Calibration Method of Measuring Heads for Testing Residual Stresses in Sheet Metal Using the Barkhausen Method.

ABSTRACT

Among non-destructive testing methods, a group dedicated to the assessment of the state of residual stresses can be distinguished. The method of measuring residual stresses using the Barkhausen noise method has many advantages, as evidenced by the number of publications. The residual stresses in metal products are important for the further processing of such metal, such as laser cutting or bending. The results presented in this work are of an experimental nature, and the presented method of calibration of measuring heads shows how various research techniques can be used to correlate results. The research was carried out for structural steel due to the market share of this type of steel. The method can be used to measure the residual stresses in ferromagnetic metal products in order to assess their directions and quantify them. A prerequisite for the use of this measurement method is that the amplitude and geometry of the Barkhausen noise are adequately correlated to the specific values of the state of stress depending on the tested steel grade or other metals. In this study, a method for calibrating measuring sensors for the residual stress measurements is presented, as developed by the authors. The method involved conducting bending tests in both numerical modeling and experimental tests. During the bending tests, changes in the magnetic field (Barkhausen noise waveform) were recorded, taking into account the state of elastic stresses. Correlating the results of the numerical calculations and Barkhausen noise measurements made it possible to determine the quantitative values of the residual stresses in the steel sheets. Thanks to the method used, very accurate measurement is possible, and the obtained results are repeatable.