Reduction of dietary crude protein and feed form: Impact on broiler litter quality, ammonia concentrations, excreta composition, performance, welfare, and meat quality.

Nitrogen (N) excreted by poultry is converted to ammonia (NH3), presenting an environmental risk and a health risk to the farmer and animals. A study was performed to investigate the effect of reduced CP and feed form on broiler performance and welfare, meat and litter quality, N utilization, and NH3 concentrations at litter level. A total of 2,232 Ross 308 male broilers was divided into 6 treatments and 6 replicates, which was fed diets in both pellet and mash forms with different CP levels of 205.0 g/kg (H, high), 187.5 g/kg (M, intermediate) and 175.0 g/kg (L, low) in the grower phase and 195.0 g/kg (H), 180.0 g/kg (M) and 165.6 g/kg (L) in the finisher phase. Individual amino acids (AA) were supplemented to maintain digestible AA-to-digestible lysine ratios. Decreasing dietary CP content to 187.5 g/kg in the grower phase and 180.0 g/kg in the finisher phase reduced NH3 concentrations at litter level (P < 0.001), but a further reduction in dietary CP had no additional effect. Mash treatments had better litter qualities and lower incidences of foot and hock lesions than pellet treatments at d 38 (P < 0.001). In addition, treatments with reduced CP had lower incidence of foot lesions at d 38 (P < 0.001). Broilers fed pelleted diets had higher ADFI, ADG, and final BW, improved feed conversion ratio (FCR), and heavier carcasses (P < 0.001) than those fed mash diets over a production period of 39 d. Performance could not be maintained when birds were fed L CP pelleted diets. This study demonstrated that, with the supplementation of AA to meet requirements, the concentration of dietary CP can be reduced to 187.5 and 180.0 g/kg in the grower and finisher phases respectively, without impairing broiler performance, meat yield and quality. Mash diets were favorable when considering the overall litter quality and welfare of the birds. However, they could not maintain the same broiler performance and slaughter yield as pelleted diets. Results from the present study may assist the poultry sector towards a socially acceptable low-emission farming system.

Associations of barn air quality parameters with ultrasonographic lung lesions, airway inflammation and infection in group-housed calves.

Barn climate is believed to play a major role in the bovine respiratory disease complex. However, the exact air quality parameters associated with (sub)clinical pneumonia or airway inflammation in calves are currently unknown. The objective of this cross-sectional study was to assess associations of air quality parameters with clinical signs, lung consolidation, pulmonary inflammation and infection in group-housed calves. In total, 60 beef and dairy farms were visited from January to April 2017 and 428 calves sampled. Measured air quality parameters included continuous 24-h measurements of ammonia concentration, relative humidity and temperature and punctual measurements of air velocity, ammonia, CO2 and bacterial air load. Calf sampling consisted of clinical examination, thoracic ultrasonography and broncho-alveolar lavage sampling for bacteriological and cytological analysis of broncho-alveolar lavage fluid (BALf). Average air temperature was 14.2 °C (standard deviation (SD) 4.4, range 5.5-23.9) and relative humidity 68.8 % (SD 8.9, range 52.2-91.6). Average ammonia concentration was 1.7 ppm (SD 0.9, range 0-10.0). Lung consolidations of ≥1 cm, ≥3 cm and ≥6 cm in depth were present in 41.1 % (176/428), 27.1 % (116/428) and 16.1 % (69/428) of the calves, respectively. Average pen temperature was positively associated with consolidations of ≥1 cm (P = 0.005), ≥3 cm (P = 0.002) and ≥6 cm (P < 0.01). Ammonia exposure, in hours>4 ppm, was associated with lung consolidation ≥1 cm (odds ratio (OR) = 1.73; confidence interval (CI) = 1.02-3.07; P = 0.04). Ammonia concentration was positively associated with BALf epithelial cell percentage (P = 0.01). Air velocity >0.8 m/s was associated with increased odds of lung consolidation of ≥3 cm (OR = 6.8; CI = 1.2-38.5; P = 0.04) and ≥6 cm (OR = 15.9; CI = 1.2-200.0; P = 0.03). The prevalence of lung consolidations ≥1 cm was higher in the draught (81.8 %; P = 0.0092) and warm, dry and ammonia accumulation clusters (54.2 %; P = 0.02) compared to the presumably normal cluster (31.6 %). In addition, in the warm, dry and ammonia cluster the prevalence of lung consolidations ≥3 cm (38.1 %; P = 0.04) and ≥6 cm (31.4 %; P = 0.01) in depth were higher compared to the presumably normal climate cluster (18.2 % and 9.1 %, respectively). Of all frequently measured indoor air quality parameters, only average temperature, ammonia concentration and air velocity were associated with pneumonia and might therefore be preferable for cost-effective evaluation of calf barn climate.

Evaluation of a Cost-Effective Ammonia Monitoring System for Continuous Real-Time Concentration Measurements in a Fattening Pig Barn.

Ammonia (NH3) emission is one of the major environmental issues in livestock farming. Gas measurements are required to study the emission process, to establish emission factors, and to assess the efficiency of emission reduction techniques. However, the current methods for acquiring reference measurements of NH3 are either high in cost or labor intensive. In this study, a cost-effective ammonia monitoring system (AMS) was constructed from a commercially-available gas analyzing module based on tunable diode laser absorption (TDLA) spectroscopy. To cope with the negative measurement biases caused by differing inlet pressures, a set of correction equations was formulated. Field validation of the AMS on NH3 measurement was conducted in a fattening pig barn, where the system was compared to a Fourier-transform infrared (FTIR) spectroscopy analyzer. Under two test conditions in a fattening pig barn, the absolute error of the AMS measurements with respect to the average obtained values between the AMS and the FTIR was respectively 0.66 and 0.08 ppmv, corresponding to 5.9% and 0.5% relative error. Potential sources of the measurement uncertainties in both the AMS and FTIR were discussed. The test results demonstrated that the AMS was capable of performing high-quality measurement with sub-ppm accuracy, making it a promising cost-effective tool for establishing NH3 emission factors and studying NH3 emission processes in pig houses.

Long-term microbial community dynamics at two full-scale biotrickling filters treating pig house exhaust air.

In this study, the microbial community structure of two full-scale biotrickling filters treating exhaust air from a pig housing facility were evaluated using 16S metabarcoding. The effect of inoculation with activated sludge of a nearby domestic waste water treatment plant was investigated, which is a cheap procedure and easy to apply in practice. The study was performed at a three-stage and a two-stage full-scale biotrickling filter; of which, only the latter was inoculated. Both biotrickling filters evolved towards a rather similar community over time, which differed from the one in the activated sludge used for inoculation. However, the bacterial population at both biotrickling filters showed small differences on the family level. A large population of heterotrophic bacteria, including denitrifying bacteria, was present in both biotrickling filters. In the non-inoculated biotrickling filter, nitrite-oxidizing bacteria (NOB) could not be detected, which corresponded with the incomplete nitrification leading to high nitrite accumulation observed in this system. Inoculation with the wide spectrum inoculum activated sludge had in this study a positive effect on the biotrickling filter performance (higher ammonia removal and lower nitrous oxide production). It could thus be beneficial to inoculate biotrickling filters in order to enrich NOB at the start-up, making it easier to keep the free nitrous acid concentration low enough to not be inhibited by it.

Reduction of ammonia emissions from dairy cattle cubicle houses via improved management- or design-based strategies: A modeling approach.

Given the current scarcity of empirical data on ammonia (NH3) emissions from dairy cattle under different management-based mitigation techniques, a modeling approach to assess potential NH3 emission reduction factors is needed. This paper introduces a process-based model that estimates NH3 emission reduction factors for a dairy cattle barn featuring single or multiple management-based NH3 emission mitigation techniques, as compared to another barn, to which no mitigation measure is applied. The model accounts for the following emission mitigation measures: (a) floor scraping, (b) floor type, (c) floor flushing with water and (d) indoor acidification of manure. Model sensitivity analysis indicated that manure acidification was the most efficient NH3 emission reduction technique. A fair agreement was observed between reduction factors from the model and empirical estimates found in the literature. We propose a list of combinations of techniques that achieve the largest reductions. In order of efficiency, they are: (a) floor scraping combined with manure acidification (reduction efficiency 44-49%); (b) solid floor combined with scraping and flushing (reduction efficiency 21-27%); (c) floor scraping combined with flushing and (d) floor scraping alone (reduction efficiency 17-22%). The model is currently being used to advise the Flemish Government (Belgium), on the performance of certain NH3 emission reduction systems for dairy barns in Flanders.

Wind tunnel study of ammonia transfer from a manure pit fitted with a dairy cattle slatted floor.

In dairy cattle systems, most of the feces and urine go to the pit. At the manure pit level, mass transfer of NH3 ([Formula: see text]) has many factors, but practical difficulties hamper a controlled field evaluation. In this study, we propose a methodology for the determination of an alternative, more practical, pit transfer coefficient of NH3 (PTC), and compare it with [Formula: see text] determined from other scientific studies. The aims of this research study were: (1) to develop a wind tunnel set-up which mimics air flow patterns between the slats and above a clean section of a slatted floor section, featuring an aqueous NH3-emitting solution; and (2) to assess how air velocity, turbulence intensity, NH3 concentration ([NH3]) and PTC are influenced by inlet airflow ventilation rate (VR) forced deflection of the air above the slats into the manure pit through varying the deflection angle (DA) of a deflection panel and varying pit headspace height (HH). Main conclusions were: (1) the calculated PTC values presented a good fit to the power function of the air speed near the slats (u) (p < .001) while the average PTC (0.0039 m s(-1)) was comparable to [Formula: see text] values obtained from other studies, by remaining within the range of average values of 0.0015-0.0043 m s(-1); (2) VR and DA significantly impacted [NH3] profiles and PTC (p < .001) and (3) changing slurry pit from 0.10 to 0.90 m HH did not significantly impact [NH3] or PTC (p = .756 and p = .854, respectively).

Exposure levels of farmers and veterinarians to particulate matter and gases during operational tasks in pig-fattening houses.

The main objective of the study was to assess particulate matter (PM) exposure levels for both the farmer and the veterinarian during different operational tasks in pig-fattening houses, and to estimate their exposure levels on a daily working basis (time-weighted average (TWA)). The measured PM fractions were: inhalable and respirable PM, PM10, PM2.5 and PM1. The effects of pig age, pen floor type (conventional or low emission surface) and cleaning of the pens on the personal PM exposure were also investigated. Indoor concentrations of NH3, CH4, and CO2 were additionally measured during some operational tasks. The results showed that personal exposure levels can become extremely high during some operational tasks performed by the farmer or veterinarian. The highest concentration levels were observed during feed shovelling and blood sampling, the lowest during the weighing of the pigs. For the farmer, the estimated TWA exposure levels of inhalable and respirable PM were 6.0 and 0.29 mg m(-3), respectively. These exposure levels for the veterinarian were, respectively, 10.6 and 0.74 mg m(-3). The PM concentration levels were mainly determined by the performed operational tasks. There was no significant effect of pig age, pen floor type, nor cleaning of the pens on the personal exposure levels.

Thermodynamics of greenhouse systems for the northern latitudes: analysis, evaluation and prospects for primary energy saving.

In Flanders and the Netherlands greenhouse production systems produce economically important quantities of vegetables, fruit and ornamentals. Indoor environmental control has resulted in high primary energy use. Until now, the research on saving primary energy in greenhouse systems has been mainly based on analysis of energy balances. However, according to the thermodynamic theory, an analysis based on the concept of exergy (free energy) and energy can result in new insights and primary energy savings. Therefore in this paper, we analyse the exergy and energy of various processes, inputs and outputs of a general greenhouse system. Also a total system analysis is then performed by linking the exergy analysis with a dynamic greenhouse climate growth simulation model. The exergy analysis indicates that some processes ("Sources") lie at the origin of several other processes, both destroying the exergy of primary energy inputs. The exergy destruction of these Sources is caused primarily by heat and vapour loss. Their impact can be compensated by exergy input from heating, solar radiation, or both. If the exergy destruction of these Sources is reduced, the necessary compensation can also be reduced. This can be accomplished through insulating the greenhouse and making the building more airtight. Other necessary Sources, namely transpiration and loss of CO2, have a low exergy destruction compared to the other Sources. They are therefore the best candidate for "pump" technologies ("vapour heat pump" and "CO2 pump") designed to have a low primary energy use. The combination of these proposed technologies results in an exergy efficient greenhouse with the highest primary energy savings. It can be concluded that exergy analyses add additional information compared to only energy analyses and it supports the development of primary energy efficient greenhouse systems.