Fast determination of the relative elemental and organic carbon content of aerosol samples by on-line single-particle aerosol time-of-flight mass spectrometry.

Different particulate matter (PM) samples were investigated by on-line single-particle aerosol time-of-flight mass spectrometry (ATOFMS). The samples consist of soot particulates made by a diffusion flame soot generator (combustion aerosol standard, CAST), industrially produced soot material (printex), soot from a diesel passenger car as well as ambient particulates (urban dust (NIST) and road tunnel dust). Five different CAST soot particle samples were generated with different elemental carbon (EC) and organic carbon (OC) content. The samples were reaerosolized and on-line analyzed by ATOFMS, as well as precipitated on quartz filters for conventional EC/OC analysis. For each sample ca. 1000 ATOFMS single-particle mass spectra were recorded and averaged. A typical averaged soot ATOFMS mass spectrum shows characteristic carbon cluster peak progressions (Cn+) as well as hydrogen-poor carbon cluster peaks (CnH(1-3)+). These peaks are originated predominately from the elemental carbon (EC) content of the particles. Often additional peaks, which are not due to carbon clusters, are observed, which either are originated from organic compounds (OC-organic carbon), or from the non-carbonaceous inorganic content of the particles. By classification of the mass spectral peaks as elemental carbon (i.e., the carbon cluster progression peaks) or as peaks originated from organic compounds (i.e., molecular and fragment ions), the relative abundance of elemental (EC) and organic carbon (OC) can be determined. The dimensionless TC/EC values, i.e., the ratio of total carbon content (TC, TC = OC + EC) to elemental carbon (EC), were derived from the ATOFMS single-particle aerosol mass spectrometry data. The EC/TC values measured by ATOFMS were compared with the TC/EC values determined by the thermal standard techniques (thermooptical and thermocoulometric method). A good agreement between the EC/TC values obtained by on-line ATOFMS and the offline standard method was found.

Oxidant denuder sampling for analysis of polycyclic aromatic hydrocarbons and their oxygenated derivates in ambient aerosol: evaluation of sampling artefact.

The concentrations of some polycyclic aromatic hydrocarbons (PAH) and oxygenated PAH (O-PAH) can be changed by oxidation reactions during sampling. This can lead to an over- or underestimation of the corresponding adverse health effects. The aim of this study was the evaluation of these sampling artefacts. The potential of using an oxidant denuder was shown by parallel low-volume sampling with and without MnO(2) ozone denuder. Twenty-three PAH and 11 O-PAH in ambient air were analysed, both in the vapour and particulate phase. The denuder was proven to be highly efficient for stripping ozone from air while causing no significant particle losses. In general, the concentrations of 5- to 7-ring PAH, which are predominantly associated with particles, were underestimated in non-denuded samples. The highest losses due to reaction with ozone and other atmospheric oxidants were observed for benzo[a]pyrene and perylene. Concurrently, the concentrations of most of the mainly particle-associated 4- to 5-ring O-PAH were higher in the non-denuded samples. The denuder did not only remove ozone, moreover other gaseous species such as more volatile PAH and O-PAH were partially oxidized on the catalytic surface, too. Degradation of PAH and concurrent degradation/formation reactions of O-PAH occurred. The corresponding reactivities of selected PAH and O-PAH are discussed.

Application of infrared laser desorption vacuum-UV single-photon ionization mass spectrometry for analysis of organic compounds from particulate matter filter samples.

A new built instrument suitable for laser desorption-single photon ionization time-of-flight mass spectrometry (LD-SPI-TOFMS) with use of Vacuum-UV photons with a wavelength of 118 nm was used for the analysis of organic compounds. Fragmentation-free analysis of a variety of substances was achieved for desorption experiments with pure compounds desorbed from quartz glass filters applying low desorption energies. It was further found that the rate of fragmentation is strongly dependent on the desorption energy. Matrix effects were investigated by desorption experiments utilizing soot spiked with several organic compounds.The characteristics of the desorption process are assessed in more detail and the impact on the analysis of ambient particulate matter (PM) samples on filters are discussed. First results obtained from the application of the technique to the analysis of organic compounds from ambient PM are presented. Furthermore, possibilities of future developments of the method, in particular for analysis of ambient PM, are discussed.

On-line analysis of gas-phase composition in the combustion chamber and particle emission characteristics during combustion of wood and waste in a small batch reactor.

The emission of particulate matter and gaseous compounds during combustion of wood and refuse-derived fuel in a small batch reactor is investigated by laser mass-spectrometric on-line measurement techniques for gas-phase analysis and simultaneous registration of physical aerosol properties (number size distribution). The gas-phase composition is addressed by a laser-based mass spectrometric method, namely, vacuum-UV single-photon ionization time-of-flight mass spectrometry (VUV-SPI-TOFMS). Particle-size distributions are measured with a scanning mobility particle sizer. Furthermore, a photoelectric aerosol sensor is applied for detection of particle-bound polycyclic aromatic hydrocarbons. The different phases of wood combustion are distinguishable by both the chemical profiles of gas-phase components (e.g., polycyclic aromatic hydrocarbons, PAH) and the particle-size distribution. Furthermore, short disturbances of the combustion process due to air supply shortages are investigated regarding their effect on particle-size distribution and gas-phase composition, respectively. It is shown that the combustion conditions strongly influence the particle-size distribution as well as on the emission of particle-bound polycyclic aromatic hydrocarbons.

Discrimination of three tobacco types (Burley, Virginia and Oriental) by pyrolysis single-photon ionisation-time-of-flight mass spectrometry and advanced statistical methods.

Pyrolysis single-photon ionisation (SPI)-time-of-flight mass spectrometry (TOFMS) and statistical analysis techniques have been applied to differentiate three major tobacco types, Burley, Virginia and Oriental, by means of the gas phase. SPI is known as a soft ionisation technique that allows fast and comprehensive on-line monitoring of a large variety of aliphatic and aromatic substances without fragmentation of the molecule ions. The tobacco samples were pyrolysed at 800 degrees C in a nitrogen atmosphere. The resulting pyrolysis gas contained signals from more than 70 masses between m/z 5 and 170. Mass spectra obtained were analysed by principal component analysis (PCA) and linear discriminant analysis (LDA) to distinguish between different tobacco types. Prior variable reduction of the data set was carried out by calculation of the Fisher ratios. Results achieved give information about chemical composition and characteristics of the smoke derived from each tobacco type and enable conclusions on plant cultivation to be drawn. Based on LDA, a model for tobacco type recognition of unknown samples was established, which was cross-checked by additional measurements of each tobacco type. Furthermore, first results on the recognition of tobacco mixtures based on principal component regression (PCR) are presented.

Comprehensive on-line characterization of complex gas mixtures by quasi-simultaneous resonance-enhanced multiphoton ionization, vacuum-UV single-photon ionization, and electron impact ionization in a time-of-flight mass spectrometer: setup and instrument characterization.

This paper reports on a newly developed mobile mass spectrometer for comprehensive on-line analysis of complex gas mixtures such as ambient air or industrial process gases. Three ionization methods, namely, the resonance-enhanced multiphoton ionization (REMPI), vacuum-ultraviolet single-photon ionization (SPI), and electron impact ionization (EI) are implemented in this instrument and can be operated (quasi-) simultaneously. By means of this setup, a wide range of compounds can be analyzed due to the unique ionization selectivitiy and sensitivity profiles provided by the different ionization techniques. The mass spectrometer is designed for field application even under severe conditions. The REMPI technique is suitable for the selective and soft ionization (without fragmentation) of aromatic compounds at trace level (ppbv/pptv). The also soft but less selective SPI technique with 118-nm vacuum-ultraviolet laser pulses is used as a second laser-based ionization method. Mass spectra obtained by this technique show profiles of most organic compounds (aliphatic and aromatic species) and of some low IP inorganic substances (e.g., ammonia, nitrogen oxide) down to ppbv concentrations. In addition to the laser-based ionization techniques, EI ionization can be used for analysis of the bulk components such as water, oxygen, nitrogen, and carbon dioxide as well as for detection of inorganic minor components such as HCN or HCl from combustion flue gases at ppmv concentration levels. Each method yields specific mass spectrometric information of the sample composition. Special techniques have been developed to combine the three ionization methods in a single mass spectrometer and to allow the quasi-parallel application of all three ionization techniques.

Application of single-particle laser desorption/ionization time-of-flight mass spectrometry for detection of polycyclic aromatic hydrocarbons from soot particles originating from an industrial combustion process.

Combustion-related soot particles were sampled in situ from the stoker system of a 0.5 MW incineration pilot plant (feeding material was wood) at two different heights over the feed bed in the third air supply zone. The collected particles were re-aerosolized by a powder-dispersing unit and analyzed by a single-particle laser desorption/ionization (LDI) time-of-flight mass spectrometer (aerosol-time-of-flight mass spectrometry, ATOFMS). The ATOFMS instrument characterizes particles according to their aerodynamic size (laser velocimetry) and chemical composition (LDI mass spectrometry). Chemical species from the particles are laser desorbed/ionized by 266 nm Nd:YAG laser pulses. ATOFMS results on individual 'real world' particles in general give information on the bulk inorganic composition. Organic compounds, which are of much lower concentrations, commonly are not detectable. However, recent off-line laser microprobe mass spectrometric (LMMS) experiments on bulk soot aerosol samples have emphasized that organic compounds can be desorbed and ionized without fragmentation in LDI experiments from black carbonaceous matrices. This paper reports the successful transfer of the off-line results to on-line analysis of airborne soot particles by ATOFMS. The detection of polycyclic aromatic hydrocarbons from soot particles is addressed in detail. The results are interpreted in the context of the recent LMMS results. Furthermore, their relevance with respect to possible applications in on-line monitoring of combustion processes is discussed.