Study of the impact of structural factors and cleaning efficiency in reducing hazardous litter density and its related pollution in urban environment.

Cigarette filter is the most common hazardous litter that contains many pollutants including PAHs. The durability of this litter in the urban environment has an important effect on the rate of pollutant leakage. In this study, the leakage rate of PAHs from the littered cigarette filters was estimated by considering the affecting parameters on their durability in the urban environment. The results showed that the density of littered cigarette filters in the studied locations was 0.00048-0.13563 g/m2. The maximum spatial variation of the littered cigarette filter was 225 times. The average leakage of the total studied PAHs was estimated to be 2.048 µg/10 m2. The impact of structural factors and efficiency of urban cleaning in the estimated leakage was at most 2.4 times. It is necessary to change the behavior of citizens in littering the cigarette filter, considering its durability in the urban environment, to reduce the environmental and health consequences caused by the leakage of PAHs.

Techno-environmental study on the consequences of carwash wastewater and its management methods.

Carwash wastewater (CWW) is an important source of environmental pollution. The aim of this study was to investigate the characteristics of CWW and technical comparison of its treatment methods. For this purpose, a systematic search was conducted and after three stages of screening the found articles, finally 30 articles were selected for this review. The results showed that due to the differences in the type of washing, the geological condition, the type of car, and the climatic conditions, the CWWs have temporal and spatial variation in the concentration of pollutants. However, the most important pollutants of CWW include oil, suspended solids, detergents, and organic compounds. The most widely used methods in CWW treatment in the main stages included chemical coagulation and electrocoagulation, which reduce turbidity by more than 90% and COD by more than 50% in the best efficiency. Also, membrane technology was a common method in CWW treatment systems to achieve proper effluent quality. COD reduction by ultrafiltration, nanofiltration, microfiltration, and reverse osmosis was 95-77%, more than 90%, 81-73%, and 87%, respectively. The efficiency of membrane technologies in reducing turbidity was often more than 90% and in few cases more than 50%. Sludge production in the coagulation process, energy consumption in electrochemical processes, and the low water recovery rate in membrane processes are important challenges in CWW treatment that must be managed by modifying the process or using combined methods.

Comprehensive health risk analysis of heavy metal pollution using water quality indices and Monte Carlo simulation in R software.

Rapid urbanization, population growth, agricultural practices, and industrial activities have led to widespread groundwater contamination. This study evaluated heavy metal contamination in residential drinking water in Shiraz, Iran (2021). The analysis involved 80 groundwater samples collected across wet and dry seasons. Water quality was comprehensively assessed using several indices, including the heavy metals evaluation index (HEI), heavy metal pollution index (HPI), contamination degree (CD), and metal index (MI). Carcinogenic and non-carcinogenic risk assessments were conducted using deterministic and probabilistic approaches for exposed populations. In the non-carcinogenic risk assessment, the chronic daily intake (CDI), hazard quotient (HQ), and hazard index (HI) are employed. The precision of risk assessment was bolstered through the utilization of Monte Carlo simulation, executed using the R software platform. Based on the results, in both wet and dry seasons, Zinc (Zn) consistently demonstrates the highest mean concentration, followed by Manganese (Mn) and Chromium (Cr). During the wet and dry seasons, 25% and 40% of the regions exhibited high CD, respectively. According to non-carcinogenic risk assessment, Cr presents the highest CDI and HQ in children and adults, followed by Mn, As and HI values, indicating elevated risk for children. The highest carcinogenic risk was for Cr in adults, while the lowest was for Cd in children. The sensitivity analysis found that heavy metal concentration and ingestion rate significantly impact both carcinogenic and non-carcinogenic risks. These findings provide critical insights for shaping policy and allocating resources towards effectively managing heavy metal contamination in residential drinking water.

Short-term exposure to some heavy metals carried with PM10 and cardiovascular system biomarkers during dust storm.

This study aimed to evaluate the effect of short-term exposure to heavy metals (HM) extracted from PM10 on CB in workers' population in an outdoor space located in southern Iran during a dust storm. At first, 44 healthy and non-smoking workers were selected. Then PM10 and Blood samples were collected before and after the dust storm. Finally, HMs associated with PM10 measured by ICP-MS and its effect on the CB, including fibrinogen, CRP, TNF-α, and BP were estimated by ANOVA, Pearson correlation, and Odd Ratio (OR) in SPSS23. Based on the results, the concentration of PM10 and extracted HM such as Cr, As, and Cd was higher than the WHO/EPA standards in dust storms they increased the CB and BP remarkably. Moreover, the level of fibrinogen, blood pressure (BP) and TNF-α in dust storms were higher than in normal conditions (p < 0.05, OR > 3). In addition, As and Cd decreased fibrinogen concentration and systolic BP, respectively. Whereas, TNF-α was associated with concentration of Pb (R = - 0.85) on normal days. Consequently, the HM on PM10 such as As, interferes with the level of investigated CB. These results considered a potential risk for the residents in the southern regions of Iran.

Cigarette butts as a super challenge in solid waste management: a review of current knowledge.

Filtered cigarette is the most common type of tobacco used and cigarette butt is the most important environmental consequence of smoking. This study aimed to investigate the cigarette butt management and identify future needs to improve the current situation. The results showed that cigarette butts are the most abundant and widespread hazardous waste in the world. The current form of cigarette butt management has inferior performance that faced waste management systems with serious challenges. The results showed that reducing the littering rate and recycling are known as basic strategies in the management of this hazardous waste. Future studies should focus on reducing cigarette butt pollution and the amount of pollutant leakage from them.

Magnetic CuNiFe2O4 nanoparticles loaded on multi-walled carbon nanotubes as a novel catalyst for peroxymonosulfate activation and degradation of reactive black 5.

Novel copper-nickel ferrite nanocatalyst loaded on multi-walled carbon nanotube (MWCNTs-CuNiFe2O4) was synthesized and applied to activate peroxymonosulfate (PMS) in the degradation of the reactive black 5 (RB5). The structure of the catalyst was well characterized by scanning electron microscope (SEM), Fourier-transform infrared spectroscopy (FTIR), and X-ray powder diffraction (XRD). The MWCNTs-CuNiFe2O4/PMS system showed a high performance in the degradation of RB5 with a kinetic rate of 1.5-2.5 times higher than homogeneous and heterogeneous systems. Maximum degradation efficiency (99.60%) was obtained at an initial pH of 7, catalyst dosage of 250 mg/L, PMS dosage of 4 mM, the temperature of 25 °C, and reaction time of 15 min. Anion experiments emphasized that the presence of nitrate, carbonate, and phosphate in the solution reduced the degradation efficiency by producing reactive species with low oxidation potential. The RB5 degradation rate evolved with temperature, and the activation energy was obtained to be 44.48 kJ/mol. The mechanism of PMS activation and production of free radicals was proposed based on tert-butyl alcohol (TBA), ethanol (EtOH), and potassium iodide (KI) scavengers. Trapping experiments showed that both sulfate (SO4•-) and hydroxyl (•OH) radicals are involved in the catalytic degradation of RB5. The effective treatment of real wastewater and tap water by the MWCNTs-CuNiFe2O4/PMS system requires a long reaction time. Gas chromatography-mass spectrometry (GC-MS) analysis indicated that RB5 can be degraded via methylation, decarboxylation, hydroxylation, and ring/chain cleavage pathways. The stable catalytic activity after three consecutive cycles suggested that MWCNTs-CuFe2O4 is a novel reusability catalyst in PMS activation.

In situ treatment of metalworking wastewater by chemical addition-dissolved air flotation coupled with UV, H2O2 & ZnO.

The hybrid treatment techniques have been proven that could be a proper solution to the metalworking fluid (MWF) wastewaters disposal challenge. Hence, this investigation was conducted aim to the assessment of chemical addition-dissolved air floatation (CA-DAF) unit followed with a heterogeneous photocatalytic (PC) process as UV/H2O2/ZnO to treat MWF wastewater produced in one of the central industrial estates in the Middle East. The CA-DAF unit was implemented as trial and errors and had an appropriate efficiency. However, the environmental discharge standards were not achieved only by this unit, so that, a PC process considered for this purpose in a pilot-scale reactor. And also, Chemical oxygen demand (COD), total petroleum hydrocarbons (TPHs) were considered as physicochemical parameters to analyze the applied photochemical reaction throughout the concentrations of ZnO and H2O2, and pH value as variables of the study. The ideal and optimized conditions were observed at pH 10, 600 mg l-1 of ZnO, and 13.11 g l-1 of H2O2 via 99.87% and 97.9% reduction rates in total COD and TPH, respectively. These removal rates were obtained for this integrated strategy under the optimized reaction. By evaluating the synergistic effect, it was found that UV/ZnO could be a predominant reaction in this process. The organic and intermediates analysis appeared 78.46% reduction for all detected organic matters. Besides, PC generation of bis phthalate, mono phthalate, benzene, and benzoic acid to 2,6-bis (1,1-dimethylethyl)-4-mthyl phenol was the reason of the residual phenolic compound concentration in the reaction solution with low removal rate. The kinetic study showed that this reaction could be well fitted with the pseudo-first-order kinetic model by R 2 equal with 0.973 and 0.988 in turn for COD and TPH. The expenditures to treat 1 m3 of the CA-DAF was estimated at 5.335 us$ via cost analysis. Finally, the collected findings indicate that CA-DAF integrated with UV/H2O2/ZnO can be an efficient approach in the MWF wastes disposal or treatment for reuse.

Environmental and biological monitoring of exposures to VOCs in a petrochemical complex in Iran.

Exposure to volatile organic compounds (VOCs) can cause cancers in human. This study aimed to measure the concentration of four VOCs including benzene, styrene, ethylbenzene, and phenol in ambient air of a petrochemical complex in Iran. Also, their urinary metabolites including phenol, mandelic acid (MA), and phenylglyoxylic acid (PGA) in the workers were monitored. Urine samples were collected before and after the 8-h workshift according to the NIOSH methods. They were analyzed by a gas chromatograph coupled with a flame ionization detector (GC-FID). High levels of the ambient VOCs were detected in the units of recovery and olefin. The levels of ethylbenzene and phenol were less than the guidelines suggested by NIOSH and ACGIH. However, in some cases, the amounts of benzene and styrene were higher than the guidelines. Excellent positive correlations were observed between VOCs exposure and their urinary metabolites (r 2 > 0.90), except for benzene (r 2 = 0.26). Our finding verified that urinary biomarkers can be applied as bioindicators for ambient exposure to VOCs. There is a risk of exposure to high levels of the pollutants in some of the sites, and it is necessary to adopt some preventive measures to reduce health risk.