RESUMO
Fluorescence resonance energy transfer (FRET) is a highly useful tool to investigate biomolecular interactions and dynamics in single-molecule spectroscopy and nanoscopy. However, the use of spectrally overlapping dye pairs results in various artifact signals that prevent accurate determination of FRET values. In this paper, an algorithmic method of spectral unmixing was devised to extract FRET values of spectrally overlapping dye pairs at the single molecule level. Application of this method allows the determination of both the donor-acceptor composition and the FRET efficiency of the samples labelled with spectrally overlapping dye pairs.
RESUMO
Rendering a high crystalline perovskite film is integral to achieve superior performance of perovskite solar cells (PSCs). Here, we established a two-dimensional liquid cage annealing system, a unique methodology for remarkable enhancement in perovskite crystallinity. During thermal annealing for crystallization, wet-perovskite films were suffocated by perfluorodecalin with distinctively low polarity, nontoxic, and chemically inert characteristics. This annealing strategy facilitated enlargement of perovskite grain and diminution in the number of trap states. The simulation results, annealing time, and temperature experiments supported that the prolonged diffusion length of precursor ions attributed to the increase of perovskite grains. Consequently, without any complicated handling, the performance of perovskite photovoltaics was remarkably improved, and the monolithic grains which directly connected the lower and upper electrode attenuated hysteresis.
RESUMO
By incorporating STED (stimulated emission depletion) nanoscopy into single-molecule spectroscopy, we demonstrate that the concentration limit imposed by optical diffraction can be overcome in diffusion-based single-molecule measurement. We showed that single-molecule detection is feasible at a concentration of 5 nM, which is 100-times higher than the limit of conventional single-molecule measurements.
RESUMO
Previously, we reported a method for facile purification of oligonucleotides labeled with hydrophobic dyes, based on the solubility difference between the hydrophilic DNA and unreacted dye. Here, we present a new purification method applicable to any dye regardless of its hydrophobicity. We exploited the population shift of a fluorescent dye in a low-pH aqueous solution from its anionic form toward its neutral form. When the pH of an aqueous solution containing dye-labeled DNA and unreacted free dye is lowered, and the solution is mixed with a hydrophobic organic solvent (butanol), the neutral free dye is preferentially dissolved in the organic phase, leaving behind the hydrophilic dye-labeled DNA in the aqueous phase. We experimentally verified that our new method results in high yields of dye-labeled oligonucleotides and the efficient removal of free dye.
Assuntos
Carbocianinas/isolamento & purificação , DNA/isolamento & purificação , Corantes Fluorescentes/isolamento & purificação , Oligonucleotídeos/isolamento & purificação , Precipitação Química , Cromatografia Líquida de Alta Pressão , Concentração de Íons de Hidrogênio , Interações Hidrofóbicas e Hidrofílicas , Transição de Fase , Solubilidade , Soluções , Água/químicaRESUMO
The power conversion efficiency (PCE) of perovskite solar cells (PSCs) has now exceeded 20%; thus, research focus has shifted to establishing the foundations for commercialization. One of the pivotal themes is to curtail the overall fabrication time, to reduce unit cost, and mass-produce PSCs. Additionally, energy dissipation during the thermal annealing (TA) stage must be minimized by realizing a genuine low-temperature (LT) process. Here, tin oxide (SnO2 ) thin films (TFs) are formulated at extremely high speed, within 5 min, under an almost room-temperature environment (<50 °C), using atmospheric Ar/O2 plasma energy (P-SnO2 ) and are applied as an electron transport layer of a "n-i-p"-type planar PSC. Compared with a thermally annealed SnO2 TF (T-SnO2 ), the P-SnO2 TF yields a more even surface but also outstanding electrical conductivity with higher electron mobility and a lower number of charge trap sites, consequently achieving a superior PCE of 19.56% in P-SnO2 -based PSCs. These findings motivate the use of a plasma strategy to fabricate various metal oxide TFs using the sol-gel route.
RESUMO
Electrostatic effects on the redox photochemistry of synthetic probes (1, 2, and 1-Zn) are examined by adjusting the thermodynamic driving force of their oxidation reactions. The redox photochemistry was simply controlled by introducing a zinc binding site (2,2'-dipicolylamine (DPA)) on the coumarin moiety of probe 2. Zinc complexation produced a positively charged environment on the coumarin (1-Zn), which lowered the electron density of a nearby 9 H-xanthene ring, attenuating the auto-oxidation of 1-Zn by 45 % compared with that of probe 1 at 298â K. The positive net charge of 1-Zn also provided an attractive Coulombic force toward the phosphate of flavin mononucleotide and flavin adenine dinucleotide, which lowered the reduction potential of the electron acceptor (isoalloxazine) and improved intermolecular electron transfer from the 9 H-xanthene ring to isoalloxazine. The flavin-mediated oxidation rate of 1-Zn was increased to 1.5â times that of probe 2. Probe 1-Zn showed highly selective sensing behaviour toward flavins, producing an intense brightness (ϵΦF =2.80×103 m-1 â cm-1 ) in the long-wavelength regions (λmax =588â nm) upon flavin-mediated oxidation. Furthermore, probes 1-Zn and 2 were successfully applied to eosinophil imaging and the differential diagnosis of eosinophilia; this demonstrates their use as diagnostic tools.