RESUMO
TiO2-Kaolinite nanocomposite photocatalysts were synthesized using the sol-gel method, with titanium isopropoxide/HCl as reactants and Jordanian kaolinite clay as a support material. The samples' TiO2 content ranged from 10% to 70% (m/m). TiO2-Kaolinite composites were characterized using FTIR, SEM, XRF, and XRD. According to XRD measurements of the nano-composite samples, the intensity of the anatase peaks increased as the TiO2 percentage of the composition increased. As the percentage of TiO2 increased, so did the peaks of Ti-O-Si in FTIR. The extent of photocatalytic degradation of Congo-red dye was used to evaluate the photocatalytic activity of the prepared nanocomposites. After four hours under the sun, the percentage of Congo-red degradation ranged from 27 to 99 percent depending on the TiO2 content of the used nanocomposite. Meanwhile, the concentration drop in the dark did not exceed 10%. Photodegradation outperforms traditional treatment methods in terms of target degradation. Using naturally abundant materials such as clay in conjunction with metal oxides is widely regarded as an effective method of modifying the photoresponse properties of TiO2 particles, thereby improving solar light harvesting for target degradation.
RESUMO
The concentrations and chemical distributions of heavy metals (Cd, Cr, Ni, Zn, U, and V) in the Al-Jiza phosphate ores were investigated. Typically, the mean concentration values of Cd, Cr, Ni, U, and Zn are 15 ± 8, 109 ± 21, 34 ± 6, 211 ± 55, 142 ± 55, and 161 ± 57 mg kg(-1), respectively. On the other hand, the encountered average concentration values of Cd, Cr, Ni, Zn, U, and V in the phosphate dust particles (<0.053) were found to be 22 ± 5, 179 ± 5, 67 ± 11, 441 ± 14, 225 ± 58, and 311 ± 9 mg kg(-1), respectively. The contamination factors of U and Cr are greater than 1, indicating that these heavy metals could be potentially hazardous, if released to the environment. Multivariate statistical analysis allowed the identification of three main factors controlling the distribution of these heavy metals and the other chemical constituents. The extracted factors are as follows: francolite mineral factor, clay minerals factor, and diagenesis factor. Health risk assessments of non-cancerous effects in finer-grained size fraction that might be caused by contamination with the heavy elements have been calculated for both children and adults. The risk assessments in case of children for non-cancerous effects showed that U has values greater than the safe level of hazard index (HI = 1). In case of adults, the value of risk for U is also higher as compared to those of Cd, Ni, Cr, and Zn where it lies within the safe range of hazard index (HI < 1). Child health risk assessment indicates that children are more vulnerable to contaminants from phosphate mining than adults.