30 TW and 33 fs pulses delivered by a Ti:Sa amplifier system seeded with a frequency-doubled fiber laser.

We report a full experimental comparison study on the injection of a Ti:Sa multi-terawatt amplifier chain with a standard 15 fs Ti:Sa oscillator and 35 fs frequency-doubled fiber oscillator. The study highlights that the Ti:Sa oscillator, with high performance in terms of pulse duration and spectral width, can be replaced by the frequency-doubled fiber oscillator to seed Ti:Sa amplifier chains almost without any compromise on the output pulse duration and picosecond contrast. Finally, we demonstrate for the first time to our knowledge a 30 TW and 33 fs Ti:Sa amplifier injected by a fiber oscillator.

Large-mode-area optical fiber for photonic nanojet generation.

The photonic nanojet (PNJ) generated by a shaped optical fiber tip is an attractive technology for laser micro-machining. The working distance has the same order of size as the fiber core diameter; therefore, multimode (MM) fibers are generally preferred. However, the PNJ is due to the fundamental mode and, therefore, the energy coupled on the high-order modes does not contribute to the process. We demonstrate the benefit of a large-mode-area (LMA) optical fiber in the generation of the PNJ. A homemade 40 µm mode field diameter LMA fiber is compared with a 100/140 MM-shaped fiber tip. Similar micro-peaks are obtained, and an energy gain is demonstrated. The coupled energy required was eight times less intense with the LMA fiber, which may open new possibilities for laser micro- and nano-processing.

Extreme large mode area in single-mode pixelated Bragg fiber.

This paper reports the design and the fabrication of an all-solid photonic bandgap fiber with core diameter larger than 100 µm, a record effective mode area of about 3700 µm2 at 1035 nm and robust single-mode behavior on propagation length as short as 90 cm. These properties are obtained by using a pixelated Bragg fiber geometry together with an heterostructuration of the cladding and the appropriated generalized half wave stack condition applied to the first three higher order modes. We detail the numerical study that permitted to select the most efficient cladding geometry and present the experimental results that validate our approach.

Design and realization of flexible very large mode area pixelated Bragg fibers.

A new Pixelated Bragg Fiber design showing improved optical performances in terms of single-mode behavior and effective area is presented. The cladding is made of 3 rings of cylindrical high refractive index rods (pixels) in which some pixels are removed to act as a modal sieve for an improved rejection of Higher Order Modes (HOMs). Two half-wave-stack conditions are used to increase the confinement losses of the 3 first HOMs: LP11 and LP02-LP21 guided core modes. The realized fiber exhibits a core diameter of 48.5 µm with an effective single-mode behavior observed from 1000 nm to beyond 1700 nm even for a 1-m-long straight fiber. Losses prove to be low with a minimum value of 25 dB/km between 1200 and 1500 nm. Bending radius of 22.5 cm is reported for this structure without any significant extra-losses above a wavelength of 1350 nm.