RESUMO
In this work, Ti-doped Fe2O3 with hollow ellipsoidal capsules nanostructure has been prepared in a green manner using plant extract (flax seed). This new green hematite nanomaterial has been evaluated as photocatalyst for water treatment by testing its activity for degradation of bromophenol blue dye (BPB) and 2,4-dichlorophenoxy acetic acid (2,4-D) herbicide. For a better understanding of the green material properties, a comparison with the pristine Fe2O3 nanospheres previously prepared by the same procedure is included. Structural and optical properties of the green prepared materials are studied. The results revealed the success doping of Ti4+ at Fe3+ site, without forming any of TiO2 phases. It was also found that the Ti doping resulted in the reduction of the band gap of Fe2O3 as well as changing the morphology. The Ti-doped Fe2O3 nanomaterial exhibited an enhanced photocatalytic activity either for BPB dye or for 2,4-D degradation with more than 2 times higher rate than that using pristine Fe2O3.
Assuntos
Herbicidas , Nanoestruturas , Titânio/química , Cápsulas , Catálise , Corantes/química , Azul de Bromofenol , Ácido 2,4-DiclorofenoxiacéticoRESUMO
For the tendency toward cleaner production and safe conversion of undesired toxic wastes to highly priced advanced products, this work introduces new ceramics/glass composites of Cr2O3/Fe2O3/lead silicate glass (LSG) from industrial LSG wastes. Both chromia Cr2O3 and hematite Fe2O3 ceramics are added equally to the LSG wastes with different percentages (10, 20, and 30 wt.%) via the pressureless sintering method. The competitiveness of this work is dependent on the conversion of undesired waste materials into advanced/smart optical materials with a low cost and an environmentally friendly method. Hence, the influence of both Cr2O3 and Fe2O3 additions on the behavior and the different characteristics of the lead silicate wastes are comprehensively investigated. Evaluation of the final ceramics/glass composites was achieved through their phase composition, microstructure, optical, and magnetic characteristics. The results verified that the insertion of both chromia and hematite together into the glass waste had a key role in improving its morphological properties and optical and magnetic behaviors. Composite with 30% of Cr2O3/Fe2O3 gave the highest optical absorbance of 90%, the lowest and best band gap energy of 1.68 ev, and the highest refractive index of 2.85. Also, it recorded the best magnetic behavior with the highest saturation magnetization of 139.700 × 10-2A m2 kg-1 and the best coercivity of 190.0 Oe. These findings confirmed the successful clean conversion of the hazardous lead silicate waste into advanced products with promising optoelectronic characteristics.
Assuntos
Vidro , Resíduos Industriais , Vidro/química , SilicatosRESUMO
Producing new technological materials with high performance from clean sources has become a global requirement. Alumina/aluminum titanate (Al2O3/Al2TiO5) composites are high-temperature portentous materials used in various advanced applications. In this work, different Al2O3/Al2TiO5 composites were obtained with high thermal and mechanical properties for high-temperature applications by a low-cost process. The targeted composites were produced from calcined alumina and, rutile ore extracted from the Egyptian black sands by pressureless sintering at a temperature of 1650 °C/2 h. Rutile was added to alumina with a different content (0-40 wt%) to promote its sinterability and thermo-mechanical response. Evaluation of the produced composites in terms of phase composition, densification, microstructural features, mechanical and thermal properties was investigated. The results indicated that the addition of small amounts of rutile (10 and 20 wt%) succeeded in forming a stable Al2O3/Al2TiO5 composite structure. However, higher content of rutile led to the formation of Al2TiO5 rich matrix composites. Moreover, highly dense composites with harmonic microstructure and enhanced mechanical strength were attained by increasing the rutile content. The composite with only 10 wt% rutile addition gave the highest density of 3.6 g/cm3 and the highest cold crushing strength and modulus of rupture values of 488.73 MPa and 106.19 MPa, respectively. Notably, the addition of rutile has a substantial effect on promoting the thermal properties and thermal stability of the obtained composites up to a high temperature of 1400 °C. The present study shows that addition of rutile ore to alumina is one economical way of improving the densification and thermal expansion of Al2O3 for high temperature applications. Using a clean source such as rutile ore that contains some thermal stabilizers as Fe2O3, Al2O3, SiO2, ZrO2, and MgO instead of pure TiO2 has played a noticeable role in improving the reaction sintering and resulting in a highly qualified material. Thus, sintered Al2O3/Al2TiO5 composites can be considered as a promising high-temperature material for advanced applications.
RESUMO
Nowadays, the disposal of industrial wastes is an ablaze issue worldwide, especially those containing hazardous materials. Lead silicate glass waste (LSG) produced during lead crystal glass manufacturing, which contains about 30% of toxic lead compounds, belongs to this category. This work aims to adopt an innovative clean method to convert this waste into novel advanced ceramic materials via an environmental friendly method. Chromia Cr2O3 and hematite Fe2O3 ceramics with different content (0, 5, 10, 15%) are added separately to the solid wastes of LSG recovered from national crystal glass industry to obtain various ceramics/LSG composites by pressureless sintering methods. Different properties of the produced composites are evaluated in terms of phase's identification and microstructural features. Optical properties in terms of absorbance, reflectance, band gap (Eg), refractive index (n) and photoluminescence (PL) are investigated. Magnetic and electrical properties are inclusively studied. Results indicated that, an addition of chromia and hematite as well as increasing their content to 15% has enhanced the microstructural features, optical, electrical and magnetic properties of the obtained composites. Cr2O3/LSG composites are considered as promising optical and electrical materials. However, Fe2O3/LSG composites showed the highest optical and magnetic properties. They are strongly recommended in optoelectronic and magneto-optical applications.