ABSTRACT
Using NIST-calibrated solutions of (131)Ba and (131)I in the 5mL NIST ampoule geometry, measurements were made in three NIST-maintained Capintec activity calibrators and the NIST Vinten 671 ionization chamber to evaluate the suitability of using (133)Ba as a calibration surrogate for (131)I. For the Capintec calibrators, the (133)Ba response was a factor of about 300% higher than that of the same amount of (131)I. For the Vinten 671, the Ba-133 response was about 7% higher than that of (131)I. These results demonstrate that (133)Ba is a poor surrogate for (131)I. New calibration factors for these radionuclides in the ampoule geometry for the Vinten 671 and Capintec activity calibrators were also determined.
Subject(s)
Barium Radioisotopes/analysis , Barium Radioisotopes/standards , Calibration/standards , Iodine Radioisotopes/analysis , Iodine Radioisotopes/standards , Radiation Dosimeters/standards , Equipment Design , Equipment Failure Analysis , Reproducibility of Results , Sensitivity and Specificity , United StatesABSTRACT
Several problems concerning (133)Ba activity distribution in a cylindrical source were addressed by measurements with a 47% n-type HPGe detector and by simulation. Within-sample homogeneity was tested using the count rates from normal and from pure sum peaks. The sensitivity of front versus back source measurements to deviations from uniform distribution was studied. In the case of distributions symmetric with respect to the median plane of the source quantities that can provide information on the distribution of the activity were proposed.