Photocatalytic reduction for graphene oxide by PbTiO3 with high polarizability and its electrocatalytic application in pyrrole detection.

Quick recombination of photogenerated electrons and holes in photocatalytic process remains a huge challenge. And the routine efforts are concentrated on heterojunction, metal decoration and surface defect strategies. PbTiO3 as a typical perovskite ferroelectrics is with a strong built-inelectric field as self-junction caused by internal spontaneous polarization, facilitating the charge separation in the photocatalytic process. Here, under UV irradiation, L-shaped PbTiO3 with active (1 1 0) facet as a photocatalyst was applied to photo-reduce graphene oxide (GO), where a specific reduced graphene oxide (rGO)/PbTiO3 composite was synthesized in presence of isopropanol, a hole-trapping agent. According to the linear optical properties, the polarizability of PbTiO3 is calculated to 1.01 × 10-23 cm3 (2.68 times that of P25 (TiO2)), inducing the photo-excited charge separation by PbTiO3. Based on XPS characterization, a TiOC chemical bond is identified on the interface between rGO and PbTiO3. The response peak current for an electrochemical sensor based on rGO/PbTiO3 was proportional to the concentration of pyrrole (6.6 × 10-9-3.1 × 10-7 M, R2 = 0.999), and an extremely low limit reaches to 2.38 × 10-9 M. In addition, polypyrrole during the pyrrole detection was realized by the multi-cycle oxidation process. And also, the electrochemical detection has been successfully applied for the pyrrole quantification in real samples.

Poly (Octadecyl Methacrylate-Co-Trimethylolpropane Trimethacrylate) Monolithic Column for Hydrophobic in-Tube Solid-Phase Microextraction of Chlorophenoxy Acid Herbicides.

Chlorophenoxy acid herbicides (CAHs), which are widely used on cereal crops, have become an important pollution source in grains. In this work, a highly hydrophobic poly (octadecyl methacrylate-co-trimethylolpropane trimethacrylate) [poly (OMA-co-TRIM)] monolithic column has been specially prepared for hydrophobic in-tube solid-phase microextraction (SPME) of CAHs in rice grains. Due to the hydrophobicity of CAHs in acid conditions, trace CAHs could be efficiently extracted by the prepared monolith with strong hydrophobic interaction. Several factors for online hydrophobic in-tube SPME, including the length of the monolithic column, ACN and trifluoroacetic acid percentage in the sampling solution, elution volume, and elution flow rate, were investigated with respect to the extraction efficiencies of CAHs. Under the optimized conditions, the limits of detection of the four CAHs fell in the range of 0.9-2.1 µg/kg. The calibration curves provided a wide linear range of 5-600 µg/kg and showed good linearity. The recoveries of this method ranged from 87.3% to 111.6%, with relative standard deviations less than 7.3%. Using this novel, highly hydrophobic poly (OMA-co-TRIM) monolith as sorbent, a simple and sensitive online in-tube SPME-HPLC method was proposed for analysis of CAHs residue in practical samples of rice grains.