Determination of Synthetic Cathinones in Urine Using Gas Chromatography-Mass Spectrometry Techniques.

In recent years, the abuse of synthetic cathinones has increased considerably. This study proposes a method, based on gas chromatography/mass spectrometry (GC-MS), to analyze and quantify six synthetic cathinones in urine samples: mephedrone (4-MMC), methylone (bk-MDMA), butylone, ethylone, pentylone and methylenedioxypyrovalerone (MDPV). In our procedure, the urine samples undergo solid-phase extraction (SPE) and derivatization prior to injection into the GC-MS device. Separation is performed using a HP-5MS capillary column. The use of selective ion monitoring (SIM mode) makes it is good sensitivity in this method, and the entire analysis process is within 18 min. In addition, the proposed method maintains linearity in the calibration curve from 50 to 2,000 ng/mL (r(2) > 0.995). The limit of detection of this method is 5 ng/mL, with the exception of MDPV (20 ng/mL); the limit of quantification is 20 ng/mL, with the exception of MDPV (50 ng/mL). In testing, the extraction performance of SPE was between 82.34 and 104.46%. Precision and accuracy results were satisfactory <15%. The proposed method was applied to six real urine samples, one of which was found to contain 4-MMC and bk-MDMA. Our results demonstrate the efficacy of the proposed method in the identification of synthetic cathinones in urine, with regard to the limits of detection and quantification. This method is highly repeatable and accurate.

Effective extraction method through alkaline hydrolysis for the detection of starch maleate in foods.

A high-performance liquid chromatography (HPLC) method was developed for the determination of maleic acid which was released from starch maleate (SM) through the alkaline hydrolysis reaction. The proper alkaline hydrolysis conditions and LC separation are reported in this study. The starch samples were treated with 50% methanol for 30 minutes, and then hydrolyzed by 0.5N KOH for 2 hours to release maleic acid. A C18 column and gradient mobile phase consisting of 0.1% phosphoric acid and methanol at a flow rate of 1.0 mL/minute were used for separation. The method showed a good linearity in the range of 0.01-1.0 ìg/mL, with a limit of quantification (LOQ) at 10 mg/kg in starch. The recoveries in corn starch, noodle, and fish balls were between 93.9% and 108.4%. The relative standard deviation (RSD) of precision was <4.9% (n = 3). This valid method was rapid, sensitive, precise, and suitable for routine monitoring of the illegal adulteration of SM in foods.

Analysis of titanium dioxide and zinc oxide nanoparticles in cosmetics.

There have been rapid increases in consumer products containing nanomaterials, raising concerns over the impact of nanoparticles (NPs) to humankind and the environment, but little information has been published about mineral filters in commercial sunscreens. It is urgent to develop methods to characterize the nanomaterials in products. Titanium dioxide (TiO2) and zinc oxide (ZnO) NPs in unmodified commercial sunscreens were characterized by laser scanning confocal microscopy, atomic force microscopy, X-ray diffraction (XRD), and transmission electron microscopy (TEM). The results showed that laser scanning confocal microscopy evaluated primary particle aggregates and dispersions but could not size NPs because of the diffraction limited resolution of optical microscopy (200 nm). Atomic force microscopy measurements required a pretreatment of the sunscreens or further calibration in phase analysis, but could not provide their elemental composition of commercial sunscreens. While XRD gave particle size and crystal information without a pretreatment of sunscreen, TEM analysis required dilution and dispersion of the commercial sunscreens before imaging. When coupled with energy-dispersive X-ray spectroscopy, TEM afforded particle size information and compositional analysis. XRD characterization of six commercial sunscreens labeled as nanoparticles revealed that three samples contained TiO2 NPs, among which two listed ZnO and TiO2, and displayed average particle sizes of 15 nm, 21 nm, and 78 nm. However, no nanosized ZnO particles were found in any of the samples by XRD. In general, TEM can resolve nanomaterials that exhibit one or more dimensions between 1 nm and 100 nm, allowing the identification of ZnO and TiO2 NPs in all six sunscreens and ZnO/TiO2 mixtures in two of the samples. Overall, the combination of XRD and TEM was suitable for analyzing ZnO and TiO2 NPs in commercial sunscreens.