New biopolymer from biomass for conditioning and dehydration of sewage sludge: application on the sludge of Bouira WWTP.

Sewage treatment plants in Algeria produce huge quantities of sludge expressed in tons annually. This sludge produced is unfortunately contaminated because of the use of synthetic polyelectrolytes. Recently several kinds of research have been carried out on natural flocculants for sludge conditioning, because of several advantages they present such as their renewable source and their non-toxicity. This work aims to evaluate the potential use of protonated pectin extracted from orange waste of N'GAOUS juice factory as an eco-friendly flocculant in the chemical conditioning of sludge. Protonated pectin effectiveness was compared with synthetic cationic anionic and ionic polyelectrolytes (SUPERFLOC 8396, AF400, NF102). In this context, raw sludge samples from Bouira WWTP were tested. Specific resistance to filtration (SRF), cakes dry solid content were analyzed to determine filterability, dewatering capacity of conditioned sludge, and the optimum dose of each conditioner. So that our goal was to obtain greater dryness, which is the case with the addition of protonated pectin and even the addition of Superfloc, which allowed us to obtain dryness of 33.01% and 29.19%, respectively, for the same doses that gave the lowest SRF. Based on the results found and the analysis of the specific resistance to filtration (SRF) and the dryness, and compared with the values observed for the dewatered sludge by the method used in the Bouira WWTP. Band filters (18-22%) and raw sludge (4.8-5.7%).

A novel use of Moringa oleifera seed powder in enhancing the primary treatment of paper mill effluent.

In this study, Moringa oleifera (M. oleifera) performance as an eco-friendly coagulant in the enhanced primary treatment of paper mill effluent was investigated. Its performance in terms of turbidity removal and COD abatement was examined. Local M. oleifera seed powder from ADRAR-city, South of Algeria, was used. Conventional jar tests were conducted for enhancing the primary treatment of paper mill effluent from paper factory. For this reason, comparative coagulation tests were performed using aluminum sulfate (alum). Indeed, in terms of turbidity abatement, 96.02% and 97.1% were obtained for Moringa and alum, respectively. However, in the case of COD abatement, the abatement rate of M. oleifera seeds was slightly higher than that of alum, 97.28% and 92.67%, respectively. Because M. oleifera is a natural resource that is locally available, an eco-friendly coagulant, non-toxic, and biodegradable and does not affect the pH of water; thus, its use allows to avoid numerous disadvantages of conventional coagulants like alum.

Antimicrobial activity of aqueous extracts from four plants on bacterial isolates from periodontitis patients.

Four aqueous extracts of different plant organs are the following: Artemisia herba-alba, Opuntia ficus-indica, Camellia sinensis and Phlomis crinita were evaluated against two bacterial strains: Porphyromonas gingivalis and Prevotella intermedia, which are implicated in periodontal diseases. By using a disc method, these plant extracts demonstrated powerful bacterial activity against these Gram-negative strains. The minimum inhibitory concentration values of the four plant extracts varied between 0.03 and 590.82 mg/ml for the microbes. Another assay using commercial antibiotics and antibacterials as positive controls was also conducted. Values obtained after statistical analysis of inhibition diameters of all plant extracts demonstrated that for P. gingivalis, the aqueous extracts of A. herba-alba and O. ficus-indica were most effective, followed by those of C. sinensis and P. crinita. For P. intermedia, aqueous extracts of O. ficus-indica and C. sinensis appeared to be more efficient with significantly different (P > 0.05) inhibition diameters, followed by those of O. ficus-indica and P. crinita. In summary, the statistical results reveal that these plant extracts exert stronger antibacterial activity on P. intermedia germ as compared to P. gingivalis.

Purification, characterization, and molecular cloning of an extracellular chitinase from Bacillus licheniformis stain LHH100 isolated from wastewater samples in Algeria.

An extracellular chitinase (ChiA-65) was produced and purified from a newly isolated Bacillus licheniformis LHH100. Pure protein was obtained after heat treatment and ammonium sulphate precipitation followed by Sephacryl S-200 chromatography. Based on matrix assisted laser desorption ionization-time of flight mass spectrometry (MALDI-TOF/MS) analysis, the purified enzyme is a monomer with a molecular mass of 65,195.13 Da. The sequence of the 27 N-terminal residues of the mature ChiA-65 showed high homology with family-18 chitinases. Optimal activity was achieved at pH 4 and 75 °C. Among the inhibitors and metals tested, p-chloromercuribenzoic acid, N-ethylmaleimide, Hg(2+), and Hg(+) completely inhibited enzyme activity. Chitinase activity was high on colloidal chitin, glycol chitin, glycol chitosane, chitotriose, and chitooligosaccharide. Chitinase activity towards synthetic substrates in the order of p-NP-(GlcNAc)n (n = 2-4) was p-NP-(GlcNAc)2 > p-NP-(GlcNAc)4 > p-NP-(GlcNAc)3. Our results suggest that ChiA-65 preferentially hydrolyzed the second glycosidic link from the non-reducing end of (GlcNAc)n. ChiA-65 obeyed Michaelis-Menten kinetics, the Km and kcat values being 0.385 mg, colloidal chitin/ml and 5000 s(-1), respectively. The chiA-65 gene encoding ChiA-65 was cloned in Escherichia coli and its sequence was determined. Above all, ChiA-65 exhibited remarkable biochemical properties suggesting that this enzyme is suitable for bioconversion of chitin waste.