Improved Dynamic Light Scattering using an adaptive and statistically driven time resolved treatment of correlation data.

Dynamic Light Scattering (DLS) is a ubiquitous and non-invasive measurement for the characterization of nano- and micro-scale particles in dispersion. The sixth power relationship between scattered intensity and particle radius is simultaneously a primary advantage whilst rendering the technique sensitive to unwanted size fractions from unclean lab-ware, dust and aggregated & dynamically aggregating sample, for example. This can make sample preparation iterative, challenging and time consuming and often requires the use of data filtering methods that leave an inaccurate estimate of the steady state size fraction and may provide no knowledge to the user of the presence of the transient fractions. A revolutionary new approach to DLS measurement and data analysis is presented whereby the statistical variance of a series of individually analysed, extremely short sub-measurements is used to classify data as steady-state or transient. Crucially, all sub-measurements are reported, and no data are rejected, providing a precise and accurate measurement of both the steady state and transient size fractions. We demonstrate that this approach deals intrinsically and seamlessly with the transition from a stable dispersion to the partially- and fully-aggregated cases and results in an attendant improvement in DLS precision due to the shorter sub measurement length and the classification process used.

Advances in the measurement of protein mobility using laser Doppler electrophoresis - the diffusion barrier technique.

A new technique for the measurement of protein mobility using laser Doppler electrophoresis (LDE) is introduced and characterised. The diffusion barrier approach loads a tiny protein sample volume into a much larger volume of dispersant, which contains the electrodes; the LDE measurement is then recorded before the sample can diffuse to the electrodes. We demonstrate that sample volumes are reduced by up to two orders of magnitude to volumes typically associated with separation techniques (∼50 µL), no reduction in measurement sensitivity occurs, samples can be retrieved usefully intact, post-measurement and typical measurement times are of the order of minutes. Measurements of BSA mobility up to 75°C and 1 M buffer concentration and lysozyme at a concentration as low as 0.5 mg/mL are demonstrated using the technique with good agreement with literature values.

High-strength nanograined and translucent hydroxyapatite monoliths via continuous hydrothermal synthesis and optimized spark plasma sintering.

The synthesis of high-strength, completely dense nanograined hydroxyapatite (bioceramic) monoliths is a challenge as high temperatures or long sintering times are often required. In this study, nanorods of hydroxyapatite (HA) and calcium-deficient HA (made using a novel continuous hydrothermal flow synthesis method) were consolidated using spark plasma sintering (SPS) up to full theoretical density in ∼5 min at temperatures up to 1000°C. After significant optimization of the SPS heating and loading cycles, fully dense HA discs were obtained which were translucent, suggesting very high densities. Significantly high three-point flexural strength values for such materials (up to 158 MPa) were measured. Freeze-fracturing of disks followed by scanning electron microscopy investigation revealed selected samples possessed sub-200 nm sized grains and no visible pores, suggesting they were fully dense.

Sampling of the telescope image plane using single- and few-mode fibre arrays.

The coupling efficiency of starlight into single and few-mode fibres fed with lenslet arrays to provide a continuous field of view is investigated. The single-mode field of view (FOV) and overall transmission is a highly complicated function of wavelength and fibre size leading to a continuous sample only in cases of poor throughput. Significant improvements are found in the few-mode regime with a continuous and efficient sample of the image plane shown to be possible with as few as 4 modes. This work is of direct relevance to the coupling of celestial light into photonic instrumentation and the removal of image scrambling and reduction of focal ratio degradation (FRD) using multi-mode fibre to single-mode fibre array converters.