RESUMO
A fiber-connectorized K-band integrated-optics two-telescope beam combiner was developed for long-baseline interferometry at the CHARA telescope array utilizing the ultrafast laser inscription (ULI) technique. Single-mode waveguide insertion losses were measured to be â¼1.1d B over the 2-2.3 µm window. The development of asymmetric directional couplers enabled the construction of a beam combiner that includes a 50:50 coupler for interferometric combination and two â¼75:25 couplers for photometric calibration. The visibility of the bare beam combiner was measured at 87% and then at 82% after fiber-connectorization by optimizing the input polarization. These results indicate that ULI technique can fabricate efficient fiber-connectorized K-band beam combiners for astronomical purposes.
RESUMO
We have built and characterized, to our knowledge, the first six-telescope discrete beam combiner (DBC) for stellar interferometry in the astronomical J-band. It is the DBC with the largest number of beam combinations and was manufactured using ultrafast laser inscription in borosilicate glass, with a throughput of ≈56%. For calibration of the visibility-to-pixel matrix, we use a two-input Michelson interferometer and extract the complex visibility. A visibility amplitude of 1.05 and relative precision of 2.9% and 3.8% are extracted for 1328 nm and 1380 nm, respectively. Broadband (≤40n m) characterization is affected by dispersion but shows similar performance.
RESUMO
In ground-based astronomy, starlight distorted by the atmosphere couples poorly into single-mode waveguides, but a correction by adaptive optics, even if only partial, can boost coupling into the few-mode regime, allowing the use of photonic lanterns to convert into multiple single-mode beams. Corrected wavefronts result in focal patterns that couple mostly with circularly symmetric waveguide modes. A mode-selective photonic lantern is hence proposed to convert multimode light into a subset of single-mode waveguides of the standard photonic lantern, thereby reducing the required number of outputs. We ran simulations to show that only two out of the six waveguides of a 1×6 photonic lantern carry >95% of the coupled light to the outputs at D/r0<10 if the wavefront is partially corrected and the photonic lantern is made mode selective.
RESUMO
We present the first on-sky results of a four-telescope integrated optics discrete beam combiner (DBC) tested at the 4.2 m William Herschel Telescope. The device consists of a four-input pupil remapper followed by a DBC and a 23-output reformatter. The whole device was written monolithically in a single alumino-borosilicate substrate using ultrafast laser inscription. The device was operated at astronomical H-band (1.6 µm), and a deformable mirror along with a microlens array was used to inject stellar photons into the device. We report the measured visibility amplitudes and closure phases obtained on Vega and Altair that are retrieved using the calibrated transfer matrix of the device. While the coherence function can be reconstructed, the on-sky results show significant dispersion from the expected values. Based on the analysis of comparable simulations, we find that such dispersion is largely caused by the limited signal-to-noise ratio of our observations. This constitutes a first step toward an improved validation of the DBC as a possible beam combination scheme for long-baseline interferometry.
RESUMO
Astrophotonics is an emerging field that focuses on the development of photonic components for astronomical instrumentation. With ongoing advancements, astrophotonic solutions are already becoming an integral part of existing instruments. A recent example is the 60M ESO GRAVITY instrument at the Very Large Telescope Interferometer, Chile, that makes heavy use of photonic components. We envisage far-reaching applications in future astronomical instruments, especially those intended for the new generation of extremely large telescopes and in space. With continued improvements in extreme adaptive optics, the case becomes increasingly compelling. The joint issue of JOSA B and Applied Optics features more than 20 state-of-the-art papers in diverse areas of astrophotonics. This introduction provides a summary of the papers that cover several important topics, such as photonic lanterns, beam combiners and interferometry, spectrographs, OH suppression, and coronagraphy.
RESUMO
Bose-Einstein condensates (BECs) in free fall constitute a promising source for space-borne interferometry. Indeed, BECs enjoy a slowly expanding wave function, display a large spatial coherence and can be engineered and probed by optical techniques. Here we explore matter-wave fringes of multiple spinor components of a BEC released in free fall employing light-pulses to drive Bragg processes and induce phase imprinting on a sounding rocket. The prevailing microgravity played a crucial role in the observation of these interferences which not only reveal the spatial coherence of the condensates but also allow us to measure differential forces. Our work marks the beginning of matter-wave interferometry in space with future applications in fundamental physics, navigation and earth observation.
RESUMO
We present a compact and robust distributed-feedback diode laser system architecture for ultracold atom experiments with K41 and Rb87 in a mobile setup operating at the ZARM drop tower in Bremen. Our system withstands DC accelerations of up to 43 g in operation with only minor adjustments over several drop campaigns. Micro-integrated master-oscillator-power-amplifier modules in conjunction with miniaturized, free-space opto-mechanics are integrated on a platform with a volume of 43 L. With compact control and driver electronics, this laser system features output power and spectral characteristics suitable for 2D+ and 3D magneto-optical trapping operation, atomic state preparation, Bragg-diffraction-based atom interferometry, and detection.
RESUMO
Owing to the low-gravity conditions in space, space-borne laboratories enable experiments with extended free-fall times. Because Bose-Einstein condensates have an extremely low expansion energy, space-borne atom interferometers based on Bose-Einstein condensation have the potential to have much greater sensitivity to inertial forces than do similar ground-based interferometers. On 23 January 2017, as part of the sounding-rocket mission MAIUS-1, we created Bose-Einstein condensates in space and conducted 110 experiments central to matter-wave interferometry, including laser cooling and trapping of atoms in the presence of the large accelerations experienced during launch. Here we report on experiments conducted during the six minutes of in-space flight in which we studied the phase transition from a thermal ensemble to a Bose-Einstein condensate and the collective dynamics of the resulting condensate. Our results provide insights into conducting cold-atom experiments in space, such as precision interferometry, and pave the way to miniaturizing cold-atom and photon-based quantum information concepts for satellite-based implementation. In addition, space-borne Bose-Einstein condensation opens up the possibility of quantum gas experiments in low-gravity conditions1,2.
RESUMO
We present micro-integrated diode laser modules operating at wavelengths of 767 and 780 nm for cold quantum gas experiments on potassium and rubidium. The master-oscillator-power-amplifier concept provides both narrow linewidth emission and high optical output power. With a linewidth (10 µs) below 1 MHz and an output power of up to 3 W, these modules are specifically suited for quantum optics experiments and feature the robustness required for operation at a drop tower or on-board a sounding rocket. This technology development hence paves the way toward precision quantum optics experiments in space.
RESUMO
We report on the MARS2013 mission, a 4-week Mars analog field test in the northern Sahara. Nineteen experiments were conducted by a field crew in Morocco under simulated martian surface exploration conditions, supervised by a Mission Support Center in Innsbruck, Austria. A Remote Science Support team analyzed field data in near real time, providing planning input for the management of a complex system of field assets; two advanced space suit simulators, four robotic vehicles, an emergency shelter, and a stationary sensor platform in a realistic work flow were coordinated by a Flight Control Team. A dedicated flight planning group, external control centers for rover tele-operations, and a biomedical monitoring team supported the field operations. A 10 min satellite communication delay and other limitations pertinent to human planetary surface activities were introduced. The fields of research for the experiments were geology, human factors, astrobiology, robotics, tele-science, exploration, and operations research. This paper provides an overview of the geological context and environmental conditions of the test site and the mission architecture, in particular the communication infrastructure emulating the signal travel time between Earth and Mars. We report on the operational work flows and the experiments conducted, including a deployable shelter prototype for multiple-day extravehicular activities and contingency situations.
Assuntos
Marte , Simulação de Ambiente Espacial , Abrigo de Emergência , Humanos , Marrocos , PesquisaRESUMO
Abstract We have developed a portable dual-wavelength laser fluorescence spectrometer as part of a multi-instrument optical probe to characterize mineral, organic, and microbial species in extreme environments. Operating at 405 and 532 nm, the instrument was originally designed for use by human explorers to produce a laser-induced fluorescence emission (L.I.F.E.) spectral database of the mineral and organic molecules found in the microbial communities of Earth's cryosphere. Recently, our team had the opportunity to explore the strengths and limitations of the instrument when it was deployed on a remote-controlled Mars analog rover. In February 2013, the instrument was deployed on board the Magma White rover platform during the MARS2013 Mars analog field mission in the Kess Kess formation near Erfoud, Morocco. During these tests, we followed tele-science work flows pertinent to Mars surface missions in a simulated spaceflight environment. We report on the L.I.F.E. instrument setup, data processing, and performance during field trials. A pilot postmission laboratory analysis determined that rock samples acquired during the field mission exhibited a fluorescence signal from the Sun-exposed side characteristic of chlorophyll a following excitation at 405 nm. A weak fluorescence response to excitation at 532 nm may have originated from another microbial photosynthetic pigment, phycoerythrin, but final assignment awaits development of a comprehensive database of mineral and organic fluorescence spectra. No chlorophyll fluorescence signal was detected from the shaded underside of the samples.
Assuntos
Marte , Simulação de Ambiente Espacial , Espectrometria de Fluorescência/instrumentação , Robótica/instrumentaçãoRESUMO
Martian caves are regarded as one of the most interesting locations in which to search for life on the planet. Data obtained during the MARS2013 expedition at Hamar Laghdad Ridge in the Tafilalt region of Morocco indicate that even small cavities can display thermal behavior that is characteristic for caves. For example, temperature in a cavity equaled 14°C±0.1°C before sunrise, which was higher than the temperature of the ambient air (10°C±0.1°C) and proximate rocks (9°C±0.1°C) at the same time. Within 30 min after sunrise, when the temperature of surrounding rocks corresponded to 15°C, this thermal relationship reversed. Measurements were conducted under simulated spaceflight conditions, including near-real-time interpretation of data that were acquired in a complex flight planning environment. We conclude that using ground-based thermal contrast measurements, in 7-14 µm band before and after sunset, is an effective method for Mars astronauts to identify caves, possibly superior to usage of space-based or ground-penetrating data.