Predictive assessment of kidney functional recovery following ischemic injury using optical spectroscopy.

Functional changes in rat kidneys during the induced ischemic injury and recovery phases were explored using multimodal autofluorescence and light scattering imaging. The aim is to evaluate the use of noncontact optical signatures for rapid assessment of tissue function and viability. Specifically, autofluorescence images were acquired in vivo under 355, 325, and 266 nm illumination while light scattering images were collected at the excitation wavelengths as well as using relatively narrowband light centered at 500 nm. The images were simultaneously recorded using a multimodal optical imaging system. The signals were analyzed to obtain time constants, which were correlated to kidney dysfunction as determined by a subsequent survival study and histopathological analysis. Analysis of both the light scattering and autofluorescence images suggests that changes in tissue microstructure, fluorophore emission, and blood absorption spectral characteristics, coupled with vascular response, contribute to the behavior of the observed signal, which may be used to obtain tissue functional information and offer the ability to predict posttransplant kidney function.

Laser damage mechanisms in conductive widegap semiconductor films.

Laser damage mechanisms of two conductive wide-bandgap semiconductor films - indium tin oxide (ITO) and silicon doped GaN (Si:GaN) were studied via microscopy, spectroscopy, photoluminescence (PL), and elemental analysis. Nanosecond laser pulse exposures with a laser photon energy (1.03 eV, 1064 nm) smaller than the conductive films bandgaps were applied and radically different film damage morphologies were produced. The laser damaged ITO film exhibited deterministic features of thermal degradation. In contrast, laser damage in the Si:GaN film resulted in highly localized eruptions originating at interfaces. For ITO, thermally driven damage was related to free carrier absorption and, for GaN, carbon complexes were proposed as potential damage precursors or markers.

Laser-induced Hertzian fractures in silica initiated by metal micro-particles on the exit surface.

Laser-induced Hertzian fractures on the exit surface of silica glass are found to result from metal surface-bound micro particles. Two types of metal micro-spheres are studied (stainless-steel and Al) using ultraviolet laser light. The fracture initiation probability curve as a function of fluence is obtained, resulting in an initiation threshold fluence of 11.1 ± 4.7 J/cm2 and 16.5 ± 4.5 J/cm2 for the SS and Al particles, accordingly. The modified damage density curve is calculated based on the fracture probability. The calculated momentum coupling coefficient linking incident laser fluence to the resulting plasma pressure is found to be similar for both particles: 32.6 ± 15.4 KN/J and 28.1 ± 10.4 KN/J for the SS and Al cases accordingly.

Mechanisms governing the interaction of metallic particles with nanosecond laser pulses.

The interaction of nanosecond laser pulses at 1064- and 355-nm with micro-scale, nominally spherical metallic particles is investigated in order to elucidate the governing interaction mechanisms as a function of material and laser parameters. The experimental model used involves the irradiation of metal particles located on the surface of transparent plates combined with time-resolved imaging capable of capturing the dynamics of particle ejection, plume formation and expansion along with the kinetics of the dispersed material from the liquefied layer of the particle. The mechanisms investigated in this work are informative and relevant across a multitude of materials and irradiation geometries suitable for the description of a wide range of specific applications. The experimental results were interpreted using physical models incorporating specific processes to assess their contribution to the overall observed behaviors. Analysis of the experimental results suggests that the induced kinetic properties of the particle can be adequately described using the concept of momentum coupling introduced to explain the interaction of plane metal targets to large-aperture laser beams. The results also suggest that laser energy deposition on the formed plasma affects the energy partitioning and the material modifications to the substrate.

Damage on fused silica optics caused by laser ablation of surface-bound microparticles.

High peak power laser systems are vulnerable to performance degradation due to particulate contamination on optical surfaces. In this work, we show using model contaminant particles that their optical properties decisively determine the nature of the optical damage. Borosilicate particles with low intrinsic optical absorption undergo ablation initiating in their sub-surface, leading to brittle fragmentation, distributed plasma formation, material dispersal and ultimately can lead to micro-fractures in the substrate optical surface. In contrast, energy coupling into metallic particles is highly localized near the particle-substrate interface leading to the formation of a confined plasma and subsequent etching of the substrate surface, accompanied by particle ejection driven by the recoil momentum of the ablation plume. While the tendency to create fractured surface pitting from borosilicate is stochastic, the smooth ablation pits created by metal particles is deterministic, with pit depths scaling linearly with laser fluence. A simple model is employed which predicts ~3x electric field intensity enhancement from surface-bound fragments. In addition, our results suggest that the amount of energy deposited in metal particles is at least twice that in transparent particles.

Directed dewetting of amorphous silicon film by a donut-shaped laser pulse.

Irradiation of a thin film with a beam-shaped laser is proposed to achieve site-selectively controlled dewetting of the film into nanoscale structures. As a proof of concept, the laser-directed dewetting of an amorphous silicon thin film on a glass substrate is demonstrated using a donut-shaped laser beam. Upon irradiation of a single laser pulse, the silicon film melts and dewets on the substrate surface. The irradiation with the donut beam induces an unconventional lateral temperature profile in the film, leading to thermocapillary-induced transport of the molten silicon to the center of the beam spot. Upon solidification, the ultrathin amorphous silicon film is transformed to a crystalline silicon nanodome of increased height. This morphological change enables further dimensional reduction of the nanodome as well as removal of the surrounding film material by isotropic silicon etching. These results suggest that laser-based dewetting of thin films can be an effective way for scalable manufacturing of patterned nanostructures.

Time-resolved imaging of processes associated with exit-surface damage growth in fused silica following exposure to nanosecond laser pulses.

We study the dynamics of energy deposition and subsequent material response associated with exit surface damage growth in fused silica using a time resolved microscope system. This system enables acquisition of two transient images per damage event with temporal resolution of 180 ps and spatial resolution on the order of 1 µm. The experimental results address important issues in laser damage growth that include: a) the specific structural features within a damage site where plasma formation initiates; b) the subsequent growth of the plasma regions; c) the formation and expansion of radial and circumferential cracks; d) the kinetics and duration of material ejection; e) the characteristics of the generated shockwave.

Characterization of ejected fused silica particles following surface breakdown with nanosecond pulses.

The light emission produced near the surface of fused silica following laser-induced breakdown on the exit surface was spatially and spectrally resolved. This signal is in part generated by ejected particles while traveling outside the hot ionized region. The thermal emission produced by the particles can be separated from the plasma emission near the surface and its spectral characteristics provide information on the temperature of the particles after ejection from the surface. Assuming the emission is thermal in origin, data suggest an initial average temperature on the order of at least 0.5 eV.

Measurement of the Raman scattering cross section of the breathing mode in KDP and DKDP crystals.

The spontaneous Raman scattering cross sections of the main peaks (related to the A1 vibrational mode) in rapid and conventional grown potassium dihydrogen phosphate and deuterated crystals are measured at 532 nm, 355 nm, and 266 nm. The measurement involves the use of the Raman line of water centered at 3400 cm-1 as a reference to obtain relative values of the cross sections which are subsequently normalized against the known absolute value for water as a function of excitation wavelength. This measurement enables the estimation of the transverse stimulated Raman scattering gain of these nonlinear optical materials in various configurations suitable for frequency conversion and beam control in high-power, large-aperture laser systems.

Monitoring annealing via CO(2) laser heating of defect populations on fused silica surfaces using photoluminescence microscopy.

Photoluminescence (PL) microscopy and spectroscopy under 266 nm and 355 nm laser excitation are explored as a means of monitoring defect populations in laser-modified sites on the surface of fused silica and their subsequent response to heating to different temperatures via exposure to a CO(2) laser beam. Laser-induced temperature changes were estimated using an analytic solution to the heat flow equation and compared to changes in the PL emission intensity. The results indicate that the defect concentrations decrease significantly with increasing CO(2) laser exposure and are nearly eliminated when the peak surface temperature exceeds the softening point of fused silica (approximately 1900K), suggesting that this method might be suitable for in situ monitoring of repair of defective sites in fused silica optical components.

Evaluation of the contribution of the renal capsule and cortex to kidney autofluorescence intensity under ultraviolet excitation.

The use of reduced nicotinamide adenine dinucleotide (NADH) fluorescence to gain metabolic information on kidneys in response to an alteration in oxygen availability has previously been experimentally demonstrated, but signal quantification has not, to date, been addressed. In this work the relative contribution to rat kidney autofluorescence of the capsule versus cortex under ultraviolet excitation is determined from experimental results obtained using autofluorescence microscopy and a suitable mathematical model. The results allow for a quantitative assessment of the relative contribution of the signal originating in the metabolically active cortex as a function of capsule thickness for different wavelengths.

A non-contact method and instrumentation to monitor renal ischemia and reperfusion with optical spectroscopy.

The potential of NADH autofluorescence as an in vivo intrinsic optical signature to monitor tissue metabolism is well recognized and supported by experimental results mainly in animal models. In this work, we propose a non-contact implementation of this method using large area excitation and employing a normalization method to account for non-metabolic signal changes. Proof of principle in vivo experiments were carried out using an autofluorescence imaging experimental system and a rat renal ischemia model. A hand-held fiber-optic probe was utilized to test the ability of the signal normalization method to address operational conditions associated with the translation of this method to a clinical setting. Preliminary pre-clinical in vivo test of the probe system was carried out using the same rat model.

Quantification of in vivo autofluorescence dynamics during renal ischemia and reperfusion under 355 nm excitation.

We explore a method to quantitatively assess the ability of in vivo autofluorescence as a means to quantify the progression of longer periods of renal warm ischemia and reperfusion in a rat model. The method employs in vivo monitoring of tissue autofluorescence arising mainly from NADH as a means to probe the organ's function and response to reperfusion. Clinically relevant conditions are employed that include exposure of the kidney to ischemia on the order of tens of minutes to hours. The temporal profile during the reperfusion phase of the autofluorescence intensity averaged over an area as large as possible was modeled as the product of two independent exponential functions. Time constants were extracted from fits to the experimental data and their average values were found to increase with injury time.

Real-time assessment of in vivo renal ischemia using laser autofluorescence imaging.

Potentially transplantable kidneys experience warm ischemia, and this injury is difficult to quantify. We investigate optical spectroscopic methods for evaluating, in real time, warm ischemic kidney injury and reperfusion. Vascular pedicles of rat kidneys are clamped unilaterally for 18 or 85 min, followed by 18 or 35 min of reperfusion, respectively. Contralateral, uninjured kidneys serve as controls. Autofluorescence and cross-polarized light scattering images are acquired every 15 s using 335-nm laser excitation (autofluorescence) and 650+/-20-nm linearly polarized illumination (light scattering). We analyze changes of injured-to-normal kidney autofluorescence intensity ratios during ischemia and reperfusion phases. The effect of excitation with 260 nm is also explored. Average injured-to-normal intensity ratios under 335-nm excitation decrease from 1.0 to 0.78 at 18 min of ischemia, with a return to baseline during 18 min of reperfusion. However, during 85 min of warm ischemia, average intensity ratios level off at 0.65 after 50 min, with no significant change during 35 min of reperfusion. 260-nm excitation results in no autofluorescence changes with ischemia. Cross-polarized light scattering images at 650 nm suggest that changes in hemoglobin absorption are not related to observed temporal behavior of the autofluorescence signal. Real-time detection of kidney tissue changes associated with warm ischemia and reperfusion using laser spectroscopy is feasible. Normalizing autofluorescence changes under 335 nm using the autofluorescence measured under 260-nm excitation may eliminate the need for a control kidney.