Simultaneous determination of rutin and ascorbic acid in a sequential injection lab-at-valve system.

A green, simple, accurate and highly sensitive sequential injection lab-at-valve procedure has been developed for the simultaneous determination of ascorbic acid (Asc) and rutin using 18-molybdo-2-phosphate Wells-Dawson heteropoly anion (18-MPA). The method is based on the dependence of the reaction rate between 18-MPA and reducing agents on the solution pH. Only Asc is capable of interacting with 18-MPA at pH 4.7, while at pH 7.4 the reaction with both Asc and rutin proceeds simultaneously. In order to improve the precision and sensitivity of the analysis, to minimize reagent consumption and to remove the Schlieren effect, the manifold for the sequential injection analysis was supplemented with external reaction chamber, and the reaction mixture was segmented. By the reduction of 18-MPA with reducing agents one- and two-electron heteropoly blues are formed. The fraction of one-electron heteropoly blue increases at low concentrations of the reducer. Measurement of the absorbance at a wavelength corresponding to the isobestic point allows strictly linear calibration graphs to be obtained. The calibration curves were linear in the concentration ranges of 0.3-24mgL-1 and 0.2-14mgL-1 with detection limits of 0.13mgL-1 and 0.09mgL-1 for rutin and Asc, respectively. The determination of rutin was possible in the presence of up to a 20-fold molar excess of Asc. The method was applied to the determination of Asc and rutin in ascorutin tablets with acceptable accuracy and precision (1-2%).

Highly sensitive sequential injection determination of p-aminophenol in paracetamol formulations with 18-molybdodiphosphate heteropoly anion based on elimination of Schlieren effect.

A highly sensitive, precise and automated method using sequential injection analysis to assay quantitatively low levels of the p-aminophenol (PAP) in paracetamol formulations has been developed. A solution containing PAP and paracetamol is injected into an acetate buffer carrier stream and merged on-line with 18-molybdodiphosphate heteropoly complex reagent to form a specific blue derivative that is subsequently detected spectrophotometrically at 820nm. The procedure has been optimized mainly with respect to measurement sensitivity. It is based on the leveling off of the refraction indices of the liquids mixed in the flow system by the careful matching of the refractive index of the reagent solution with that of the carrier and sample solutions. Amount as low as 0.5µmolL(-1) of PAP, which corresponds to the 0.001% of PAP in paracetamol tablets, can be reliably determined using the proposed method, which is clearly below the specification limits recommended for PAP determination in paracetamol drug and tablet formulations (50ppm or 0.005% (w/w)). The developed method was successfully applied to the analysis of paracetamol formulations spiked with PAP and determination of PAP content in Rapidol tablets past their expiration date both by proposed SIA and reference HPLC methods.

Sequential injection determination of orthophosphate as ion associate of 12-molybdophosphate with Astra Phloxine.

A simple and fast reaction between 12-molybdophosphate heteropoly anion and the polymethine dye Astra Phloxine was used for the development of a new SIA method for the determination of orthophosphate. The suggested method has higher sensitivity and a broader calibration range than existing SIA methods. It can be used to detect phosphate in the range from 0.2 to 10 µmol L(-1) with a detection limit of 0.1 µmol L(-1) and an acceptable throughput of 20 samples h(-1). The comparably low molybdate (5.6 mmol L(-1)) and dye (0.1 mmol L(-1)) concentrations led to an improvement in the stability of the base line. Inter-day reproducibility was better than 5%, while the intra-day RSD was in the range 0.8-3.5%. The method was used for the analysis of natural water samples and phosphorus-containing chemicals having a low content of orthophosphate.

11-Molybdobismuthophosphate--a new reagent for the determination of ascorbic acid in batch and sequential injection systems.

The guanidinium salt of the new heteropolymolybdate 11-molybdobismuthophosphate Gua(6)PBiMo(11)O(40) (11-MBP) was synthesized, characterized and used as a reagent for batch spectrophotometric (SP) and sequential injection determination of ascorbic acid (AsA). When compared to other Keggin's heteropolyanions, the reduction of 11-MBP with AsA is both fast and maximal within a pH range of 1.6-2.0. The stoichiometry of the reaction was determined using molar ratio and continuous variation methods and was shown to be 1:1. The molar absorptivity of the reduced form of 11-MBP was 6.0 x 10(3)L mol(-1)cm(-1) at 720 nm. The reaction is also specific for AsA. Only cysteine, hydroquinone and hydroxyacids were found to interfere with the reaction, while no interference was observed with the common reducing agents, including reducing sugars, catecholamines, nitrite, sulfite and iron(II) ions. Batch SP and sequential injection analysis (SIA) systems were developed for the determination of AsA, with calibration ranges of the SP methods at 2x10(-6)-8 x 10(-5)M for a 10mm cell and 5 x 10(-7)-3 x 10(-5)M for a 50mm cell and a limit of detection at 3 x 10(-7)M. The linear range of the SIA method was 6 x 10(-6)-5 x 10(-4)M, with a detection limit of 2 x 10(-6)M and a sample throughput of 15 h(-1). The proposed methods were successfully used for the determination of AsA in both pharmaceuticals and fruit juices, and the results were consistent with those provided by the 2,6-dichlorophenolindophenol method.

Investigation of 2-[(E)-2-(4-diethylaminophenyl)-1-ethenyl]-1,3,3-trimethyl-3H-indolium as a new highly sensitive reagent for the spectrophotometric determination of nitrophenols.

A new, simple, rapid, and sensitive spectrophotometric method has been developed for the determination of nitrophenols [picric acid (PA); dinitrophenols (DNP)] in wastewater samples. The method is based on the reaction of nitrophenols with 2-[(E)-2-(4-diethylaminophenyl)-1-ethenyl]-1,3,3-trimethyl-3 H-indolium chloride reagent to form the colored ion associates, which are extracted by organic solvents. The molar absorptivity of the ion associates of PA with the investigated reagent ranges from 8.3x10(4) to 11.3 x 10(4) L mol(-1) cm(-1), depending on the extractant. Because only PA is extracted in an acidic medium with the investigated reagent, but both PA and DNP are extracted in an alkaline medium, it is possible to determine both substances in a mixture. Appropriate reaction conditions have been established. The absorbance of the colored extracts obeys Beer's law in the range of 0.04-4.58 mg L(-1) PA, 1.0-18.4 mg L(-1) 2,4-DNP and 1.2-14.7 mg L(-1) 2,6-DNP, respectively. The limit of detections, calculated from a blank test (n=10; P=0.95), are 0.05 mg L(-1) PA, 0.9 mg L(-1) (2,4-DNP), and 1.1 mg L(-1) (2,6-DNP), respectively.