RESUMO
Gallium-68-labeled FAPI-46 has recently been proposed as a novel positron emission tomography imaging probe to diagnose and monitor a wide variety of cancers. Promising results from several ongoing clinical trials have led to a soaring demand for this radiotracer. Typical [68Ga]Ga-FAPI-46 labeling protocols do not cope with multiple generator elutions, leaving radiopharmacies unable to scale-up the production and meet the demand. Here, we propose a robust and efficient automated radiosynthesis of [68Ga]Ga-FAPI-46 on the Trasis miniAllinOne synthesizer, featuring a prepurification step which allows multiple generator elutions and ensures compatibility with a wide range of gallium-68 generators. Our approach was to optimize the prepurification step by first testing five different cationic cartridge chemistries. Only the strong cationic exchange (SCX) cartridges tested had sufficient affinities for quantitative trapping of >99.9%, while the weak cationics did not exceed 50%. Packaging, rinsing, or flowing of the selected SCX cartridges was not noticeable, but improvements in fluidics managed to save time. Based on our previous development experience of [68Ga]Ga-FAPI-46, radiolabeling optimization was also carried out at different temperatures during 10 min. At temperatures above 100°C, radiochemical yield (RCY) > 80% was achieved without significantly increasing the chemical impurities (<5.5 µg mL-1). The optimized sequence was reproducibly conducted with three different brands of widely used generators (RCY >88%). A comparison with radiosyntheses carried out without prepurification steps was also conclusive in terms of RCY, radiochemical yield, and chemical purity. Finally, high-activity tests using elutions from three generators were also successful for these parameters. [68Ga]Ga-FAPI-46 was consistently obtained in good radiochemical yields (>89%, n = 3), and the final product quality was compliant with internal specifications based on European Pharmacopoeia. This process is suitable for GMP production and allows scaling-up of routine productions, higher throughput, and, ultimately, better patient care.
RESUMO
OBJECTIVES: In France, dispensation is defined by the validation of a prescription associated with a pharmaceutical analysis, preparation of medication and provision of information necessary for proper use. There are very few data available in the literature that describe prescription analysis modality in radiopharmacy. The aim was to secure a place for paediatric prescription analysis in radiopharmacy by designing a flow chart validated by experts. METHODS: Experts from different disciplines and health setups (ie, public, private) were selected to represent the various paediatric patient care processes. A review of the literature on pharmaceutical analysis and paediatric prescription in radiopharmacy was conducted. A Delphi approach comprising two rounds (Google Form survey) was used to validate the flow chart. Answers were graded according to a nine-point Likert scale for agreement. Open-ended questions allowed experts to comment on the propositions. A consensus between experts was reached if more than 70% of the experts agreed on an item and fewer than 30% disagreed. RESULTS: Sixty-five experts were solicited: two oncopaediatricians, three nuclear medicine physicians, 46 radiopharmacists, three residents in radiopharmacy, one hospital pharmacist, five medical physicists, one pharmacy technician, two X-ray technicians and two patients who are pharmacists. The first round survey included a draft of the flow chart: 31 experts answered (48%). All professional disciplines were represented except pharmacy technician. The second round survey was sent with a new flow chart that had been improved by the experts' comments. After 3 weeks, 18 answers were obtained (28%). After the first round, consensus was obtained for each item. Experts gave a total of 97 comments. The second flow chart had three steps: regulatory aspects, patient data, and radiopharmaceutical data, and it was accompanied by descriptive text explaining the field of application. CONCLUSION: The resulting flow chart will secure the pharmaceutical analysis step for this special patient population.
Assuntos
Prescrições , Compostos Radiofarmacêuticos , Criança , Humanos , Prescrições/estatística & dados numéricos , Compostos Radiofarmacêuticos/uso terapêuticoRESUMO
OBJECTIVES: The risk of chronic exposure to antineoplastic agents in hospitals, mainly by skin contact with contaminated surfaces, is well established. The aim of this study was to assess indirectly the risk of occupational exposure to antineoplastics drugs at two hospitals by using an environmental monitoring, and to suggest ways of improving the exposure to healthcare workers. METHODS: An observational study of care practices on both sites was carried out. A wipe sampling campaign was then designed to study environmental contamination throughout the chemotherapy process: receipt, storage, compounding, transport, administration, and elimination areas. Samples were analyzed by a validated LC-MS/MS method allowing trace quantification of cyclophosphamide. A guidance 'safe value' of 0.10 ng/cm2 was considered. RESULTS: A total of 293 samples were analyzed, of which 58% were found to be positive. In the compounding units, the drug vials were contaminated before [range = (non-quantifiable [NQ]-0.71) ng/cm2] and after cleaning procedure [(NQ-0.62) ng/cm2], particularly when the flip-off lid was removed during cleaning. The contamination found on manual preparations was operator-dependent: [non-detectable (ND)-3.51] ng/cm2 on infusion bag surfaces; (780.61-24 698.98) ng/cm2 on medication ports. In the case of automated preparations, the average contamination was higher on infusion bag surfaces [(2.43-36.86) ng/cm2] and lower on medication ports [(0.43-7.65) ng/cm2] than manual preparations. Contamination of the analytical control area was also highlighted. In the daily care unit, the contamination was located near the infusion area (armchairs, infusion stands, floor, and patient toilets), and varied somewhat between the two sites, especially on the floor with (0.46-27.32) compared to (ND-0.18) ng/cm2. We did not detect contamination on the transport boxes, on the door handles or in the disposal areas. CONCLUSIONS: The variability of contamination observed between the two sites can be explained in part by the difference in routine practices, especially training of the staff, and cleaning procedures. Findings were communicated to healthcare workers, and news interventions were implemented based on wipe sampling results. This study demonstrated a method for routine environmental monitoring and worker education as a strategy to reduce occupational exposure.
Assuntos
Antineoplásicos , Neoplasias , Exposição Ocupacional , Humanos , Exposição Ocupacional/análise , Cromatografia Líquida , Espectrometria de Massas em Tandem , Ciclofosfamida/análise , Antineoplásicos/análise , Monitoramento Ambiental/métodosRESUMO
Radiolabelling with short half-lives radionuclides (e.g., fluorine-18 and carbon-11) must be as efficient and as fast as possible. Nucleophilic radiofluorinations and radiomethylations are conducted in polar aprotic solvents, such as dimethylsulfoxyde (DMSO), N,N-dimethylformamide (DMF) and N,N-dimethylacetamide (DMA), at high temperature. Those solvents are classified as toxic according to the ICH guidelines and must be evaluated in drug such as radiopharmaceuticals. Headspace gas chromatography is the standard method for the quantification of residual solvents but is not optimized for a rapid quantification of low vapor pressure solvents such as DMSO, DMF and DMA in radiopharmaceuticals. Direct injection gas chromatography is an interesting option without incubation step but the analysis run-time remains beyond 10 min long. In consequence, we developed a very simple ultra-high performance liquid chromatography method coupled with UV detection. Following the EMA requirements, we successfully validated a 3-min run-time analysis for quantification of three solvents in short half-lives radiopharmaceuticals. We currently use this method for the quality control of radiopharmaceuticals produced in our PET center.
Assuntos
DimetilformamidaRESUMO
The radiochemical purity (RCP) determination of radiopharmaceuticals is routinely done with radio-thin layer chromatography (r-TLC). These methods are usually transposed and adjusted from the summary product characteristics without any analytical validation. The r-TLC method is simple but manually-performed steps could lead to RCP misinterpretation. To increase the sensitivity, radio ultra-high performance liquid chromatography (r-UHPLC) can be used. In this study, an r-UHPLC method had been validated and compared to the r-TLC method. Hydrolyzed-reduced technetium had also been studied.
Assuntos
Cromatografia Líquida de Alta Pressão/métodos , Controle de Qualidade , Compostos Radiofarmacêuticos/química , Tecnécio/química , Cromatografia em Camada Fina/métodosRESUMO
The main objective of the present work was to ensure quality of radiopharmaceuticals syringes withdrawn with a "Spinal needle/obturator In-Stopper" system. Methods: Visual examinations and physicochemical tests are performed at T0 and T+4h for [99mTc]albumin nanocolloid and T+7h for [99mTc]eluate, [99mTc] HydroxyMethylene DiPhosphonate and [99mTc]Human Serum Albumin. Microbiological validation was performed according to European pharmacopoeia. Fingertip radiation exposure was evaluated to confirm the safety of the system. Results: Results show stable visual and physicochemical properties. The integrity of the connector was not affected after 30 punctures (no cores). No microbiological contamination was found on tested syringes. Conclusion: The system could be used 30 times. The stability of syringes drawing with this method is guaranteed up to 4 hours for [99mTc]albumin nanocolloid and 7 hours for [99mTc]eluate, [99mTc]HydroxyMethylene DisPhosphonate and [99mTc]Human serum albumin.
RESUMO
BACKGROUND: More than 25% of 99mTc colloidal rhenium sulphide preparations have been reported to have a radiochemical purity of <95% in 11 radiopharmacies. OBJECTIVES: To identify the key parameters involved in radiochemical purity, different preparation procedures were analysed to develop an optimised preparation method. METHODS: In the first part of this study, various data such as the Nanocis kit batch number, the eluate volume, the time between the two final elutions, the temperature and duration of heating were collected and analysed to determine the critical parameters that significantly decrease radiochemical purity. In the second part, a new procedure was applied and then the same parameters and radiochemical purity values were collected and compared with the results before the new procedure. RESULTS: Among 184 preparations, 137 (75%) had a radiochemical purity exceeding 95%, 25 (13.6%) were between 90 and 95% pure and 22 (12%) were below 90%. Significantly higher radiochemical purity was observed after the implementation of the new preparation procedure (89.5% of 374 preparations had radiochemical purities of > 95%). This new procedure consists in lowering the 99mTc eluate volume and time of heating. CONCLUSIONS: The implementation of a new method for the preparation of (99m)Tc colloidal rhenium sulphide based on a comparison of practices in various radiopharmacies resulted in: i) a determination of the critical points of this preparation, ii) an optimised labelling technique to harmonise different practices, and iii) a significant improvement in the preparations radiochemical purity and the quality of the lymphoscintigraphy in the location of sentinel node.