RESUMO
Single crystals of boron-doped diamond (BDD) were synthesized by the temperature gradient method in high-pressure and high-temperature conditions in the Fe-Al-B-C system, and multisectoral diamond plates were extracted. Temperature-dependent (77-600 K) high-resolution Raman spectroscopic studies have been carried out to investigate the behavior of anharmonic phonon decay in the {001}, {113}, and {111} growth sectors of multisectoral diamond plates with different content of boron impurities (⩽80 ppm) and compare with the data for undoped IIa diamond. Micro-Fourier transform infrared spectroscopy was used to estimate the spatial distribution of uncompensated boron impurity[Na-Nd]in BDD plates by analyzing boron-related absorption peaks. The plates were shown to have non-uniform growth-sector-dependent content of uncompensated boron impurity in the range from 1.1 × 1018to 1.4 × 1019cm-3. The effects of anharmonic decay (damping) of optical phonons in BDD are studied by modeling the temperature dependence of phonon frequency and linewidth of the diamond's F2gand boron-induced vibrational modes. The extrapolated zero-temperature optical phonon linewidth and frequency and the anharmonic nature of their linear relationship are determined as a function of the growth sector and boron doping. The predominant mechanisms and parameters of the anharmonic decay of optical phonons are determined, which is of fundamental importance for the thermal conductivity of semiconductor materials. The anharmonic phonon decay remained the predominant process at higher temperatures, irrespective of the doping level.
RESUMO
The unique physicochemical properties of modern two-dimensional (2D) nanomaterials with graphene-like structures make them promising candidates for biology and medicine purposes. In this article, we investigate the influence of the two-dimensional tungsten disulfide (2D WS2) water suspension nanoparticles obtained by an improved mechanochemical method from powdered WS2 on morphological and structural characteristics of Lewis lung carcinoma cells using FT-IR, Raman spectroscopy, and confocal microscopy. The characterization of the 2D WS2 nanoparticles by different physical methods is given also. We have highlighted that 2D WS2 does not exert cytotoxic activity in the case of 1 day incubation with tumor cells. Prolongation of the incubation period up to 2 days has caused a statistically significant (p < 0.05) concentration-dependent decrease of the number of viable cells by more than 30% with the maximum cytotoxic effect at concentrations of 2D WS2 close to 2 µg ml-1. In the Raman spectra of 2D WS2 treated cells the bands centered at 354 cm-1 and 419 cm-1, which are assigned to characteristics and modes of WS2 nanoparticles were observed. The obtained data indicate, that the cytotoxic effect of 2D WS2 on tumor cells in the case of long-term incubation is realized particularly through the ability of 2D WS2 to enter tumor cells and/or accumulate on their surface, which gives a rationale to conduct further studies of their antitumor efficacy in vitro and in vivo when combined with chemotherapeutic drugs.
RESUMO
Al2O3:SiOC nanocomposites were synthesized by thermal treatment of fumed alumina nanoparticles modified by phenyltrimethoxysilane. The effect of annealing temperature in inert ambient on structure and photoluminescence of modified alumina powder was studied by IR spectroscopy as well as photoluminescence spectroscopy with ultraviolet and X-ray excitation. It is demonstrated that increase of annealing temperature results in formation of silica precipitates on the surface of alumina particles that is accompanied by development and spectral evolution of visible photoluminescence. These observations are discussed in terms of structural transformation of the surface of Al2O3 particles.
RESUMO
In the present work, we used Raman spectroscopy as sensitive tool for characterization of dispersion of electron-phonon resonances in one-layer graphene. We analyzed Stokes and anti-Stokes components of the Raman spectra to investigate the temperature dependence of the graphene G-band on the power of exciting radiation. Appearance and drastic intensity increase of zone-edge D-like modes caused by introduction of structural defects and/or deformations in the graphene layer were observed in the Raman spectra at high powers of excitation. We investigated phonon dispersion of one-layer graphene for iTO phonon branch at K point along K-M direction, which is involved in double-resonance Raman scattering. Raman dispersion slope of D-band is in good agreement with results of theoretical calculations based on the Green's functions approach based on the screened electron-electron interaction. Deviation of the experimental iTO phonon frequency from the linear dependence on excitation energy was observed at excitation E(exc) = 3.81 eV. Self-consistent classification of phonon states according to the symmetry for all dispersion branches of one-layer graphene was carried out.
Assuntos
Grafite/química , Nanoestruturas/química , Nanoestruturas/ultraestrutura , Análise Espectral Raman/métodos , Ressonância de Plasmônio de Superfície/métodos , Luz , Teste de Materiais , Tamanho da Partícula , Espalhamento de RadiaçãoRESUMO
Resonance Raman spectra of mixture of single-wall carbon nanotubes were investigated in details. The diameter distribution of the investigated nanotubes was estimated from the experimental frequencies of radial breathing modes. Two series of two-phonon lines revealing step-like behavior with excitation energy as well as non-dispersive single-phonon lines were registered in the intermediate frequency range 200-1200 cm(-1). Observed Raman lines were analyzed and their assignment to particular phonons was carried out. Step-like dispersive high intermediate-frequency modes in the range of 720-1000 cm(-1) are attributed to resonance two-phonon processes with combinations of optical and acoustical modes Low intermediate-frequency modes in the range of 300-650 cm(-1), also revealing step-like behavior, are attributed to resonance two-phonon processes with combinations of flexural optical and acoustical modes.
Assuntos
Nanotubos de Carbono/química , Nanotubos de Carbono/ultraestrutura , Luz , Teste de Materiais , Tamanho da Partícula , Espalhamento de Radiação , Análise Espectral RamanRESUMO
We report a way to assess the separation between a molecule and a metal surface on account of both Raman scattering and fluorescence intensities measured simultaneously. This approach has no need for an accurate quantity of molecules and bears 1 nm resolution. Its distance sensitivity is experimentally demonstrated in the case of dye molecules lying on a gold surface with a polymer spacer layer in between and is compared with theoretical prediction.
RESUMO
Lateral ordering of InGaAs quantum dots on the GaAs (001) surface has been achieved in earlier reports, resembling an anisotropic pattern. In this work, we present a method of breaking the anisotropy of ordered quantum dots (QDs) by changing the growth environment. We show experimentally that using As(2) molecules instead of As(4) as a background flux is efficient in controlling the diffusion of distant Ga adatoms to make it possible to produce isotropic ordering of InGaAs QDs over GaAs (001). The control of the lateral ordering of QDs under As(2) flux has enabled us to improve their optical properties. Our results are consistent with reported experimental and theoretical data for structure and diffusion on the GaAs surface.