ABSTRACT
Four-wheeled walkers or rollators are often used to assist older individuals in maintaining an independent life by compensating for muscle weakness and reduced movement stability. However, limited biomechanical studies have been performed to understand how rollator support affects posture and stability, especially when standing up and sitting down. Therefore, this study examined how stability and posture change with varying levels of rollator support and on an unstable floor. The aim was to collect comprehensive baseline data during standing up and sitting down in young participants. In this study, 20 able-bodied, young participants stood up and sat down both 1) unassisted and assisted using a custom-made robot rollator simulator under 2) full support and 3) touch support. Unassisted and assisted performances were analyzed on normal and unstable floors using balance pads with a compliant surface under each foot. Using 3D motion capturing and two ground-embedded force plates, we compared assistive support and floor conditions for movement duration, the relative timing of seat-off, movement stability (center of pressure (COP) path length and sway area), and posture after standing up (lower body sagittal joint angles) using ANOVA analysis. The relative event of seat-off was earliest under full support compared to touch and unassisted conditions under normal but not under unstable floor conditions. The duration of standing up and sitting down did not differ between support conditions on normal or unstable floors. COP path length and sway area during both standing up and sitting down were lowest under full support regardless of both floor conditions. Hip and knee joints were least flexed under full support, with no differences between touch and unassisted in both floor conditions. Hence, full rollator support led to increased movement stability, while not slowing down the movement, during both standing up and sitting down. During standing up, the full support led to an earlier seat-off and a more upright standing posture when reaching a stable stance. These results indicate that rollator support when handles are correctly aligned does not lead to the detrimental movement alterations of increased forward-leaning. Future research aims to verify these findings in older persons with stability and muscle weakness deficiencies.
ABSTRACT
This study compared overground walking with and without exosuit assistance in post-stroke patients. Exosuit-assisted walking was found to improve paretic propulsion and ground clearance during swing, two common gait deviations in stroke patients. No changes in leg muscle activity was found, motivating further study of the exosuit as a tool for gait training during stroke rehabilitation.
Subject(s)
Robotics , Stroke Rehabilitation , Stroke , Ankle , Humans , Muscle, Skeletal , Stroke/complications , Walking/physiologyABSTRACT
BACKGROUND AND PURPOSE: To support clinical decision-making in central neurological disorders, a physical examination is used to assess responses to passive muscle stretch. However, what exactly is being assessed is expressed and interpreted in different ways. A clear diagnostic framework is lacking. Therefore, the aim was to arrive at unambiguous terminology about the concepts and measurement around pathophysiological neuromuscular response to passive muscle stretch. METHODS: During two consensus meetings, 37 experts from 12 European countries filled online questionnaires based on a Delphi approach, followed by plenary discussion after rounds. Consensus was reached for agreement ≥75%. RESULTS: The term hyper-resistance should be used to describe the phenomenon of impaired neuromuscular response during passive stretch, instead of for example 'spasticity' or 'hypertonia'. From there, it is essential to distinguish non-neural (tissue-related) from neural (central nervous system related) contributions to hyper-resistance. Tissue contributions are elasticity, viscosity and muscle shortening. Neural contributions are velocity dependent stretch hyperreflexia and non-velocity dependent involuntary background activation. The term 'spasticity' should only be used next to stretch hyperreflexia, and 'stiffness' next to passive tissue contributions. When joint angle, moment and electromyography are recorded, components of hyper-resistance within the framework can be quantitatively assessed. CONCLUSIONS: A conceptual framework of pathophysiological responses to passive muscle stretch is defined. This framework can be used in clinical assessment of hyper-resistance and will improve communication between clinicians. Components within the framework are defined by objective parameters from instrumented assessment. These parameters need experimental validation in order to develop treatment algorithms based on the aetiology of the clinical phenomena.
Subject(s)
Neurologic Examination , Neuromuscular Diseases/diagnosis , Consensus , Decision Support Systems, Clinical , Delphi Technique , Electromyography , Europe , Humans , Muscle Spasticity/diagnosis , Muscle Spasticity/physiopathology , Muscle, Skeletal/physiopathology , Neuromuscular Diseases/physiopathology , Terminology as TopicABSTRACT
Calibration of instrumented treadmills is imperative for accurate measurement of ground reaction forces and center of pressure (COP). A protocol using an instrumented pole has been shown to considerably increase force and COP accuracy. This study examined how this protocol can be further optimized to maximize accuracy, by varying the measurement time and number of spots, using nonlinear approaches to calculate the calibration matrix and by correcting for potential inhomogeneity in the distribution of COP errors across the treadmill's surface. The accuracy increased with addition of spots and correction for the inhomogeneous distribution across the belt surface, decreased with reduction of measurement time, and did not improve by including nonlinear terms. Most of these methods improved the overall accuracy only to a limited extent, suggesting that the maximal accuracy is approached given the treadmill's inherent mechanical limitations. However, both correction for position dependence of the accuracy as well as its optimization within the walking area are found to be valuable additions to the standard calibration process.
Subject(s)
Exercise Test/instrumentation , Calibration , Nonlinear Dynamics , Time FactorsABSTRACT
Instrumented treadmills are becoming more common in gait analysis. Due to their large and compliant structure, errors in force measurements are expected to be higher compared with conventional force plates. There is, however, no consistency in the literature on testing the performance of these treadmills. Therefore, we propose a standard protocol to assess and report error sources in instrumented treadmills. The first part of this protocol consists of assessment of the accuracy of forces and center of pressure (COP), including non-linearity, hysteresis and crosstalk. The second part consists of (novel) instrumented resonance testing and belt speed variability tests. The third part focuses on measurement variability over time, including drift, warming of the system and noise. The performance of two in-house instrumented treadmills with different dynamics was measured. Differences were found between the treadmills in COP accuracy (4.0 mm versus 6.5 mm), lowest eigen frequency (35 Hz versus 23 Hz) and noise level at 5 km/h (10 N versus 29 N). The loaded treadmills both showed a 3.3% belt speed variability at 5 km/h. Thus, the protocol was able to characterize strong and weak characteristics of the treadmills and allowed for a proper judgement on the validity of the instruments and their application in the domain of gait analysis. We propose to use this protocol when testing and reporting the performance of instrumented treadmills.
Subject(s)
Exercise Test/instrumentation , Physical Therapy Modalities/instrumentation , Biomechanical Phenomena , Calibration , Gait , Humans , Nonlinear Dynamics , PressureABSTRACT
Treadmill walking aims to simulate overground walking, but intra-stride belt speed variations of treadmills result in some interaction between treadmill and subject, possibly obstructing this aim. Especially in self-paced treadmill walking, in which the belt speed constantly adjusts to the subject, these interactions might affect the gait pattern significantly. The aim of this study was to quantify the energy exchange between subject and treadmill, during the fixed speed (FS) and self-paced (SP) modes of treadmill walking. Eighteen subjects walked on a dual-belt instrumented treadmill at both modes. The energy exchange was calculated as the integration of the product of the belt speed deviation and the fore-aft ground reaction force over the stride cycle. The total positive energy exchange was 0.44 J/stride and the negative exchange was 0.11 J/stride, which was both less than 1.6% of the performed work on the center of mass. Energy was mainly exchanged from subject to treadmill during both the braking and propulsive phase of gait. The two treadmill modes showed a similar pattern of energy exchange, with a slightly increased energy exchange during the braking phase of SP walking. It is concluded that treadmill walking is only mildly disturbed by subject-belt interactions when using instrumented treadmills with adequate belt control.
Subject(s)
Exercise Test/instrumentation , Gait/physiology , Mechanical Phenomena , Walking/physiology , Adult , Biomechanical Phenomena , Female , Humans , Male , Motion , Stress, Mechanical , Young AdultABSTRACT
Differences in gait between overground and treadmill walking are suggested to result from imposed treadmill speed and lack of visual flow. To counteract this effect, feedback-controlled treadmills that allow the subject to control the belt speed along with an immersive virtual reality (VR) have recently been developed. We studied the effect of adding a VR during both fixed speed (FS) and self-paced (SP) treadmill walking. Nineteen subjects walked on a dual-belt instrumented treadmill with a simple endless road projected on a 180° circular screen. A main effect of VR was found for hip flexion offset, peak hip extension, peak knee extension moment, knee flexion moment gain and ankle power during push off. A consistent interaction effect between VR and treadmill mode was found for 12 out of 30 parameters, although the differences were small and did not exceed 50% of the within subject stride variance. At FS, the VR seemed to slightly improve the walking pattern towards overground walking, with for example a 6.5mm increase in stride length. At SP, gait became slightly more cautious by adding a VR, with a 9.1mm decrease in stride length. Irrespective of treadmill mode, subjects rated walking with the VR as more similar to overground walking. In the context of clinical gait analysis, the effects of VR are too small to be relevant and are outweighed by the gains of adding a VR, such as a more stimulating experience and possibility of augmenting it by real-time feedback.
Subject(s)
Lower Extremity/physiology , User-Computer Interface , Walking/physiology , Adult , Biomechanical Phenomena , Computer Simulation , Exercise Test , Female , Humans , Male , Range of Motion, Articular/physiologyABSTRACT
Instrumented treadmills are increasingly used in gait research, although the imposed walking speed is suggested to affect gait performance. A feedback-controlled treadmill that allows subjects to walk at their preferred speed, i.e. functioning in a self-paced (SP) mode, might be an attractive alternative, but could disturb gait through accelerations of the belt. We compared SP with fixed speed (FS) treadmill walking, and also considered various feedback modes. Nineteen healthy subjects walked on a dual-belt instrumented treadmill. Spatio-temporal, kinematic and kinetic gait parameters were derived from both the average stride patterns and stride-to-stride variability. For 15 out of 70 parameters significant differences were found between SP and FS. These differences were smaller than 1cm, 1°, 0.2 Nm and 0.2 W/kg for respectively stride length and width, joint kinematics, moments and powers. Since this is well within the normal stride variability, these differences were not considered to be clinically relevant, indicating that SP walking is not notably affected by belt accelerations. The long-term components of walking speed variability increased during SP walking (43%, p<0.01), suggesting that SP allows for more natural stride variability. Differences between SP feedback modes were predominantly found in the timescales of walking speed variability, while the gait pattern was similar between modes. Overall, the lack of clinically significant differences in gait pattern suggests that SP walking is a suitable alternative to fixed speed treadmill walking in gait analysis.