Membrane of Functionalized Reduced Graphene Oxide Nanoplates with Angstrom-Level Channels.

Membranes with atomic level pores or constrictions are valuable for separation and catalysis. We report a graphene-based membrane with an interlayer spacing of 3.7 angstrom (Å). When graphene oxide nanoplates are functionalized and then reduced, the laminated reduced graphene oxide (rGO) nanoplates or functionalized rGO membrane is little affected by an intercalated fluid, and the interlayer spacing of 3.7 Å increases only to 4.4 Å in wetted state, in contrast to the graphene oxide (GO) membrane whose interlayer spacing increases from 9 Å to 13 Å in wetted state. When applied to ion separation, this membrane reduced the permeation rate of small ions such as K(+) and Na(+) by three orders of magnitude compared to the GO membrane.

Upper critical solution temperature (UCST) phase transition of halide salts of branched polyethylenimine and methylated branched polyethylenimine in aqueous solutions.

The upper critical solution temperature (UCST) phase transition of halide salts of branched polyethylenimine (PEI) and methylated branched polyethylenimine (MPEI) is first reported in aqueous solutions. In particular, iodide counter-ions can introduce UCST properties in MPEI. The importance of the counter-ion composition of MPEI for UCST transition is discussed in detail.

Unlocking the pH-responsive degradability of fumaramic acid derivatives using photoisomerization.

Fumaramic acid derivatives can be converted into their cis isomer maleamic acid derivatives under UV illumination, and these maleamic acid derivatives show pH-responsive degradability at acidic pH only after the preceding photoisomerization. The rate of the tandem photoisomerization-degradation of fumaramic acid derivatives can be finely controlled by changing the substituents on the double bond. Photoisomerization-based unlocking of the pH-responsive degradability of fumaramic acid derivatives has strong potential for the development of multisignal-responsive smart materials in biomedical applications.

Lower critical solution temperature (LCST) phase separation of glycol ethers for forward osmotic control.

Lower critical solution temperature (LCST) phase transition of glycol ether (GE)-water mixtures induces an abrupt change in osmotic pressure driven by a mild temperature change. The temperature-controlled osmotic change was applied for the forward osmosis (FO) desalination. Among three GEs evaluated, di(ethylene glycol) n-hexyl ether (DEH) was selected as a potential FO draw solute. A DEH-water mixture with a high osmotic pressure could draw fresh water from a high-salt feed solution such as seawater through a semipermeable membrane at around 10 °C. The water-drawn DEH-water mixture was phase-separated into a water-rich phase and a DEH-rich phase at around 30 °C. The water-rich phase with a much reduced osmotic pressure released water into a low-salt solution, and the DEH-rich phase was recovered into the initial DEH-water mixture. The phase separation behaviour, the residual GE concentration in the water-rich phase, the osmotic pressure of the DEH-water mixture, and the osmotic flux between the DEH-water mixture and salt solutions were carefully analysed for FO desalination. The liquid-liquid phase separation of the GE-water mixture driven by the mild temperature change between 10 °C and 30 °C is very attractive for the development of an ideal draw solute for future practical FO desalination.

Circulatory osmotic desalination driven by a mild temperature gradient based on lower critical solution temperature (LCST) phase transition materials.

Abrupt changes in effective concentration and osmotic pressure of lower critical solution temperature (LCST) mixtures facilitate the design of a continuous desalination method driven by a mild temperature gradient. We propose a prototype desalination system by circulating LCST mixtures between low and high temperature (low T and high T) units. Water molecules could be drawn from a high-salt solution to the LCST mixture through a semipermeable membrane at a temperature lower than the phase transition temperature, at which the effective osmotic pressure of the LCST mixture is higher than the high-salt solution. After transfer of water to the high T unit where the LCST mixture is phase-separated, the water-rich phase could release the drawn water into a well-diluted solution through the second membrane due to the significant decrease in effective concentration. The solute-rich phase could be recovered in the low T unit via a circulation process. The molar mass, phase transition temperature, and aqueous solubility of the LCST solute could be tuneable for the circulatory osmotic desalination system in which drawing, transfer, release of water, and the separation and recovery of the solutes could proceed simultaneously. Development of a practical desalination system that draws water molecules directly from seawater and produces low-salt water with high purity by mild temperature gradients, possibly induced by sunlight or waste heat, could be attainable by a careful design of the molecular structure and combination of the circulatory desalination systems based on low- and high-molar-mass LCST draw solutes.

Novel lower critical solution temperature phase transition materials effectively control osmosis by mild temperature changes.

Osmosis can be controlled reversibly and effectively by mild temperature changes based on novel thermosensitive solutes with LCST transition. The nBu-TAEA thermosensitive solution can draw fresh water from seawater at temperatures less than the phase separation temperature, and the osmotic flow was reversed at higher temperatures.