Can the design of the instruments used for undersized osteotomies influence the initial stability of implants installed in low-density bone? An in vitro pilot study.

OBJECTIVES: The aims of this study were to compare the initial implant stability obtained using four different osteotomy techniques in low-density synthetic bone, to evaluate the instrument design in comparison to the implant design, and to determinate a possible correlation between the insertion torque and initial stability quotient (ISQ). MATERIALS AND METHODS: Four groups were identified in accordance with the osteotomy technique used (n = 10 implants per group): group G1, osteotomy using the recommended drilling sequence; group G2, osteotomy using an undersized compactor drill; group G3, osteotomy using an undersized drill; and group G4, osteotomy using universal osseodensification drills. Two polyurethane blocks were used: block 1, with a medullary portion of 10 pounds per cubic foot (PCF 10) and with a 1 mm cortical portion of PCF 40, and block 2, with a medullary of PCF 15 and with a 2 mm cortical portion of PCF 40. Tapered implants of 4 mm in diameter and 11 mm in length were used. The insertion torque (IT) and ISQ were measured. The dimensions of the final instrument used in each group and the dimensions of the implant were used to calculate the total area of each part, and these data were compared. RESULTS: Differences between the four groups were found for IT and ISQ values depending on the technique used for the osteotomy in the two synthetic bone models (p < 0.0001). All groups showed lower values of initial stability in block 1 than in block 2. CONCLUSIONS: Undersized osteotomies with instruments designed according to the implant body significantly increased the initial stability values compared to beds prepared with universal drills and using the drilling sequence standardized by the manufacturer.

Osseodensification Versus Subtractive Drilling Techniques in Bone Healing and Implant Osseointegration: Ex Vivo Histomorphologic/Histomorphometric Analysis in a Low-Density Bone Ovine Model.

PURPOSE: The aim of this study was to qualitatively and quantitatively assess the effect of osteotomy preparation by conventional, subtractive, or osseodensification instrumentation on osteotomies, treated with or without endosteal implants, and healing capacity. MATERIALS AND METHODS: Seven sheep were used, and 56 osteotomies were made in the left and right ilium of the sheep (n = 8/sheep [4 per side/time point (3 and 6 weeks)]). Two different instrumentation techniques were used: (1) conventional/regular drilling in a three-step series of a 2-mm pilot and 3.2-mm and 3.8-mm twist drills and (2) osseodensification drilling with a Densah Bur 2.0-mm pilot and 2.8-mm and 3.8-mm multi-fluted tapered burs. Drilling was performed at 1,100 rpm with saline irrigation. RESULTS: Qualitative histomorphometric evaluation of the osteotomies after 3 and 6 weeks did not indicate any healing impairment due to the instrumentation. In all samples, histologic examination suggested bone remodeling and growth (empty and treated with an implant), irrespective of preparation technique. Osteotomies prepared using the osseodensification instrumentation showed the existence of bone chips autografted into the trabecular spaces along the length of the osteotomy wall. CONCLUSION: The osseodensification group yielded higher osseointegration rates, as distinguished through qualitative assessment, bone-to-implant contact, and bone-area-fraction occupancy, indicating an increased osteogenic potential in osteotomies prepared using the osseodensification technique.