ABSTRACT
Porphyry-type molybdenum deposits, many of which are in China, supply most of the World's molybdenum. Of particular importance are the molybdenum deposits located in the Qinling-Dabie region that are responsible for more than half of China's molybdenum production. A feature that distinguishes this suite of deposits from the better-known Climax and Endako sub-types of porphyry molybdenum deposits is their formation from CO2-rich magmatic-hydrothermal fluids. The role of CO2, if any, in the transport of molybdenum by these fluids, however, is poorly understood. We conducted experiments on the partitioning of molybdenum between H2O-CO2, H2O-NaCl, and H2O-NaCl-CO2 fluids and a felsic melt at 850 °C and 100 and 200 MPa. Here we show that the exsolution of separate (immiscible) brine and vapor leads to the very high brine DMo values needed for efficient extraction of Mo from the magmas forming Dabie-type porphyry molybdenum deposits.
ABSTRACT
The ability to accurately determine the metal content of crude oils is necessary for reasons ranging from the need to identify the source of the oils (Ni and V) to removing components that might inhibit catalysis during refining or impact negatively on the environment during hydrocarbon combustion. Here we show that ashing followed by chemical oxidation and acid digestion, coupled with ICP-MS analysis, provides an accurate method for determining the concentration of metals in crude oil. Nickel and vanadium concentrations were measured in certified Ni and V oil standards and in various light, intermediate and heavy crude oils after application of a single vessel ashing-chemical oxidation-acid digestion sample preparation and storing technique. Prior to the ashing, chemical oxidation and acid digestion, an aliquot of the crude oil was placed in a 10 ml Pyrex™ culture tube and capped with quartz wool. The capped culture tubes were then subjected to thermal combustion, followed by chemical oxidation and leaching. The leachates and the aqueous standards were diluted and analyzed for their Ni and V contents using inductively coupled plasma mass spectrometry (ICP-MS). The measured concentrations of Ni in oil standards, reported to contain 1, 100, and 1000 mg kg-1 Ni (±2% error), were 1.1 ± 0.01, 99.8 ± 1.46, and 1025 ± 24 mg kg-1 respectively. The corresponding concentrations of V in these standards, reported to contain 2, 100, and 1000 mg kg-1 V, were measured to be 1.93 ± 0.06, 104 ± 1.3, and 1027 ± 7.5 mg kg-1, respectively. Crude oil samples, A, B, C, D and E, that varied significantly in their composition, and ranged from light to heavy, were determined to contain 5.59 ± 0.32, 4.05 ± 0.03, 6.22 ± 0.22, 33.8 ± 0.7 and 41.6 ± 3.5 mg kg-1 Ni, respectively. Their V contents were determined to be 11.98 ± 0.1, 12.2 ± 0.1, 16.5 ± 0.4, 34.7 ± 0.4, and 104 ± 8.9 mg kg-1, respectively. The results were thus repeatable on average to 4.1% and 2.75% for Ni and V, respectively; the repeatability was worst (â¼8.5%) for crude oil E, a heavy (viscous) oil with a very high asphaltene content (27.2%). This modified single vessel ashing-digestion technique (combustion, chemical oxidation, acid leaching and storing) minimizes contamination and significantly reduces the loss of ash. Our results are repeatable, comparable to, and in some cases superior to those of other methods. The method is applicable to a wide range of crude oil compositions, is very accessible and robust, easy to use, and does not require costly equipment in preparing the samples for analysis by ICP-MS.
ABSTRACT
Fiber dimension and concentration may vary substantially between two necropsy populations of former chrysotile miners and millers of Thetford-Mines and Asbestos regions. This possibility could explain, at least in part, the higher incidence of respiratory diseases among workers from Thetford-Mines than among workers from the Asbestos region. The authors used a transmission electron microscope, equipped with an x-ray energy-dispersive spectrometer, to analyze lung mineral fibers of 86 subjects from the two mining regions and to classify fiber sizes into three categories. The most consistent difference was the higher concentration of tremolite in lung tissues of workers from Thetford-Mines, compared with workers from the Asbestos region. Amosite and crocidolite were also detected in lung tissues of several workers from the Asbestos region. No consistent and biologically important difference was found for fiber dimension; therefore, fiber dimension does not seem to be a factor that accounts for the difference in incidence of respiratory diseases between the two groups. The greater incidence of respiratory diseases among workers of Thetford-Mines can be explained by the fact that they had greater exposure to fibers than did workers at the Asbestos region. Among the mineral fibers studied, retention of tremolite fibers was most apparent.