RESUMO
This current work expresses numerical simulation of forced turbulent flow convection in a grooved cylinder. Rectangular grooves with a spacing of A = 1, A = 1.1, and A = 1.3, and groove depth to cylinder diameter of e/D = 0.1 and 0.2 were considered. This research concentrates on the effect of groove depth, location of the grooves and CuO nanoparticles on the heat transfer for Reynolds numbers 10000, 12,500, 15,000 and 17,500 in volume fractions of 0, 1, 2, 3 and 4% of nanoparticles. Results show that grooves improve heat transfer. This behavior at a lower A ratio results in a significant Nu number increase so that the highest Nu number occurs for A ratio of 1, 1.1 and 1.3. Increasing e/D ratio, due to increasing the channel section in this area, results in loss of velocity and dissipation of flow momentum, resulting in lower convective heat transfer and lower Nu number. Changing the pitch for e/D = 0.1 results in a 1.1 to 1.6 times increase of Nu number compared with the smooth channel, and for e/D = 0.2 this value is 1.1-1.5 times the smooth channel for similar Re, φ and geometry. Changing groove pitch at e/D = 0.1 results in a 2.1-2.9 times increase in friction factor compared with the smooth channel in similar conditions. For e/D = 0.2, this increase is 1.8-2.8 times the smooth channel. In low Re, the thermal performance is higher than in higher velocities. This is because the grooved channel acts as a smooth channel at high Re, and the average Nu does not have significant growth.