Influence of emulsifier on lipid oxidation in spray-dried microencapsulated O/W emulsions.

Lipid oxidation limits the shelf-life of dried microencapsulated oils (DMOs), such as infant formula. However, it is poorly understood how lipid oxidation is affected by different types of emulsifiers. To improve our understanding, we prepared DMOs with different emulsifiers (whey protein isolate (WPI), pea protein isolate (PPI), and non-proteinaceous CITREM) and studied lipid oxidation in both the free and encapsulated fat. Only a small difference in oxidation rate was observed between these fat fractions for all formulations. We ascribed this to a non-discrete distribution of the fractions and the subsequent low fractionation selectivity as shown by Raman microscopy. The DMO with PPI showed hardly any oxidation during a 7-week incubation at 40 °C, whereas the DMOs with WPI and CITREM both reached significantly higher contents of oxidation products (lipid hydroperoxides, aldehydes, and epoxides). The enhanced stability of DMO-PPI could not be ascribed to the presence of phytic acid. In conclusion, we demonstrate the potential of using PPI to produce oxidatively stable DMOs.

A mechanistic kinetic model for lipid oxidation in Tween 20-stabilized O/W emulsions.

Models predicting lipid oxidation in oil-in-water (O/W) emulsions are a requirement for developing effective antioxidant solutions. Existing models do, however, not include explicit equations that account for composition and structural features of O/W emulsions. To bridge this gap, a mechanistic kinetic model for lipid oxidation in emulsions is presented, describing the emulsion as a one-dimensional three phase (headspace, water, and oil) system. Variation in oil droplet sizes, overall surface area of oil/water interface, oxidation of emulsifiers, and the presence of catalytic transition metals were accounted for. For adequate predictions, the overall surface area of oil/water interface needs to be determined from the droplet size distribution obtained by dynamic and static light scattering (DLS, SLS). The kinetic model predicted well the formation of oxidation products in both mono- and polydisperse emulsions, with and without presence of catalytic transition metals.

Unravelling the effect of droplet size on lipid oxidation in O/W emulsions by using microfluidics.

Lipid oxidation in emulsions is hypothesised to increase with decreasing droplet size, as this increases the specific oil-water interfacial area, where lipid oxidation is expected to be initiated. In literature, however, contradictory results have been reported, which can be caused by confounding factors such as the oil droplet polydispersity and the distribution of components between the available phases. In this work, monodisperse surfactant-stabilised emulsions with highly controlled droplet sizes of 4.7, 9.1, and 26 µm were produced by microfluidic emulsification. We show that lipid oxidation increases with decreasing droplet size, which we ascribe to the increased contact area between lipids and continuous phase prooxidants. Besides, a significant amount of oxygen was consumed by oxidation of the surfactant itself (Tween 20), an effect that also increased with decreasing droplet size. These insights substantiate the importance of controlling droplet size for improving the oxidative stability of emulsions.

Quantitative assessment of epoxide formation in oil and mayonnaise by 1H-13C HSQC NMR spectroscopy.

Lipid oxidation is detrimental for the quality of oil-based foods. Historically, lipid oxidation research focussed on hydroperoxides and aldehydes, but a third class, the epoxides, have been proposed to resolve observed mechanistic anomalies. Here, we developed a 2D 1H-13C HSQC NMR spectroscopic method to quantify epoxides in food in a reproducible (relative standard deviation ≤11.6 %) and sensitive (LoQ 0.62 mmol/kg oil) manner. Lipid hydroperoxides, aldehydes, and epoxides generated in rapeseed oil and mayonnaise were quantified over time by NMR. Epoxides accounted at most for 10-40 % of the products. They were formed after hydroperoxide accumulation, most likely primarily via alkoxyl radical intermediates, which limits their potential as an early oxidation marker. As 99 % and ∼60 % of the epoxide signal intensities were assigned in a fatty acid and sub-structure specific manner, respectively, our quantitative HSQC method will enable unravelling and quantitative modelling of lipid oxidation mechanisms.

Regioselective C4 and C6 Double Oxidation of Cellulose by Lytic Polysaccharide Monooxygenases.

Lytic polysaccharide monooxygenases (LPMOs) play a key role in enzymatic degradation of hard-to-convert polysaccharides, such as chitin and cellulose. It is widely accepted that LPMOs catalyze a single regioselective oxidation of the C1 or C4 carbon of a glycosidic linkage, after which the destabilized linkage breaks. Here, a series of novel C4/C6 double oxidized cello-oligosaccharides was discovered. Products were characterized, aided by sodium borodeuteride reduction and hydrophilic interaction chromatography coupled to mass spectrometric analysis. The C4/C6 double oxidized products were generated by C4 and C1/C4 oxidizing LPMOs, but not by C1 oxidizing ones. By performing incubation and reduction in H2 18 O, it was confirmed that the C6 gem-diol structure resulted from oxygenation, although oxidation to a C6 aldehyde, followed by hydration to the C6 gem-diol, could not be excluded. These findings can be extended to how the reactive LPMO-cosubstrate complex is positioned towards the substrate.