RESUMO
Photonic integrated circuits have the potential to pervade into multiple applications traditionally limited to bulk optics. Of particular interest for new applications are ferroelectrics such as Lithium Niobate, which exhibit a large Pockels effect, but are difficult to process via dry etching. Here we demonstrate that diamond-like carbon (DLC) is a superior material for the manufacturing of photonic integrated circuits based on ferroelectrics, specifically LiNbO3. Using DLC as a hard mask, we demonstrate the fabrication of deeply etched, tightly confining, low loss waveguides with losses as low as 4 dB/m. In contrast to widely employed ridge waveguides, this approach benefits from a more than one order of magnitude higher area integration density while maintaining efficient electro-optical modulation, low loss, and offering a route for efficient optical fiber interfaces. As a proof of concept, we demonstrate a III-V/LiNbO3 based laser with sub-kHz intrinsic linewidth and tuning rate of 0.7 PHz/s with excellent linearity and CMOS-compatible driving voltage. We also demonstrated a MZM modulator with a 1.73 cm length and a halfwave voltage of 1.94 V.
RESUMO
Stressed nanomechanical resonators are known to have exceptionally high quality factors ( Q) due to the dilution of intrinsic dissipation by stress. Typically, the amount of dissipation dilution and thus the resonator Q is limited by the high mode curvature region near the clamps. Here we study the effect of clamp geometry on the Q of nanobeams made of high-stress Si3N4. We find that tapering the beam near the clamps, thus locally increasing the stress, leads to an increased Q of MHz-frequency low order modes due to enhanced dissipation dilution. Contrary to recent studies of tethered-membrane resonators, we find that widening the clamps leads to a decreased Q despite increased stress in the beam bulk. The tapered-clamping approach has practical advantages compared to the recently developed "soft-clamping" technique, as it enhances the Q of the fundamental mode and can be implemented without increasing the device size.