Niobium K-Edge X-ray Absorption Spectroscopy of Doped TiO2 Produced from Ilmenite Digested in Hydrochloric Acid.

Niobium doping of TiO2 creates a conductive material with many new energy applications. When TiO2 is precipitated from HCl solutions containing minor Nb, the Nb in solution is quantitatively deposited with the TiO2. Here, we investigate the structure of Nb doped in anatase and rutile produced from ilmenite digested in hydrochloric acid. Nb K-edge X-ray absorption near edge structure (XANES) and extended X-ray absorption fine structure (EXAFS) are used to characterize the environment of 0.08 atom % Nb doped in TiO2. XANES shows clear structural differences between Nb-doped anatase and rutile. EXAFS for Nb demonstrates that Nb occupies a Ti site in TiO2 with no near neighbors of Nb. Hydrolysis of Ti and Nb from acid solution, followed by calcination, leads to a well dispersed doped material, with no segregation of Nb. Production of Nb-doped TiO2 by this method may be able to supply future demand for large quantities of the material and in energy applications where a low cost of production, from readily available natural resources, would be highly desirable.

Synthesis and Structure of Oxygen Deficient Lead-Technetium Pyrochlore, the First Example of a Valence V Technetium Oxide.

The structure of lead-technetium pyrochlore has been refined in space group F d 3 ¯ m with a = 10.36584(2) Å using a combination of synchrotron X-ray and neutron powder diffraction data and confirmed via Electron Diffraction. The oxide is found to be oxygen deficient with a stoichiometry of Pb2Tc2O7-d. Displacive disorder of the Pb cations is evident from the refinements, as has been observed in Bi2Tc2O7-d. X-ray absorption spectroscopic measurements at the Tc K-edge demonstrate the valence of the Tc is greater than 4.0 as anticipated from the refined oxygen stoichiometry. Raman spectroscopy confirms the presence of disorder leading us to conclude that this pyrochlore is the first example of a valence V technetium oxide.

A new ammine dual-cation (Li, Mg) borohydride: synthesis, structure, and dehydrogenation enhancement.

A new ammine dual-cation borohydride, LiMg(BH(4))(3)(NH(3))(2), has been successfully synthesized simply by ball-milling of Mg(BH(4))(2) and LiBH(4)·NH(3). Structure analysis of the synthesized LiMg(BH(4))(3)(NH(3))(2) revealed that it crystallized in the space group P6(3) (no. 173) with lattice parameters of a=b=8.0002(1) Å, c=8.4276(1) Å, α=ß=90°, and γ=120° at 50 °C. A three-dimensional architecture is built up through corner-connecting BH(4) units. Strong N-H···H-B dihydrogen bonds exist between the NH(3) and BH(4) units, enabling LiMg(BH(4))(3)(NH(3))(2) to undergo dehydrogenation at a much lower temperature. Dehydrogenation studies have revealed that the LiMg(BH(4))(3)(NH(3))(2)/LiBH(4) composite is able to release over 8 wt% hydrogen below 200 °C, which is comparable to that released by Mg(BH(4))(3)(NH(3))(2). More importantly, it was found that release of the byproduct NH(3) in this system can be completely suppressed by adjusting the ratio of Mg(BH(4))(2) and LiBH(4)·NH(3). This chemical control route highlights a potential method for modifying the dehydrogenation properties of other ammine borohydride systems.

A temperature-dependent order-disorder and crystallographic phase transition in a 0D Fe(II) spin crossover compound and its non-spin crossover Co(II) isomorph.

The new dipyridylamino/triazine ligand DDE (N(2),N(2),N(4),N(4)-tetraethyl-N(6),N(6)-di(pyridin-2-yl)-1,3,5-triazine-2,4,6-triamine) has been incorporated into the mononuclear Fe(II) SCO compounds cis-[Fe(II)(NCSe)(2)(DDE)(2)] (1), cis-[Fe(II)(NCBH(3))(2)(DDE)(2)] (2), and cis-[Fe(II)(NCS)(2)(DDE)(2)] (3). Magnetic susceptibility measurements reveal that each of 1, 2 and 3 undergoes a complete, continuous spin transition with a T(½) of ∼260 K, ∼300 K and ∼205 K, respectively. An analogue and isomorph of 1, cis-[Co(II)(NCSe)(2)(DDE)(2)] (4), remains high spin down to low temperatures. Variable temperature single crystal data reveal that 1 and 4 undergo a crystallographic phase transition (from orthorhombic Pbcn at high temperatures to monoclinic P2/c at low temperatures) accompanied by an order-disorder transition of ethyl moieties of the DDE ligand. In the Pbcn phase, the structures of 1 and 4 contain one crystallographically unique M(II) centre, while in the P2/c phase, 1 and 4 contain two crystallographically unique M(II) centres. Variable temperature powder X-ray diffraction experiments reveal that the crystallographic phase transition occurs at ∼250 K for 1. The occurrence of the concomitant order-disorder and crystallographic phase transitions undergone by 1 and 4 is not directly apparent in their magnetic susceptibility measurements, and this is likely due to the local environment of the M(II) centres remaining largely undisturbed as the transitions occur. The compound 2 is isostructural to 1 and 4 at low temperatures.

Structural phase transitions and magnetic order in SrTcO3.

The structure of the perovskite SrTcO(3) has been investigated using both synchrotron X-ray and neutron powder diffraction. At room temperature SrTcO(3) is orthorhombic as a consequence of cooperative tilting of the corner sharing TcO(6) octahedra. The tilts are sequentially removed as the sample is heated with the oxide displaying the sequence of structres Pnma→Imma→I4/mcm→Pm ̅3m. Neutron powder diffraction data collected in the temperature range 4-1023 K indicate that SrTcO(3) has G-type antiferromagnetic structure, in which each Tc moment is antiparallel to its six nearest neighbours, below ∼1000 K. The magnetic structure is collinear antiferromagnetic with the technetium moments parallel to c-axis and can be described by the propagation vector k = [0,0,0] and the basis vector (0,0,A(z)). The same magnetic structure is observed in each of the four crystal structures.

Antiferromagnetism in a technetium oxide. Structure of CaTcO3.

The technetium perovskite CaTcO(3) has been synthesized. Combining synchrotron X-ray and neutron diffraction, we found that CaTcO(3) is an antiferromagnetic with a surprisingly high Neel temperature of ∼800 K. The transition to the magnetic state does not involve a structural change, but there is obvious magnetostriction. Electronic structure calculations confirm the experimental results.

X-ray pair distribution function analysis of nanostructured materials using a Mythen detector.

Total scattering from nanocrystalline materials recorded on the Australian Synchrotron powder diffraction beamline has been analysed to produce atomic pair distribution functions (PDFs) for structural analysis. The capability of this beamline, which uses the massively parallel Mythen II detector, has been quantified with respect to PDF structure analysis. Data were recorded to a wavevector magnitude, Q, of 20.5 A(-1), with successful PDFs obtained for counting times as short as 10 s for crystalline LaB(6) and 180 s for nanocrystalline (47 A) anatase. This paper describes the aspects of a PDF experiment that are crucial to its success, with reference to the outcomes of analysis of data collected from nanocrystalline TiO(2) and microcrystalline LaB(6) and IrO(2).

A flow cell for in situ synchrotron x-ray diffraction studies of scale formation under Bayer processing conditions.

The design, construction, and commissioning of a stainless steel flow cell for in situ synchrotron x-ray diffraction studies of scale formation under Bayer processing conditions is described. The use of the cell is demonstrated by a study of Al(OH)(3) scale formation on a mild steel substrate from synthetic Bayer liquor at 70 degrees C. The cell design allows for interchangeable parts and substrates and would be suitable for the study of scale formation in other industrial processes.

Metal ion-dependent molecular inclusion chemistry: inclusion of aromatic anions by coordinated 1,4,7,10-tetrakis((S)-2-hydroxy-3-phenoxypropyl)-1,4,7,10-tetraazacyclododecane.

The ability of the pendant donor macrocyclic ligand 1,4,7,10-tetrakis((S)-2-hydroxy-3-phenoxypropyl)-1,4,7,10-tetraaza- cyclododecane((S)-thphpc12) (or [Cd((S)-thphpc12)](2+)) to act as a metal ion-dependent receptor for aromatic anions has been investigated in solution and in the solid state. [Cd((S)-thphpc12)](2+) adopts a stable conical conformation with a large hydrophobic cavity, which has been shown to contain, via complementary multiple hydrogen bonding, p-nitrophenolate, aromatic carboxylates, p-toluenesulfonate, certain aromatic amino acid anions, phenoxyacetate, and acetate. In the case of p-nitrophenolate only, one or two anions can be contained within the receptor cavity. The crystal structure of [Cd((S)-thphpc12)(p-nitrophenolate)(2)] shows a coplanar arrangement of the p-nitrophenolates, where each is retained in the cavity by a pair of hydrogen bonds to cis hydroxyl groups. The crystal structure of the p-aminobenzoate inclusion complex indicates retention of the guest via a pair of hydrogen bonds to each oxygen atom of the carboxylate moiety. The crystal structure of the (L)-phenylalaninate inclusion complex indicates that the amino acid is retained by five hydrogen bonds, two involving the nitrogen atom and three to the oxygen atoms of the carboxylate moiety. Binding constants (10(3)-10(5) M(-1)) for the inclusion of some of the aforementioned anions in [Cd((S)-thphpc12)](2+) and related receptors were measured by (1)H NMR titration in DMSO-d(6) at 298 K.

Metal Ion Dependent Molecular Inclusion Chemistry: Inclusion of p-Toluenesulfonate and p-Nitrophenolate within the Structure of Coordinated 1,4,7,10-Tetrakis((S)-2-hydroxy-3-phenoxypropyl)-1,4,7,10-tetraazacyclododecane.

The pendant donor macrocyclic ligand 1,4,7,10-tetrakis((S)-2-hydroxy-3-phenoxypropyl)-1,4,7,10-tetraazacyclododecane ((S)-thphpc12) has been synthesized in quantitative yield from cyclen (1,4,7,10-tetraazacyclododecane) and (2S)-(+)-3-phenoxy-1,2-epoxypropane. An X-ray diffraction study supports the result of molecular orbital calculations in showing that complexation with hydrated cadmium(II) diperchlorate produces an approximately square-antiprismatic complex in which the metal ion is located between a plane containing the four nitrogen atoms and a plane containing the four oxygen atoms. As a consequence of this the four phenoxymethyl moieties, each attached to one of the four N-O chelate rings, juxtapose to form a substantial empty cavity allowing the complex to act as a molecular receptor. Inclusion complexes have been formed from this complex in which either a p-toluenesulfonate or p-nitrophenolate anion has entered the cavity. An X-ray crystallographic study of [Cd((S)-thphpc12)(p-toluenesulfonate)]ClO(4) shows that the guest anion is retained within the cavity by four hydrogen bonds to the group of hydroxyl moieties associated with the ligand. (13)C NMR and conductivity studies indicate that this inclusion complex retains its integrity in DMSO or DMF solution. Parallel studies have been conducted with [Pb((S)-thphpc12)](ClO(4))(2) indicating that the corresponding inclusion complexes are of lower stability.