RESUMO
Pump As Turbine (PAT) utility represents a major advance in the field of hydraulic engineering. This work aims to improve the PAT performance characteristics. The sharp impeller leading edge (original impeller) was revealed by flow analysis as exhibiting negative effects on the PAT performances due to flow separation and flow misalignment. The performances of rounded and original impeller leading edge were studied by Computational Fluid Dynamic (CFD) method carried out on ANSYS CFX. Although impeller leading edge rounding has notably improved the performances in off design conditions, the difference of efficiency between the both impeller types was decreasing when increasing the discharge. The hydraulic head generated by the rounded impeller leading edge was also slightly higher at part load conditions, but when increasing the discharge, the difference between the both heads became negligible. It appeared from numerical simulations that the impeller leading edge rounding allows to decrease the hydraulic losses of the individual sub-domains except the outlet pipe. For the seek of a comprehensive analysis, the significant losses were computed for the two impeller geometries. It was observed that the shock losses and swirling losses of the rounded impeller leading edge were lower at part load conditions, but when increasing the discharge, the both losses were lower for the original impeller geometry. The rounded impeller leading edge exhibited as well lower wall frictional losses for the entire operating range of discharge.
RESUMO
Interest of Pump as Turbine (PAT) is growing with diverse applications in engineering. Usually, the data of PATs are not available in the hands of pump manufacturers. Therefore, performance prediction methods appear as an important research area of PATs. The current prediction methods reposed on expensive, inaccurate and time consuming experimental methods. In the scope of this work, a generic and robust prediction method is built up for a centrifugal impeller PAT. The most significant hydraulic losses were derived in PAT mode, these are namely, the shock losses at the impeller inlet, the swirling losses at the impeller outlet and the impeller wall frictional losses. The Euler head, the available total head and the hydraulic efficiency were computed as well. The global efficiency was computed taking into account the machine mechanical and volumetric efficiencies, enabling therefore to perform comparison of the new prediction method with experimental, computational fluid dynamic (CFD), Rossi and Perez performances prediction methods. From where it resulted a good agreement between the given prediction methods for the entire range of operation, confirming the robustness and the applicability of the developed prediction method. The relative difference between the new prediction method and CFD data and between the new prediction method and experimental data remained higher for lower discharge conditions, notably for extreme part load conditions, where a small error could result in very high relative difference.
