Soft-tissue profile changes in adult patients treated with premolar extractions.

INTRODUCTION: The objective of this study was to identify the soft-tissue profile changes and the potential pretreatment cephalometric parameters that clinicians could use to predict the lip response after premolar extraction treatment in adult patients. METHODS: Pretreatment and posttreatment lateral cephalograms of 75 white patients treated with premolar extractions were analyzed. The following initial cephalometric measurements were recorded: upper and lower lip to E-plane, vermilion thickness, lip length, maxillary and mandibular incisor inclination, and mentolabial and nasolabial angle. Pretreatment and posttreatment radiographs were superimposed using the Björk structural method to record lip retraction and incisor/lip retraction ratio. Pearson correlation and Kruskal-Wallis tests were used to compare lip retraction and incisor/lip retraction ratio with the cephalometric variables. The sample was divided according to different extraction patterns. RESULTS: The mean upper and lower lip retraction values were 1.4 mm and 1.7 mm, respectively. Vermilion thickness showed a negative and statistically significant correlation (P <0.05) with lip retraction and incisor/lip retraction ratio. In addition, the mean incisor/lip retraction ratio was 61% and 98% for the upper and lower thin lip, respectively, whereas the mean incisor/lip retraction ratio was 17% and 44% for the upper and lower thick lip, respectively. The comparison among extraction patterns did not highlight any noticeable difference. CONCLUSIONS: The choice of a specific extraction pattern did not impact lip response. The vermilion thickness was the key factor influencing lip retraction: an increase in this parameter was related to a decrease in lip retraction and vice versa.

Non-compliance treatment in a young adult full-step class II division 2 malocclusion with preadjusted lingual appliance and upper first molars extractions.

This case report describes a complex full-step class II case in a young adult patient treated with lingual straight-wire appliance and upper first molar extraction. As the patient refused a surgical treatment, she was offered the best possible camouflage with the double aim of obtaining an ideal occlusal relationship and maintaining the profile; appropriate biomechanical strategies, including extraction choice and anchorage control during space closure, were needed to achieve the planned results. This case report demonstrates the possibility of successfully resolving severe sagittal discrepancies in an adult patient without surgical treatment by means of a completely invisible non-compliance technique, with the extraction of the most compromised teeth. This report also underlines the need for careful planning during both diagnostic and treatment phases, in order to obtain the best results.

Invisible treatment with lingual appliance for the correction of an adult class II subdivision with asymmetrical Wilson and Spee curves: A case report.

This article describes a class II subdivision malocclusion successfully treated by an invisible lingual appliance. The combination of en-masse distalization by interradicular palatal mini-screws and inner unilateral class II auxiliaries, first by intermaxillary elastic, later by a class II coil spring, resulted in a dento-alveolar correction, allowing one to maintain the appliance completely invisible. At the same time, the inclination of buccal sectors was normalized by a correct torque expression with set-up overcorrections, resulting in a significant improvement of the buccal corridors. This case report demonstrates the possibility of successfully solving class II division 2 subdivision malocclusion in adult patients without surgery by means of a completely invisible appliance. It also demonstrates that correct levelling and torque expression, for the correction of asymmetrical Spee and Wilson curves, are achievable with an accurate set-up planning. On the other hand, it underlines the necessity of mini-screws, auxiliaries and set-up overcorrections in order to obtain the best results.

Profile changes in extraction treatments of upper premolars: A case series.

This case series describes the soft tissue changes following extraction treatment in two patients with diverse lip thickness, but with similar baseline parameters including: labial competence, soft tissue profile, patient's age, extraction protocol, methods of anchorage, malocclusion, crowding, treatment appliance and mechanics. The same treatment plan involved upper first premolar extractions and lingual appliance combined with skeletal anchorage. The lip thickness played a crucial role in these cases, since a similar change of the incisor position leads to a different profile variation. This difference could be explained by the differing initial lip thicknesses as the patient with thin lips showed a more pronounced profilometric change. The choice of the ideal treatment plan must be tailored to the individual patient, taking into account not only initial skeletal and dental factors but also soft tissue factors, as well as the treatment goals.

Torque control with set-up and auxiliary spring in an adult severe class II case treated by lingual straight-wire appliance, premolar extractions and orthognathic surgery.

This case report describes a complex full-step class II high angle case in an adult patient treated with lingual straight-wire appliance, premolar extractions and orthognathic surgery. With the twofold aim of obtaining ideal occlusal relationship and aesthetic improvement, surgical treatment with appropriate biomechanical strategies, including extraction choice and torque control during space closure, are needed to achieve the planned results. This case report demonstrates the possibility of solving successfully severe sagittal, transverse and vertical discrepancies in an adult patient with surgical treatment by means of an invisible technique. This report also underlines the need for precise biomechanical control, including set-up overcorrections and an auxiliary spring to manage teeth inclination, in lingual orthodontics extraction cases.

Non-surgical occlusal plane cant resolution with lingual straight-wire appliance and miniscrews in a class II asymmetric adult patient.

This case report describes a complex class II case with important maxillo-mandibular asymmetry in an adult patient treated with lingual straight-wire appliance. With the twofold aim of obtaining dramatic aesthetic improvement, since the patient refused surgical option, and ideal occlusal relationship, accurate set-up planification and biomechanical strategies with TADS for occlusal plane cant correction are needed to achieve the planned results. This case report demonstrates the possibility of solving successfully class II malocclusion with significant asymmetry in adult patient without surgery by means of an aesthetic appliance; on the other hand, it underlines the necessity of miniscrews and auxiliaries in order to obtain the best results.

Invisible treatment of an asymmetric adult class II malocclusion related to unilateral upper lateral incisor agenesis with a straight wire lingual appliance, mini-screw and premolar extraction: A case report.

This case report describes a complex full-step class II malocclusion with unilateral upper lateral incisor agenesis in an adult patient treated with lingual straight-wire appliance and premolar extraction, with the two-fold aim of obtaining ideal occlusal relationship and smile aesthetic improvement. In view of this, it underlines how an appropriate treatment strategy, including extraction choice and anchorage control during space closure, is needed to achieve the planned results with a completely invisible lingual appliance combined with aesthetic veneers.

Accuracy of planned tooth movement with lingual straight wire technique.

OBJECTIVES: To analyze the accuracy of planned tooth movements of torque, tip, rotations, and transverse width values with lingual straight-wire technique. MATERIALS AND METHODS: 40 Caucasian subjects with mean age of 23.9 years, consecutively treated in private practice with a lingual straight-wire appliance (STb, Ormco, Glendora, Calif) were evaluated. Maxillary and mandibular dental casts were taken before treatment (T0), in the setup (T1), and at the end of treatment (T2) and scanned with an intraoral 3D scanner Carestream CS 3600 (Carestream Dental, Atlanta, GA). Virtual models at the three time points were superimposed on T1 using 3D software, and the coordinates were exported as a set of x, y, and z values. Angular and linear measurements were analyzed to measure torque, tip, rotation movements, and transverse intra-arch widths. Changes among the three time points were analyzed with Friedman's nonparametric test. RESULTS: A general increase in torque was recorded in the setup and in the final result, except for the maxillary molars. Torque, tip, and rotation movement mean accuracy was ≥84% for incisors, canines, and premolars. A general increase in transverse width was measured in the setup and in the final models, except for the upper second molars, which showed reduced transverse width during treatment. CONCLUSIONS: The movements planned in the setup to obtain the ideal torque, tip, and rotations actually occurred, except for second molars, which showed less accuracy. Planned expansion of the arches occurred only partially.

Fluorescence-aided removal of orthodontic composites: an in vivo comparative study.

BACKGROUND: To compare the fluorescent properties of 6 different orthodontic adhesives and provide useful information for clinicians in the adhesion choice, in order to remove it easily at the end of orthodontic treatment by using the Fluorescence-aided Identification Technique (FIT). METHODS: Six orthodontic adhesives were included: Ortho Connect, Gradia LoFlo A3.5, Greengloo, Transbond XT, KommonBase Pink, and KommonBase Clear. The same thermoformed template with 1 mm shell thickness on the six anterior teeth was used for adhesive positioning; furthermore, an ultraviolet light-emitting diode flashlight was used for the FIT. The brightness of adhesive area and tooth area (L* color coordinate) were measured on the photographs by using the "color picker" tool of Photoshop software. RESULTS: GC Ortho Connect, Gradia Direct LoFlo and KommonBase Clear showed the highest differences of brightness (15.5, 16.3 and 13.5, respectively), while Greengloo, Transbond XT and KommonBase Pink registered similar values between resin area and tooth area with FIT (- 0.5, - 0.8 and - 1.0, respectively). The high viscosity adhesive resins, as Greengloo and Transbond XT, showed a similar performance in terms of fluorescence to the KommonBase Pink, the lowest viscous resin adhesive considered. CONCLUSIONS: The most used orthodontic adhesives showed different fluorescence properties. Some resins were brighter with the FIT, facilitating identification and subsequent removal. Other orthodontic adhesives presented no difference between adhesive and tooth. The viscosity of orthodontic adhesives did not influence the brightness emitted with FIT.

Non-surgical adult class II high-angle treatment with an invisible appliance: A case report.

This case report describes the complex situation of a young adult Class II hyperdivergent patient treated by premolar extraction with a straight wire lingual appliance. Despite the patient's refusal to undergo surgical treatment, the dual goals of ideal occlusal relationship and profile improvement were achieved through a well thought-out biomechanical strategy with appropriate extraction choice and anchorage control during space closure. This case report demonstrates the possibility of successfully resolving severe sagittal and vertical discrepancies in an adult patient without surgical treatment using a completely invisible technique. This report also highlights the need for careful planning during the diagnostic and treatment phases.

Fluorescence-aided composite removal during lingual bracket debonding.

OBJECTIVE: This report describes the fluorescence-aided composite removal during lingual bracket debonding with an ultraviolet light emitting diode flashlight. The purpose of this technique is to help clinicians in composite removal without enamel surface damage. CLINICAL CONSIDERATIONS: The bracket debonding requires clinical attention in order to remove all composites and resins without enamel surface damage. Different protocols can be used in order to minimize the enamel damages and the excess bonding remnants. The fluorescence-aided composite removal permits to have an immediate visualization of the composites and adhesives, especially for the uneven lingual surfaces, of which the interindividual morphological variability is greater than the buccal surfaces. CONCLUSIONS: The fluorescence-aided composite removal during lingual brackets debonding minimizes the risks described in literature and it is an easier, more accurate, reliable, noninvasive, inexpensive, and time-saving method. CLINICAL SIGNIFICANCE: The application of this technique allows, with inexpensive flashlights, to remove all the composite on the lingual surfaces during debonding, without damaging the tooth and saving time.

Multiple tumor types including leiomyoma and Wilms tumor in a patient with Gorlin syndrome due to 9q22.3 microdeletion encompassing the PTCH1 and FANC-C loci.

Gorlin syndrome or nevoid basal cell carcinoma syndrome (NBCCS) is an autosomal dominant condition mainly characterized by the development of mandibular keratocysts which often have their onset during the second decade of life and/or multiple basal cell carcinoma (BCC) normally arising during the third decade. Cardiac and ovarian fibromas can be found. Patients with NBCCS develop the childhood brain malignancy medulloblastoma (now often called primitive neuro-ectodermal tumor [PNET]) in 5% of cases. The risk of other malignant neoplasms is not clearly increased, although lymphoma and meningioma can occur in this condition. Wilms tumor has been mentioned in the literature four times. We describe a patient with a 10.9 Mb 9q22.3 deletion spanning 9q22.2 through 9q31.1 that includes the entire codifying sequence of the gene PTCH1, with Wilms tumor, multiple neoplasms (lung, liver, mesenteric, gastric and renal leiomyomas, lung typical carcinoid tumor, adenomatoid tumor of the pleura) and a severe clinical presentation. We propose including leiomyomas among minor criteria of the NBCCS.