flocculated soybean flour did not deteriorate the technological properties or the sensory attributes of hamburgers. The use of collagen is a promising alternative, since it has functional properties, improves the texture characteristics of a product, and is of low cost.