ABSTRACT
Optical refractive-index sensors exploiting selective co-integration of plasmonics with silicon photonics has emerged as an attractive technology for biosensing applications that can unleash unprecedented performance breakthroughs that reaps the benefits of both technologies. However, towards this direction, a major challenge remains their integration using exclusively CMOS-compatible materials. In this context, herein, we demonstrate, for the first time to our knowledge, a CMOS-compatible plasmo-photonic Mach-Zehnder-interferometer (MZI) based on aluminum and Si3N4 waveguides, exhibiting record-high bulk sensitivity of 4764â nm/RIU with clear potential to scale up the bulk sensitivity values by properly engineering the design parameters of the MZI. The proposed sensor is composed of Si3N4 waveguides butt-coupled with an aluminum stripe in one branch to realize the sensing transducer. The reference arm is built by Si3N4 waveguides, incorporating a thermo-optic phase shifter followed by an MZI-based variable optical attenuation stage to maximize extinction ratio up to 38â dB, hence optimizing the overall sensing performance. The proposed sensor exhibits the highest bulk sensitivity among all plasmo-photonic counterparts, while complying with CMOS manufacturing standards, enabling volume manufacturing.
ABSTRACT
We demonstrate a photonic integrated Mach-Zehnder interferometric sensor, utilizing a plasmonic stripe waveguide in the sensing branch and a photonic variable optical attenuator and a phase shifter in the reference arm to optimize the interferometer operation. The plasmonic sensor is used to detect changes in the refractive index of the surrounding medium exploiting the accumulated phase change of the propagating Surface-Plasmon-Polariton (SPP) mode that is fully exposed in an aqueous buffer solution. The variable optical attenuation stage is incorporated in the reference Si3N4 branch, as the means to counter-balance the optical losses introduced by the plasmonic branch and optimize interference at the sensor output. Bulk sensitivity values of 1930 nm/RIU were experimentally measured for a Mach Zehnder Interferometer (MZI) with a Free Spectral Range of 24.8 nm, along with extinction ratio of more than 35 dB, demonstrating the functional benefits of the co-integration of plasmonic and photonic waveguides.
Subject(s)
Biosensing Techniques/methods , Interferometry/methods , Optics and Photonics/methods , Silicon Compounds/chemistry , Electricity , RefractometryABSTRACT
We demonstrate wavelength-division-multiplexed (WDM) 200 Gb/s (8 × 25 Gb/s) data transmission over 100 µm long aluminum (Al) surface-plasmon-polariton (SPP) waveguides on a Si3N4 waveguide platform at telecom wavelengths. The Al SPP waveguide was evaluated in terms of signal integrity by performing bit-error-rate (BER) measurements that revealed error-free operation for all eight 25 Gb/s non-return-to-zero (NRZ) modulated data channels with power penalties not exceeding 0.2 dB at 10-9. To the best of our knowledge, this is the first demonstration of WDM enabled data transmission over complementary-metal-oxide-semiconductor (CMOS) SPP waveguides fueling future development of CMOS compatible plasmo-photonic devices for on-chip optical interconnections.
ABSTRACT
Dielectric loaded surface plasmon waveguides (DLSPPWs) comprised of polymer ridges deposited on top of CMOS compatible metal thin films are investigated at telecom wavelengths. We perform a direct comparison of the properties of copper (Cu), aluminum (Al), titanium nitride (TiN) and gold (Au) based waveguides by implementing the same plasmonic waveguiding configuration for each metal. The DLSPPWs are characterized by leakage radiation microscopy and a fiber-to-fiber configuration mimicking the cut-back method. We introduce the ohmic loss rate (OLR) to analyze quantitatively the properties of the CMOS metal based DLSPPWs relative to the corresponding Au based waveguides. We show that the Cu, Al and TiN based waveguides feature extra ohmic loss compared to Au of 0.027 dB/µm, 0.18 dB/µm and 0.52 dB/µm at 1550nm respectively. The dielectric function of each metal extracted from ellipsometric spectroscopic measurements is used to model the properties of the DLSP-PWs. We find a fairly good agreement between experimental and modeled DLSPPWs properties except for Al featuring a large surface roughness. Finally, we conclude that TiN based waveguides sustaining intermediate effective index (in the range 1.05-1.25) plasmon modes propagate over very short distances restricting the the use of those modes in practical situations.
ABSTRACT
We demonstrate an all-optical, self-synchronization scheme for optical packet switched network nodes. It provides both the packet clock signal and the packet beginning, marker pulse. The circuit uses two hybridly integrated MZI switches and has been evaluated with synchronous, asynchronous and variable length, data packets at 10 Gb/s. It is compact and requires relatively low energies to operate.
ABSTRACT
We present and evaluate a compact, all-optical Clock and Data Recovery (CDR) circuit based on integrated Mach Zehnder interferometric switches. Successful operation for short packet-mode traffic of variable length and phase alignment is demonstrated. The acquired clock signal rises within 2 bits and decays within 15 bits, irrespective of packet length and phase. Error-free operation is demonstrated at 10 Gb/s.