InP integrated optical frequency comb generator using an amplified recirculating loop.

A novel realisation of photonically integrated optical frequency comb generation is demonstrated on indium phosphide (InP) using a generic foundry platform. The architecture, based on the amplified recirculating loop technique, consists of cascaded electro-optic phase modulators embedded within a short waveguide loop. While an injected continuous wave laser signal is recirculated by the loop, the modulators are driven with a modulation frequency corresponding to the round-trip loop length frequency. This results in many phase coherent, evenly spaced optical comb lines being generated. The choice of InP as an integration platform allows immediate optical amplification of the modulated signal by embedded semiconductor optical amplifiers, enabling loop losses to be compensated and expanding the comb across broad optical bandwidths. This approach reduces the requirement for external, high-power optical amplifiers, improving the compactness and power efficiency of the full system. The system was modelled to identify off-resonance behaviour, outlining limits in matching both the modulation frequency and seed laser frequency to the round-trip loop frequency for optimal comb line generation to be achieved. The experimental device occupied a fraction of the 6 x 2 mm2 InP chip and operated at round-trip loop frequencies of 6.71 GHz to produce 59 comb lines within a 20 dB power envelope. All comb lines exhibited strong phase coherence as characterised by low composite phase noise measurements of -105 dBc/Hz at 100 kHz. A second device is also presented with a shorter loop length operating at ∼10 GHz which generated 57 comb lines. Both loop configurations included short waveguide phase shifters providing a degree of tunability of the free spectral range with a tuning range of 150 MHz for small injection currents of < 2.5 mA.

Photonically-driven Schottky diode based 0.3 THz heterodyne receiver.

Photonics-based technologies are key players in a number of emerging applications in the terahertz (THz) field. These solutions exploit the well-known advantages of optical devices, such as ultra-wide tuneability and direct integration with fiber networks. However, THz receivers are mainly implemented by fully electronic solutions, where Schottky barrier diodes (SBD) are the preferred option as detectors and mixers due to their excellent response within the THz range at room temperature, and technological maturity. Here, we demonstrate an SBD-based subharmonic mixer (SHM) at 300 GHz pumped with a photonic local oscillator. The Schottky mixer is a prototype designed and manufactured by ACST GmbH, operating at 270-320 GHz. The local oscillator is generated by photomixing on a high-frequency and high-power uni-travelling-carrier photodiode (UTC-PD), providing enough power to saturate conversion loss. Minimum single-side-band conversion loss of 14.4 dB and a peak dynamic range of 130 dB have been measured. Finally, as a proof of concept we realize an all-photonics-based 5 Gbps wireless bridge, utilizing the optically-pumped SBD mixer. With this work, we prove the feasibility of high-performance hybrid Schottky-photonic THz receivers, incorporating the best of both worlds.

5 Gbps wireless transmission link with an optically pumped uni-traveling carrier photodiode mixer at the receiver.

We report the first demonstration of a uni-traveling carrier photodiode (UTC-PD) used as a 5 Gbps wireless receiver. In this experiment, a 35.1 GHz carrier was electrically modulated with 5 Gbps non-return with zero on-off keying (NRZ-OOK) data and transmitted wirelessly over a distance of 1.3 m. At the receiver, a UTC-PD was used as an optically pumped mixer (OPM) to down-convert the received radio frequency (RF) signal to an intermediate frequency (IF) of 11.7 GHz, before it was down-converted to the baseband using an electronic mixer. The recovered data show a clear eye diagram, and a bit error rate (BER) of less than 10-8 was measured. The conversion loss of the UTC-PD optoelectronic mixer has been measured at 22 dB. The frequency of the local oscillator (LO) used for the UTC-PD is defined by the frequency spacing between the two optical tones, which can be broadly tuneable offering the frequency agility of this photodiode-based receiver.

Foundry fabricated photonic integrated circuit optical phase lock loop.

This paper describes the first foundry-based InP photonic integrated circuit (PIC) designed to work within a heterodyne optical phase locked loop (OPLL). The PIC and an external electronic circuit were used to phase-lock a single-line semiconductor laser diode to an incoming reference laser, with tuneable frequency offset from 4 GHz to 12 GHz. The PIC contains 33 active and passive components monolithically integrated on a single chip, fully demonstrating the capability of a generic foundry PIC fabrication model. The electronic part of the OPLL consists of commercially available RF components. This semi-packaged system stabilizes the phase and frequency of the integrated laser so that an absolute frequency, high-purity heterodyne signal can be generated when the OPLL is in operation, with phase noise lower than -100 dBc/Hz at 10 kHz offset from the carrier. This is the lowest phase noise level ever demonstrated by monolithically integrated OPLLs.

Photonic generation for multichannel THz wireless communication.

We experimentally demonstrate photonic generation of a multichannel THz wireless signal at carrier frequency 200 GHz, with data rate up to 75 Gbps in QPSK modulation format, using an optical heterodyne technique and digital coherent detection. BER measurements were carried out for three subcarriers each modulated with 5 Gbaud QPSK or for two subcarriers modulated with 10 Gbaud QPSK, giving a total speed of 30 Gbps or 40 Gbps, respectively. The system evaluation was also performed with three subcarriers modulated with 12.5 Gbaud QPSK (75 Gbps total) without and with 40 km fibre transmission. The proposed system enhances the capacity of high-speed THz wireless transmission by using spectrally efficient modulated subcarriers spaced at the baud rate. This approach increases the overall transmission capacity and reduces the bandwidth requirement for electronic devices.

Optical injection locking of monolithically integrated photonic source for generation of high purity signals above 100 GHz.

A monolithically integrated photonic source for tuneable mm-wave signal generation has been fabricated. The source consists of 14 active components, i.e. semiconductor lasers, amplifiers and photodetectors, all integrated on a 3 mm(2) InP chip. Heterodyne signals in the range between 85 GHz and 120 GHz with up to -10 dBm output power have been successfully generated. By optically injection locking the integrated lasers to an external optical comb source, high-spectral-purity signals at frequencies >100 GHz have been generated, with phase noise spectral density below -90 dBc/Hz being achieved at offsets from the carrier greater than 10 kHz.

Coherent terahertz photonics.

We present a review of recent developments in THz coherent systems based on photonic local oscillators. We show that such techniques can enable the creation of highly coherent, thus highly sensitive, systems for frequencies ranging from 100 GHz to 5 THz, within an energy efficient integrated platform. We suggest that such systems could enable the THz spectrum to realize its full applications potential. To demonstrate how photonics-enabled THz systems can be realized, we review the performance of key components, show recent demonstrations of integrated platforms, and give examples of applications.