Comparison of Immobilized and Free Amyloglucosidase Process in Glucose SyrupsProduction from White Sorghum Starch.

Optimum conditions for glucose syrups production from white sorghum were studied through sequential liquefaction and saccharification processes. In the liquefaction process, a maximum dextrose equivalent (DE) of 10.98 % was achieved using 30 % (w/v) of starch and Termamyl ɑ-amylase from Bacillus licheniformis. Saccharification was performed by free and immobilized amyloglucosidase from Rhizopus mold at 1 % (w/v). DE values of 88.32 % and 79.95 % were obtained from 30 % (w/v) of starch with, respectively, free and immobilized enzyme. The immobilized Amyloglucosidase in calcium alginate beads showed reusable capacity for up to 6 cycles with 46 % of the original activity retained. The kinetic behaviour of immobilized and free enzyme gives Km value of 22.13 and 16.55 mg mL-1 and Vmax of 0.69 and 1.61 mg mL-1 min-1 , respectively. The hydrolysis yield using immobilized amyloglucosidase were lower than that of the free one. However, it is relevant to reuse enzyme without losing activity in order to trim down the overall costs of enzymatic bioprocesses as starch transformation into required products in industrial manufacturing. Hydrolysis of sorghum starch using immobilized amyloglucosidase represents a promising alternative towards the development of the glucose syrups production process and its utilization in various industries.

New biopolymer from biomass for conditioning and dehydration of sewage sludge: application on the sludge of Bouira WWTP.

Sewage treatment plants in Algeria produce huge quantities of sludge expressed in tons annually. This sludge produced is unfortunately contaminated because of the use of synthetic polyelectrolytes. Recently several kinds of research have been carried out on natural flocculants for sludge conditioning, because of several advantages they present such as their renewable source and their non-toxicity. This work aims to evaluate the potential use of protonated pectin extracted from orange waste of N'GAOUS juice factory as an eco-friendly flocculant in the chemical conditioning of sludge. Protonated pectin effectiveness was compared with synthetic cationic anionic and ionic polyelectrolytes (SUPERFLOC 8396, AF400, NF102). In this context, raw sludge samples from Bouira WWTP were tested. Specific resistance to filtration (SRF), cakes dry solid content were analyzed to determine filterability, dewatering capacity of conditioned sludge, and the optimum dose of each conditioner. So that our goal was to obtain greater dryness, which is the case with the addition of protonated pectin and even the addition of Superfloc, which allowed us to obtain dryness of 33.01% and 29.19%, respectively, for the same doses that gave the lowest SRF. Based on the results found and the analysis of the specific resistance to filtration (SRF) and the dryness, and compared with the values observed for the dewatered sludge by the method used in the Bouira WWTP. Band filters (18-22%) and raw sludge (4.8-5.7%).

Leptospira ainlahdjerensis sp. nov., Leptospira ainazelensis sp. nov., Leptospira abararensis sp. nov. and Leptospira chreensis sp. nov., four new species isolated from water sources in Algeria.

Leptospira strains were isolated from freshwater sampled at four sites in Algeria and characterized by whole-genome sequencing and matrix-assisted laser desorption ionization-time of flight mass spectrometry (MALDI-TOF MS). The cells were spiral-shaped and motile. Phylogenetic and MALDI-TOF MS analyses showed that the strains can be clearly distinguished from the other described species in the genus Leptospira, therefore representing two novel species of the pathogen subclade P1 and two novel species of the saprophyte subclade S1. The names Leptospira ainlahdjerensis sp. nov. (type strain 201903070T=KIT0297T=CIP111912T), Leptospira ainazelensis sp. nov. (201903071T=KIT0298T=CIP111913T), Leptospira abararensis sp. nov. (201903074T=KIT0299T=CIP111914T) and Leptospira chreensis (201903075T=KIT0300T=CIP111915T) are proposed.

Preparation and Characterization of TiO2-PVDF/PMMA Blend Membranes Using an Alternative Non-Toxic Solvent for UF/MF and Photocatalytic Application.

The approach of the present work is based on the use of poly (methylmethacrylate) (PMMA) polymer, which is compatible with PVDF and TiO2 nanoparticles in casting solutions, for the preparation of nano-composites membranes using a safer and more compatible solvent. TiO2 embedded poly (vinylidene fluoride) (PVDF)/PMMA photocatalytic membranes were prepared by phase inversion method. A non-solvent induced phase separation (NIPS) coupled with vapor induced phase separation (VIPS) was used to fabricate flat-sheet membranes using a dope solution consisting of PMMA, PVDF, TiO2, and triethyl phosphate (TEP) as an alternative non-toxic solvent. Membrane morphology was examined by scanning electron microscopy (SEM). Backscatter electron detector (BSD) mapping was used to monitor the inter-dispersion of TiO2 in the membrane surface and matrix. The effects of polymer concentration, evaporation time, additives and catalyst amount on the membrane morphology and properties were investigated. Tests on photocatalytic degradation of methylene blue (MB) were also carried out using the membranes entrapped with different concentrations of TiO2. The results of this study showed that nearly 99% MB removal can be easily achieved by photocatalysis using TiO2 immobilized on the membrane matrix. Moreover, it was observed that the quantity of TiO2 plays a significant role in the dye removal.

Antimicrobial activity of aqueous extracts from four plants on bacterial isolates from periodontitis patients.

Four aqueous extracts of different plant organs are the following: Artemisia herba-alba, Opuntia ficus-indica, Camellia sinensis and Phlomis crinita were evaluated against two bacterial strains: Porphyromonas gingivalis and Prevotella intermedia, which are implicated in periodontal diseases. By using a disc method, these plant extracts demonstrated powerful bacterial activity against these Gram-negative strains. The minimum inhibitory concentration values of the four plant extracts varied between 0.03 and 590.82 mg/ml for the microbes. Another assay using commercial antibiotics and antibacterials as positive controls was also conducted. Values obtained after statistical analysis of inhibition diameters of all plant extracts demonstrated that for P. gingivalis, the aqueous extracts of A. herba-alba and O. ficus-indica were most effective, followed by those of C. sinensis and P. crinita. For P. intermedia, aqueous extracts of O. ficus-indica and C. sinensis appeared to be more efficient with significantly different (P > 0.05) inhibition diameters, followed by those of O. ficus-indica and P. crinita. In summary, the statistical results reveal that these plant extracts exert stronger antibacterial activity on P. intermedia germ as compared to P. gingivalis.

Antagonistic activity of Bacillus sp. obtained from an Algerian oilfield and chemical biocide THPS against sulfate-reducing bacteria consortium inducing corrosion in the oil industry.

The present study enlightens the role of the antagonistic potential of nonpathogenic strain B21 against sulfate-reducing bacteria (SRB) consortium. The inhibitor effects of strain B21 were compared with those of the chemical biocide tetrakishydroxymethylphosphonium sulfate (THPS), generally used in the petroleum industry. The biological inhibitor exhibited much better and effective performance. Growth of SRB in coculture with bacteria strain B21 antagonist exhibited decline in SRB growth, reduction in production of sulfides, with consumption of sulfate. The observed effect seems more important in comparison with the effect caused by the tested biocide (THPS). Strain B21, a dominant facultative aerobic species, has salt growth requirement always above 5% (w/v) salts with optimal concentration of 10-15%. Phylogenetic analysis based on partial 16S rRNA gene sequences showed that strain B21 is a member of the genus Bacillus, being most closely related to Bacillus qingdaonensis DQ115802 (94.0% sequence similarity), Bacillus aidingensis DQ504377 (94.0%), and Bacillus salarius AY667494 (92.2%). Comparative analysis of partial 16S rRNA gene sequence data plus physiological, biochemical, and phenotypic features of the novel isolate and related species of Bacillus indicated that strain B21 may represent a novel species within the genus Bacillus, named Bacillus sp. (EMBL, FR671419). The results of this study indicate the application potential of Bacillus strain B21 as a biocontrol agent to fight corrosion in the oil industry.

Equilibrium, kinetic and thermodynamic studies on aluminum biosorption by a mycelial biomass (Streptomyces rimosus).

This work focused on kinetic, equilibrium and thermodynamic studies on aluminum biosorption by Streptomyces rimosus biomass. Infrared spectroscopy analysis shows that S. rimosus present some groups: hydroxyl, methyl, carboxyl, amine, thiol and phosphate. The maximum biosorption capacity of S. rimosus biomass was found to be 11.76 mg g(-1) for the following optimum conditions: particle size, [250-560] µm, pH 4-4.25, biomass content of 25 g L(-1), agitation of 250 rpm and temperature of 25 °C. Langmuir, Freundlich and Dubinin-Radushkevich (D-R) models were applied to describe the biosorption isotherms at free pH (pH(i) 4) and fixed pH (pH(f) 4). Langmuir model is the most adequate. With fixed pH, the maximum biosorption capacity is enhanced from 6.62 mg g(-1) to 11.76 mg g(-1). The thermodynamic parameters (ΔG°, ΔH° and ΔS°) showed the feasibility, endothermic and spontaneous nature of the biosorption at 10-80 °C. The activation energy (Ea) was determined as 52.18 kJ mol(-1) using the Arrhenius equation and the rate constant of pseudo-second-order model (the most adequate kinetic model). The mean free energy was calculated as 12.91 kJ mol(-1) using the D-R isotherm model. The mechanism of Al(III) biosorption on S. rimosus could be a chemical ion exchange and carboxyl groups are mainly involved in this mechanism.