Thermography as a tool to assess training effects in military working dogs.

Military working dogs are exposed to high levels of physical load during their work, although this is not always evident from their behaviour. This workload causes various physiological changes, including variation in the temperature of the affected body parts. In this preliminary study, we investigated whether thermal changes following the daily work routine of military dogs are detectable by infrared thermography (IRT). The experiment was carried out on eight male German and Belgian shepherd patrol guard dogs performing two training activities, obedience and defence. The surface temperature (Ts) of 12 selected body parts on both body sides was measured with the IRT camera 5 min before, 5 min after and 30 min after training. As predicted, there was a greater increase in Ts (mean of all measured body parts) after defence than after obedience, 5 min (by 1.24 vs. 0.60 °C, P < 0.001) and 30 min after activity (by 0.90vs. 0.57 °C, P < 0.01) compared to pre-activity levels. These findings indicate that defence is more physically demanding than obedience activity. Considering the activities separately, obedience increased Ts 5 min after the activity only in the trunk (P < 0.001) but not in the limbs, whereas defence increased it in all measured body parts (P < 0.001). Ts 30 min after obedience decreased to the pre-activity level in parts at trunk, while in distal parts of the limbs Ts remained elevated. The prolonged elevation in Ts of the limbs after both activities indicates heat flow from the core to the periphery as a thermoregulatory mechanism. The current study suggests that IRT may be a useful tool for assessing physical workload in different body parts of dogs.

Evaluation of potential toxicity of Steriplant©N aerosolization toward human alveolar cells A459 in vitro.

Protection of patients against hospital-acquired infections is of major importance. Disinfection of magnetic resonance imaging suites is, due to their unique properties and environment particularly, difficult to implement. We developed an OPTI-JET CS MD 2ZE aerosolizator for disinfection of a magnetic resonance imaging suite using the electrolyzed oxidizing water biocide Steriplant©N. The disinfection of the magnetic resonance imaging suite with this system reduced from the number of colony formed unit/m3 air by 87% and 96% in 6 and 15 min of disinfection, respectively. It is well known that exposure of personnel or patients to aerosols may represent risk to the respiratory system; therefore, the aim of this study was to assess potential cytotoxicity and genotoxicity of Steriplant©N aerosolization toward human alveolar cells A459 in vitro. The A459 cells were exposed to aerosol containing different concentrations (50% and 100% v/v) of Steripalnt©N for 6 min in a chamber that had been constructed to simulate the conditions in the magnetic resonance imaging suite. The cytotoxicity was evaluated by measuring iodide uptake, and the genotoxicity was determined by measuring formation of phosphorylated H2AX histones, a marker for deoxyribonucleic acid double-strand breaks, immediately after the aerosolization and after 1, 4, and 24 h postincubation. The results demonstrated that aerosolization with Steriplant©N at conditions reflecting aerosolization in a magnetic resonance imaging suite is not cytotoxic and does not exhibit genotoxic potential in vitro.

Surface deposited one-dimensional copper-doped TiO2 nanomaterials for prevention of health care acquired infections.

Bacterial infections acquired in healthcare facilities including hospitals, the so called healthcare acquired or nosocomial infections, are still of great concern worldwide and represent a significant economical burden. One of the major causes of morbidity is infection with Methicillin Resistant Staphylococcus aureus (MRSA), which has been reported to survive on surfaces for several months. Bactericidal activity of copper-TiO2 thin films, which release copper ions and are deposited on glass surfaces and heated to high temperatures, is well known even when illuminated with very weak UVA light of about 10 µW/cm2. Lately, there is an increased intrerest for one-dimensional TiO2 nanomaterials, due to their unique properties, low cost, and high thermal and photochemical stability. Here we show that copper doped TiO2 nanotubes produce about five times more ·OH radicals as compared to undoped TiO2 nanotubes and that effective surface disinfection, determined by a modified ISO 22196:2011 test, can be achieved even at low intensity UVA light of 30 µW/cm2. The nanotubes can be deposited on a preformed surface at room temperature, resulting in a stable deposition resistant to multiple washings. Up to 103 microorganisms per cm2 can be inactivated in 24 hours, including resistant strains such as Methicillin-resistant Staphylococcus aureus (MRSA) and Extended-spectrum beta-lactamase Escherichia coli (E. coli ESBL). This disinfection method could provide a valuable alternative to the current surface disinfection methods.

Photocatalytic disinfection of surfaces with copper doped Ti02 nanotube coatings illuminated by ceiling mounted fluorescent light.

High economic burden is associated with foodborne illnesses. Different disinfection methods are therefore employed in food processing industry; such as use of ultraviolet light or usage of surfaces with copper-containing alloys. However, all the disinfection methods currently in use have some shortcomings. In this work we show that copper doped TiO2 nanotubes deposited on existing surfaces and illuminated with ceiling mounted fluorescent lights can retard the growth of Listeria Innocua by 80% in seven hours of exposure to the fluorescent lights at different places in a food processing plant or in the laboratory conditions with daily reinocuation and washing. The disinfection properties of the surfaces seem to depend mainly on the temperature difference of the surface and the dew point, where for the maximum effectiveness the difference should be about 3 degrees celsius. The TiO2 nanotubes have a potential to be employed for an economical and continuous disinfection of surfaces.

Occurrence of Bacterial and Viral Pathogens in Common and Noninvasive Diagnostic Sampling from Parrots and Racing Pigeons in Slovenia.

Airborne pathogens can cause infections within parrot (Psittaciformes) and pigeon (Columbiformes) holdings and, in the case of zoonoses, can even spread to humans. Air sampling is a useful, noninvasive method which can enhance the common sampling methods for detection of microorganisms in bird flocks. In this study, fecal and air samples were taken from four parrot holdings. Additionally, cloacal and oropharyngeal swabs as well as air samples were taken from 15 racing pigeon holdings. Parrots were examined for psittacine beak and feather disease virus (PBFDV), proventricular dilatation disease virus (PDDV), adenoviruses (AdVs), avian paramyxovirus type-1 (APMV-1), avian influenza virus (AIV), Chlamydia psittaci (CP), and Mycobacterium avium complex (MAC). MAC and AdVs were detected in three parrot holdings, CP was detected in two parrot holdings, and PBFDV and PDDV were each detected in one parrot holding. Pigeons were examined for the pigeon circovirus (PiCV), AdVs, and CP; PiCV and AdVs were detected in all investigated pigeon holdings and CP was detected in five pigeon holdings.

Suitability of electrolyzed oxidizing water for the disinfection of hard surfaces and equipment in radiology.

BACKGROUND: Hospitals are faced with increasingly resistant strains of micro-organisms. When it comes to disinfection, individual parts of electronic equipment of angiology diagnostics such as patient couches of computer tomography (CT) and magnetic resonance imaging (MRI) scanners prove to be very hard to disinfect. Disinfectants of choice are therefore expected to possess properties such as rapid, residue-free action without any damaging effect on the sensitive electronic equipment. This paper discusses the use of the neutral electrolyzed oxidizing water (EOW) as a biocide for the disinfection of diagnostic rooms and equipment. METHODS: The CT and MRI rooms were aerosolized with EOW using aerosolization device. The presence of micro-organisms before and after the aerosolization was recorded with the help of sedimentation and cyclone air sampling. Total body count (TBC) was evaluated in absolute and log values. RESULTS: The number of micro-organisms in hospital rooms was low as expected. Nevertheless, a possible TBC reduction between 78.99-92.50% or 50.50-70.60% in log values was recorded. CONCLUSIONS: The research has shown that the use of EOW for the air and hard surface disinfection can considerably reduce the presence of micro-organisms and consequently the possibility of hospital infections. It has also demonstrated that the sedimentation procedure is insufficient for the TBC determination. The use of Biocide aerosolization proved to be efficient and safe in all applied ways. Also, no eventual damage to exposed devices or staff was recorded.

Degradation and dissipation of the veterinary ionophore lasalocid in manure and soil.

Lasalocid is a veterinary ionophore antibiotic used for prevention and treatment of coccidiosis in poultry. It is excreted from the treated animals mostly in its active form and enters the environment with the use of contaminated manure on agricultural land. To properly assess the risk that lasalocid poses to the environment, it is necessary to know its environmental concentrations as well as the rates of its degradation in manure and dissipation in soil. These values are still largely unknown. A research was undertaken to ascertain the rate of lasalocid degradation in manure under different storage conditions (aging in a pile or composting) and on agricultural soil after using lasalocid-contaminated manure. The results have shown that there is considerable difference in lasalocid degradation between aging manure with no treatment (t1/2=61.8±1.7 d) and composting (t1/2=17.5±0.8 d). Half-lives in soil are much shorter (on average 3.1±0.4 d). On the basis of the measured concentrations of lasalocid in soil after manure application, we can conclude that it can potentially be harmful to soil organisms (PEC/PNEC ratio of 1.18), but only in a worst-case scenario of using the maximum permissible amount of manure and immediately after application. To make certain that no harmful effects occur, composting is recommended.

Prevalence of pigeon circovirus infections in feral pigeons in Ljubljana, Slovenia.

Pigeon circovirus (PiCV) was detected by real-time PCR in cloacal swabs, pharyngeal swabs, and serum samples taken from 74 feral pigeons (Columba livia var. domestica) that were caught at various locations in the city of Ljubljana, Slovenia. PiCV infections were detected in the majority of the tested birds. The highest (74.3%) detection rate was observed in the cloacal swabs and the lowest (31.1%) in serum samples. PiCV DNA was more readily detected in the cloacal swabs, pharyngeal swabs, and serum samples of birds younger than 1 yr. Molecular analysis of partial open reading frame V1 sequences showed that PiCV strains detected in feral pigeons share high nucleotide and amino acid sequence identities with PiCV strains detected in ornamental, racing, meat, and feral pigeons.