RESUMO
At room temperature, a 10 µm cut-off wavelength coincides with an infrared spectral window and the peak emission of blackbody objects. We report a 10 µm cut-off wavelength InAs/GaSb T2SL p-i-n diode on a GaAs substrate with an intentional interfacial misfit (IMF) array between the GaSb buffer layer and GaAs substrate. Transmission electron microscopy and energy-dispersive X-ray spectroscopy revealed that the heterostructure on GaSb-on-GaAs is epitaxial, single-crystalline but with a reduced material homogeneity, extended lattice defects and atomic segregation/intermixing in comparison to that on the GaSb substrate. Strain-induced degradation of the material quality is observed by temperature-dependent current-voltage measurements. The T2SL with the IMF array appears as a potentially effective route to mitigate the impact of the lattice mismatch once its fabrication is fully optimized for these systems, but additional strain compensating measures can enable a low cost, scalable manufacturing of focal plane arrays (FPA) for thermal imaging cameras for spectroscopy, dynamic scene projection, thermometry, and remote gas sensing.
RESUMO
Impressive opto-electronic devices and transistors have recently been fabricated from GaAs nanopillars grown by catalyst-free selective-area epitaxy, but this growth technique has always resulted in high densities of stacking faults. A stacking fault occurs when atoms on the growing (111) surface occupy the sites of a hexagonal-close-pack (hcp) lattice instead of the normal face-centered-cubic (fcc) lattice sites. When stacking faults occur consecutively, the crystal structure is locally wurtzite instead of zinc-blende, and the resulting band offsets are known to negatively impact device performance. Here we present experimental and theoretical evidence that indicate stacking fault formation is related to the size of the critical nucleus, which is temperature dependent. The difference in energy between the hcp and fcc orientation of small nuclei is computed using density-function theory. The minimum energy difference of 0.22 eV is calculated for a nucleus with 21 atoms, so the population of nuclei in the hcp orientation is expected to decrease as the nucleus grows larger. The experiment shows that stacking fault occurrence is dramatically reduced from 22% to 3% by raising the growth temperature from 730 to 790 ° C. These data are interpreted using classical nucleation theory which dictates a larger critical nucleus at higher growth temperature.
RESUMO
We report on an InAs quantum dot (QD) hybrid structure with a top surface QD layer coupled to two buried QD layers that is highly sensitive to surface passivation. After 180 min of passivation, the photoluminescence (PL) peak of the surface QDs shifts from 1545 to 1275 nm while its intensity decreases by one order of magnitude. Time-resolved PL reveals a significant decrease of carrier tunneling between the QD layers because of the surface state modification by chemical treatment. A simple model with rate equations is used to explain the observed optical performance. Our results show that the optical performance of this hybrid structure is very sensitive to the surface environment, making it a potential candidate for sensing applications.
RESUMO
We demonstrate nanopillar-(NP) based plasmon-enhanced photodetectors (NP-PEPDs) operating in the near-infrared spectral regime. A novel fabrication technique produces subwavelength elongated nanoholes in a metal surface self-aligned to patterned NP arrays that acts as a 2D plasmonic crystal. Surface plasmon Polariton Bloch waves (SPP-BWs) are excited by the metal nanohole array resulting in electric field intensity "hot spots" in the NP. The NP periodicity determines the peak responsivity wavelength while the nanohole asymmetry produces polarization-dependent coupling of the SPP-BW modes. Resulting photodetectors have 0.28 A/W responsivity peaked at 1100 nm at a reverse bias of -5 V. Designs for further increasing the optical coupling efficiency into the nanopillar are explored. This technology has potential applications for plasmonically enhanced focal plane arrays and plasmonic photovoltaics.
RESUMO
InAs quantum dot clusters (QDCs), which consist of three closely spaced QDs, are formed on nano-facets of GaAs pyramidal structures by selective-area growth using metal-organic chemical vapor deposition. Photoluminescence (PL) and time-resolved PL (TRPL) experiments, measured in the PL linewidth, peak energy and QD emission dynamics indicate lateral carrier transfer within QDCs with an interdot carrier tunneling time of 910 ps under low excitation conditions. This study demonstrates the controlled formation of laterally coupled QDCs, providing a new approach to fabricate patterned QD molecules for optical computing applications.
RESUMO
We report the growth of InAs(1-x)Sb(x) self-assembled quantum dots (QDs) on GaAs (100) by molecular beam epitaxy. The optical properties of the QDs are investigated by photoluminescence (PL) and time-resolved photoluminescence (TRPL). A type I to type II band alignment transition is demonstrated by both power-dependent PL and TRPL in InAs(1-x)Sb(x) QD samples with increased Sb beam flux. Results are compared to an eight-band strain-dependent k x p model incorporating detailed QD structure and alloy composition. The calculations show that the conduction band offset of InAs(1-x)Sb(x)/GaAs can be continuously tuned from 0 to 500 meV and a flat conduction band alignment exists when 60% Sb is incorporated into the QDs. Our study offers the possibility of tailoring the band structure of GaAs based InAsSb QDs and opens up new means for device applications.
RESUMO
The device fabrication and integration of nanopatterned quantum dots (PQDs) are realized through the demonstration of a broad-area light-emitting diode with PQD active region. The device involves two growth processes, first to form PQDs by selective-area epitaxy on an SiO(2) mask and then to complete the device structure after mask removal. Linear current-voltage characteristics are observed with sharp turn-on, low leakage current and low forward resistance. Electroluminescence spectra show PQD intraband structure and low quenching of emission from 77 K to room temperature. Light-current measurements demonstrate external quantum efficiency per PQD comparable to self-assembled QDs, thus providing a possible route toward individually addressable single QD devices.
RESUMO
Ring-shaped GaSb/GaAs quantum dots, grown by molecular beam epitaxy, were studied using cross-sectional scanning tunneling microscopy. These quantum rings have an outer shape of a truncated pyramid with baselengths around 15 nm and heights of about 2 nm but are characterized by a clear central opening extending over about 40% of the outer baselength. They form spontaneously during the growth and subsequent continuous capping of GaSb/GaAs quantum dots due to the large strain and substantial As-for-Sb exchange reactions leading to strong Sb segregation.
RESUMO
Optical properties and carrier dynamics in type-II Ga(As)Sb/GaAs quantum dots (QDs) embedded in an InGaAs quantum well (QW) are reported. A large blueshift of the photoluminescence (PL) peak is observed with increased excitation densities. This blueshift is due to the Coulomb interaction between physically separated electrons and holes characteristic of the type-II band alignment, along with a band-filling effect of electrons in the QW. Low-temperature (4 K) time-resolved PL measurements show a decay time of [Formula: see text] ns from the transition between Ga(As)Sb QDs and InGaAs QW which is longer than that of the transition between Ga(As)Sb QDs and GaAs two-dimensional electron gas ([Formula: see text] ns).
RESUMO
InAs quantum dots embedded in InGaAs quantum well (DWELL: dots-in-the-well) structures grown on nanopatterned GaAs pyramids and planar GaAs(001) surface are comparatively investigated. Photoluminescence (PL) measurements demonstrate that the DWELL structure grown on the GaAs pyramids exhibits a broad quantum well PL band (full width at half-maximum â¼ 90 meV) and a higher quantum dot emission efficiency than the DWELL structure grown on the planar GaAs(001) substrate. These properties are attributed to the InGaAs quantum well with distributed thickness profile on the faceted GaAs pyramids, which introduces a tapered energy band structure and enhances carrier capture into the quantum dots.
RESUMO
The nonlinear optical response of semiconductor microcavities in the nonpertubative regime is studied in resonant single-beam-transmission and pump-probe experiments. In both cases a pronounced third transmission peak lying spectrally between the two normal modes is observed. A fully quantized theory is essential for the agreement with the experimental observations, demonstrating that quantum fluctuations leading to intraband polarizations are responsible for this effect.