Amphotericin-B and vancomycin-loaded chitosan nanofiber for antifungal and antibacterial application

In the present study, a mucoadhesive non-woven fiber mat (d= 116 nm) was fabricated by the electrospinning method using chitosan (80% Wt), polyethylene oxide (10% Wt), cysteine (4% Wt) and drugs (6% Wt), respectively. In addition, a comparative study was conducted to define effect of drugs and mucoadhesive agent on the nanofiber formation. FTIR, SEM, DSC and DMA were used to investigate the chemical and physical properties of the nanofibers. In vitro release of the drugs was assessed over a 48-hour period by the total immersion method. Release data were fitted to kinetic models, including the zero-order, first-order, Higuchi matrix, and Hixson-Crowell. Zone inhibition investigations were used to describe the inhibition content of vancomycin and amphotericin B loaded in the mats. The SEM images displayed a slight decrease in the fiber diameter with adding drugs and mucoadhesive agents. FTIR spectra confirmed that any undesirable reaction between VAN-AMB and CS-PEO was not observed. DSC test recognized the uniform distribution of drugs in the polymeric bead of the fiber without any crystal form. The elasticity modulus of the nanofiber was in an acceptable range for oral mucosa (approximately 5 Mpa). The results indicated that biodegradable mucoadhesive nanofibrous membranes released high concentrations of VAN in the first 24 hours, but the AMB release was affected in more controlled phenomena

Inhibition of Amphiphilic N-Alkyl-O-carboxymethyl Chitosan Derivatives on Alternaria macrospora.

Cotton leaf spot (Alternaria macrospora) is a widespread disease that occurs in the main cotton-producing area of China. In managing this disease, a novel chitosan-based biopesticide, an amphiphilic N-alkyl-O-carboxymethyl chitosan derivative, was prepared. The product was selected from variations of chitosan with different molecular structures, which were obtained via a two-step reaction. First, carboxymethyl chitosans with varying molecular sizes were obtained by etherification with chloroacetic acid; then the carboxymethyl chitosan was alkylated with C4-C12 fatty aldehyde through a Schiff-base reaction. This procedure resulted in derivatives of amphiphilic N-alkyl-O-carboxymethyl chitosan, which showed strong antifungal activities against A. macrospora, and the efficacy was determined by its molecular structure.

Investigation of the parameters affecting the release of flurbiprofen from chitosan microspheres

ABSTRACT Flurbiprofen (FLB), a NSAID, widely used for preventing pain generally for arthritis or dental problems. In this study, FLB loaded chitosan microspheres were prepared by ionotropic gelation method. In this method, microspheres were formed by dropping chitosan solutions containing FLB into sodium alginate solutions including sodium tripolyphosphate (TPP). A variety of formulation parameters like drug:polymer ratio, drug concentration, polymer's molecular weight, polymer concentration, pH and the concentration of TPP solutions, drying method and stirring time were analyzed. The dissolution studies were performed in a shaking water bath in pH 7.4 phosphate buffer saline (PBS) at 37 °C. Laser diffractometer was used for particle size analysis, and scanning electron microscope (SEM) was used for morphological properties. Drug loading and loading efficiency were calculated by using UV spectrophotometer. The particles obtained were spherical with 0.7-1.3 mm size range, and the loading efficiency was approximately 21-79%. The dissolution studies conducted revealed that drug:polimer ratio and the polymer type and concentration affected the drug release from microspheres. It was observed that increasing the polymer concentration, polymer's molecular weight and TPP concentration decreased the FLB release from microspheres, which was according to Higuchi kinetics.