Nasal ventilation and rapid maxillary expansion (RME): a randomized trial.

OBJECTIVE: To assess three rapid maxillary expansion (RME) appliances in nasal ventilation. TRIAL DESIGN: Three-arm parallel randomized clinical trial. METHODS: Sixty-six growing subjects (10-16 years old) needing RME as part of their orthodontic treatment were randomly allocated (1:1:1 ratio) to three groups of 22 patients receiving Hyrax (H), Hybrid-Hyrax (HH), or Keles keyless expander (K). The primary outcome of nasal ventilation (pressure and velocity) and secondary outcomes (skeletal, dental, soft tissue, and nasal obstruction changes) were blindly assessed on the initial (T0) and final (T1, 6 months at appliance removal) cone-beam computed tomography (CBCT) data by applying computational fluid dynamics (CFD) method. Differences across groups were assessed with crude and adjusted for baseline values and confounders (gender, age, skeletal maturation, expansion amount, mucosal/adenoid hypertrophy, nasal septum deviation) regression models with alpha = 5%. RESULTS: Fifty-four patients were analysed (19H, 21HH, 14K). RME reduced both nasal pressure (H: -45.8%, HH: -75.5%, K: -63.2%) and velocity (H: -30%, HH: -58.5%, K: -35%) accompanied with nasal obstruction resolution (H: 26%, HH: 62%, K: 50%). Regressions accounting for baseline severity indicated HH expander performing better in terms of post-expansion maximum velocity (P = 0.03) and nasal obstruction resolution (P = 0.04), which was robust to confounders. Mucosal/adenoid hypertrophy and nasal septum deviation changes were variable, minimal, and similar across groups. The HH resulted in significantly greater increase in the nasal cross-sectional area (62.3%), anterior (14.6%), and posterior (10.5%) nasal widths. Nasal obstruction resolution was more probable among younger (P = 0.04), skeletally immature (P = 0.03), and male patients (P = 0.02) without pre-treatment mucosal hypertrophy (P = 0.04), while HH was associated with marginal greater probability for obstruction resolution. CONCLUSIONS: RME resulted in improvement of nasal skeletal parameters and simulated ventilation with the former being in favour of the HH and the latter not showing significant differences among the three appliances. LIMITATION: Attrition in the K group due to blocked activation rods possibly leading to limited sample to identify any existing group differences. HARMS: Replacement of blocked Keles expanders for finalizing treatment. PROTOCOL: The protocol was not published before the trial commencement. REGISTRATION: Australian and New Zealand Clinical Trial Registry; ACTRN12617001136392.

A novel method for treatment of Class III malocclusion in growing patients.

BACKGROUND: Management of Class III malocclusion is one of the most challenging treatments in orthodontics, and several methods have been advocated for treatment of this condition. A new treatment protocol involves the use of an alternating rapid maxillary expansion and constriction (Alt-RAMEC) protocol, in conjunction with full-time Class III elastic wear and coupled with the use of temporary anchorage devices (TADs). The aim of this study was to evaluate the dento-skeletal and profile soft tissue effects of this novel protocol in growing participants with retrognathic maxilla. METHODS: Fourteen growing participants (7 males and 7 females; 12.05 ± 1.09 years), who displayed Class III malocclusions with retrognathic maxilla, were recruited. Pre-treatment records were taken before commencing treatment (T1). All participants had a hybrid mini-implant-supported rapid maxillary expansion (MARME) appliance that was activated by the Alt-RAMEC protocol for 9 weeks. Full-time bone-anchored Class III elastics, delivering 400 g/side, were then used for maxillary protraction. When positive overjet was achieved, protraction was ceased and post-treatment records were taken (T2). Linear and angular cephalometric variables were blindly measured by one investigator and repeated after 1 month. An error measurement (Dahlberg's formula) study was performed to evaluate the intra-examiner reliability. A paired-sample t test (p < 0.05) was used to compare each variable from T1 to T2. RESULTS: Treatment objectives were achieved in all participants within 8.5 weeks of protraction. The maxilla significantly protracted (SNA 1.87°± 1.06°; Vert.T-A 3.29± 1.54 mm p < 0.001), while the mandibular base significantly redirected posteriorly (SNB -2.03° ± 0.85°, Vert.T-B - 3.43± 4.47 mm, p < 0.001 and p < 0.05 respectively), resulting in a significant improvement in the jaw relationship (ANB 3.95°± 0.57°, p < 0.001; Wits 5.15± 1.51 mm, p < 0.001). The Y-axis angle increased significantly (1.95° ± 1.11°, p < 0.001). The upper incisors were significantly proclined (+ 2.98°± 2.71°, p < 0.01), coupled with a significant retroclination of the lower incisors (- 3.2°± 3.4°, p < 0.05). The combined skeletal and dental effects significantly improved the overjet (5.62± 1.36 mm, p < 0.001) and the soft tissue Harmony angle (2.75° ± 1.8°, p < 0.001). CONCLUSIONS: Class III elastics, combined with the Alt-RAMEC activation protocol of the MARPE appliance, is an efficient treatment method for mild/moderate Class III malocclusions. The long-term stability of these changes needs further evaluation.

Computational and clinical investigation on the role of mechanical vibration on orthodontic tooth movement.

The aim of this study is to investigate the biomechanics for orthodontic tooth movement (OTM) subjected to concurrent single-tooth vibration (50Hz) with conventional orthodontic force application, via a clinical study and computational simulation. Thirteen patients were recruited in the clinical study, which involved distal retraction of maxillary canines with 1.5N (150g) force for 12weeks. In a split mouth study, vibration and non-vibration sides were randomly assigned to each subject. Vibration of 50Hz, of approximately 0.2N (20g) of magnitude, was applied on the buccal surface of maxillary canine for the vibration group. A mode-based steady-state dynamic finite element analysis (FEA) was conducted based on an anatomically detailed model, complying with the clinical protocol. Both the amounts of space closure and canine distalization of the vibration group were significantly higher than those of the control group, as measured intra-orally or on models (p<0.05). Therefore it is indicated that a 50Hz and 20g single-tooth vibration can accelerate maxillary canine retraction. The volume-average hydrostatic stress (VHS) in the periodontal ligament (PDL) was computationally calculated to be higher with vibration compared with the control group for maxillary teeth and for both linguo-buccal and mesial-distal directions. An increase in vibratory frequency further amplified the PDL response before reaching a local natural frequency. An amplification of PDL response was also shown to be induced by vibration based on computational simulation. The vibration-enhanced OTM can be described by mild, vigorous and diminishing zones among which the mild zone is considered to be clinically beneficial.

A periodontal ligament driven remodeling algorithm for orthodontic tooth movement.

While orthodontic tooth movement (OTM) gains considerable popularity and clinical success, the roles played by relevant tissues involved, particularly periodontal ligament (PDL), remain an open question in biomechanics. This paper develops a soft-tissue induced external (surface) remodeling procedure in a form of power law formulation by correlating time-dependent simulation in silico with clinical data in vivo (p<0.05), thereby providing a systematic approach for further understanding and prediction of OTM. The biomechanical stimuli, namely hydrostatic stress and displacement vectors experienced in PDL, are proposed to drive tooth movement through an iterative hyperelastic finite element analysis (FEA) procedure. This algorithm was found rather indicative and effective to simulate OTM under different loading conditions, which is of considerable potential to predict therapeutical outcomes and develop a surgical plan for sophisticated orthodontic treatment.

Changes in the physical properties of human premolar cementum after application of 4 weeks of controlled orthodontic forces.

This study was performed to assess the relationship between the magnitude of orthodontic force and physical properties of individual human cementum, and to identify the sites that may be predisposed to root resorption. The findings may assist in relating physical properties of dental root cementum and its susceptibility to root resorption. Sixteen maxillary first premolar teeth were selected in eight orthodontic patients (three males and five females), mean age 14.8 years (range 11.2-17.5 years), requiring first premolar extractions. In each patient, a light orthodontic force of 25 cN was applied buccally using a sectional archwire on the first premolar on one side, while a heavy force of 225 cN was applied to the contralateral side. The teeth were extracted 4 weeks after initial force application. Hardness and elastic modulus were measured on the buccal and the lingual surfaces of the cementum at the cervical, middle, and apical third of the root. The results showed that the mean hardness and elastic modulus of cementum in the light force group were greater than in the heavy force group at all positions. There were highly significant differences in both hardness and elastic modulus between the heavy and light force groups (P < 0.01). The mean hardness and elastic modulus of cementum gradually decreased from the cervical to the apical regions for buccal as well as lingual surfaces in both groups. There was, however, an insignificant difference between hardness and elastic modulus on the buccal surface compared with the lingual surface (P < 0.05). It was concluded that the hardness and elastic modulus of cementum were affected by the application of orthodontics forces.

Teenage luxation injury: report of case.

The endodontic, restorative, and orthodontic treatment sequence of the accidental injury of three maxillary incisors has been presented. The treatment objective was to achieve an esthetically acceptable result for a young adult, until a definitive fixed prosthetic restoration can be planned. The ankylosed maxillary right permanent central incisor (11) is being maintained for reasons of arch-length space and alveolar bone height.