A green, fluorescent probe employing erythrosine-B for tracing the accidental administration of levamisole in milk and plasma samples.

A simple and sensitive fluorescent probe has been developed and optimized to detect the non-intentional administration of levamisole (LVM). LVM is used as an anthelmintic therapy in cows, and hence, its residues appear in the drained milk until 60 hours after administering the drug. Meanwhile, levamisole is known to be an adulterant to cocaine and could be detected in addicts' plasma samples. Owing to its severe side effects, including agranulocytosis, which is lethal in many cases, detection and quantification of LVM in milk and plasma samples are of utmost importance. Therefore, a sensitive and selective analytical method is required for this purpose. This work develops a highly fluorescent probe obtained through the reaction between LVM and erythrosine-B in an acidic medium, where the produced ion pair complex has been measured at 553 nm after excitation at 528 nm. The proposed method provides linearity over the concentration range of 0.5-2.0 µg mL-1 for LVM, with a corresponding detection and quantitation limit of 0.5 and 0.3 µg mL-1. Full validation was performed, permitting the application of the suggested method to perform simple extraction steps. All the applied procedures followed the guidelines offered by green analytical chemistry, where the Green Analytical Procedure Index (GAPI) assessed the greenness of the proposed tool, and the yielded pictograms proved the eco-friendliness of the offered tool.

An eco-friendly and cost-effective HPTLC method for quantification of COVID-19 antiviral drug and co-administered medications in spiked human plasma.

The coronavirus-2 has led to a global pandemic of COVID-19 with an outbreak of severe acute respiratory syndrome leading to worldwide quarantine measures and a rise in death rates. The objective of this study is to propose a green, sensitive, and selective densitometric method to simultaneously quantify remdesivir (REM) in the presence of the co-administered drug linezolid (LNZ) and rivaroxaban (RIV) in spiked human plasma. TLC silica gel aluminum plates 60 F254 were used as the stationary phase, and the mobile phase was composed of dichloromethane (DCM): acetone (8.5:1.5, v/v) with densitometric detection at 254 nm. Well-resolved peaks have been observed with retardation factors (Rf) of 0.23, 0.53, and 0.72 for REM, LNZ, and RIV, respectively. A validation study was conducted according to ICH Q2 (R1) Guidelines. The method was rectilinear over the concentration ranges of 0.2-5.5 µg/band, 0.2-4.5 µg/band and 0.1-3.0 µg/band for REM, LNZ and RIV, respectively. The sensitivities of REM, LIN, and RIV were outstanding, with quantitation limits of 128.8, 50.5, and 55.8 ng/band, respectively. The approach has shown outstanding recoveries ranging from 98.3 to 101.2% when applied to pharmaceutical formulations and spiked human plasma. The method's greenness was assessed using Analytical Eco-scale, GAPI, and AGREE metrics.

Quick simultaneous analysis of bambuterol and montelukast based on synchronous spectrofluorimetric technique.

Sensitive, simple and green analytical methodology for simultaneous estimation of bambuterol and montelukast as a combined medication based on their native fluorescence character was developed. The method relies on synchronous spectrofluorimetry to solve the problem of the overlapping emission spectra of the studied drugs. Using second derivative synchronous spectra enabled the simultaneous quantitation of bambuterol and montelukast without interference. The peak amplitudes of the aqueous solutions at Δλ = 20 nm were estimated at 284 and 304 nm for bambuterol and at 374 and 384 nm for montelukast. A linear relationship was achieved over the concentration range of 0.2-1.00 µg ml-1 for bambuterol and 0.4-2.00 µg ml-1 for montelukast. All factors and parameters were carefully studied to obtain the highest sensitivity and good precision of the proposed method. Additionally, the validation criteria were assessed in accordance with International Council of Harmonization (ICH) guidelines. The method was used for the estimation of both drugs in their raw materials, synthetic mixtures as well their combined tablets with good agreement between its results and those from the comparison method.

An ecofriendly green liquid chromatographic method for simultaneous determination of nicotinamide and clindamycin phosphate in pharmaceutical gel for acne treatment.

A new green micellar liquid chromatographic method was developed and validated for the quantitative estimation of nicotinamide (NICO) and clindamycin phosphate (CLD) in bulk and pharmaceutical gel formulation. The analytes are well resolved in less than 6.0 minutes using micellar mobile phase consisting of 0.10M sodium dodecyl sulfate (SDS), 0.3% triethylamine, and 10% 2-propanol in 0.02M orthophosphoric acid at pH 3.0, running through an Eclipse XDB-C8 column (150 mm×4.6 mm, 5 µm particle size) with flow rate 1.0 mL/min. The effluent was monitored with diode array detection at 210 nm. The retention times of NICO and CLD were 3.8 minutes and 5.6 minutes, respectively. The method was validated according to the International Conference on Harmonisation (ICH) guidelines in terms of linearity, limit of detection, limit of quantification, accuracy, precision, robustness, and specificity to prove its reliability. Linear correlation was achieved by plotting the peak area of each drug against its concentration. It was found to be rectilinear in the ranges of 1.0-40.0 µg/mL and 0.5-15.0 µg/mL with limits of detection of 0.06 µg/mL and 0.03 µg/mL and limits of quantification of 0.19 µg/mL and 0.09 µg/mL for NICO and CLD, respectively. The method was successfully implemented for the simultaneous determination of the analytes in their bulk powder and combined gel formulation with high % recoveries. The ease of sample treatment facilitates and greatly expedites the treatment with reduced cost and improved accuracy of the procedure.

A validated HPLC method for the determination of dimethyl-4,4'-dimethoxy-5,6,5',6'-dimethylene dioxybiphenyl-2,2'-dicarboxylate (DDB) with fluorescence detection in raw material and pill form: application to an in vitro dissolution test and a content uniformity test.

A simple, sensitive and rapid HPLC method with fluorescence detection for the determination of dimethyl-4,4'-dimethoxy-5,6,5',6'-dimethylene dioxybiphenyl-2,2'-dicarboxylate (DDB) in the raw material and pill form was developed. Liquid chromatography was performed on a C18 column (250 × 4.6 mm i.d., 5 µm particle size), the mobile phase consisted of methanol and 0.05 M sodium dihydrogen phosphate buffer (80 : 20, v/v), and the apparent pH of the mobile phase was adjusted to 3. The fluorescence detector was operated at excitation/emission wavelengths of 275/400 nm. The proposed method allows the determination of DDB within concentration range 0.1-1.5 µg/mL with a limit of detection of 0.032 µg/mL, a limit of quantification of 0.097 µg/mL and a correlation coefficient of 0.9997. The proposed method has been successfully applied for the analysis of DDB in its pills with a percentage recovery of 98.45 ± 0.32. The method was fully validated according to ICH guidelines. Moreover, the high sensitivity of the method permits its use in an in vitro dissolution test for DDB under simulated intestinal conditions. In addition, the proposed method was extended to a content uniformity test according to USP guidelines.

Stability-indicating spectrofluorimetric method for determination of itopride hydrochloride in raw material and pharmaceutical formulations.

A simple, sensitive and rapid spectrofluorimetric method for determination of itopride hydrochloride in raw material and tablets has been developed. The proposed method is based on the measurement of the native fluorescence of the drug in water at 363 nm after excitation at 255 nm. The relative fluorescence intensity-concentration plot was rectilinear over the range of 0.1-2 µg/mL (2.5 × 10(-7)-5.06 × 10(-6) mole/L), with good correlation (r = 0.9999), limit of detection of 0.015 µg/mL and a lower limit of quantification of 0.045 µg/mL. The described method was successfully applied for the determination of itopride hydrochloride in its commercial tablets with average percentage recovery of 100.11 ± 0.32 without interference from common excipients. Additionally, the proposed method can be applied for determination of itopride in combined tablets with rabeprazole or pantoprazole without prior separation. The method was extended to stability study of itopride. The drug was exposed to acidic, alkaline, oxidative and photolytic degradation according to ICH guidelines. Moreover, the method was utilized to investigate the kinetics of the alkaline, acidic and oxidative degradation of the drug. A proposal for the degradation pathways was postulated.

Simultaneous HPLC determination of thiocolchicoside and glafenine as well as thiocolchicoside and floctafenine in their combined dosage forms.

Sensitive and accurate high-performance liquid chromatographic methods have been developed for the simultaneous determination of thiocolchicoside (TC)-glafenine (GF) (Mix I) and thiocolchicoside-floctafenine (FN) (Mix II) in their pharmaceutical formulations. The analysis for both mixtures was performed using 250 mm × 4.6 mm i.d., 5 µm particle size C18 Waters Symmetry column. The mobile phase consisted of methanol-0.035 M phosphate buffer (50:50, v/v) of pH 4.5 for Mix I and methanol-0.03 M phosphate buffer (70:30, v/v) of pH 4 for Mix II with flow rate of 1 mL/min and UV detection at 400 nm in both cases. The calibration plots were rectilinear over the concentration range of 0.2-2 µg/mL for TC in both mixtures and 20-200 µg/mL for each of GF and FN . The limits of detection for TC and GF were 0.05 µg/mL and 0.62 µg/mL, respectively, and for TC and FN were 0.02 µg/mL and 0.70 µg/mL, respectively. Additionally, the proposed methods were successfully applied to their combined tablets with average percentage recoveries of 100.35 ± 0.61 and 100.57 ± 0.72% for TC and GF respectively and for TC and FN the percentage recoveries were 101.2 ± 0.72 and 100.36 ± 0.67%, respectively. The results obtained were favorably compared with those given using the comparison methods.

Spectrofluorometric determination of methocarbamol in pharmaceutical preparations and human plasma.

A simple, sensitive and rapid spectrofluorometric method for determination of methocarbamol in pharmaceutical formulations and spiked human plasma has been developed. The proposed method is based on the measurement of the native fluorescence of methocarbamol in methanol at 313 nm after excitation at 277 nm. The relative fluorescence intensity-concentration plot was rectilinear over the range of 0.05-2.0 µg/mL, with good correlation (r=0.9999), limit of detection of 0.007 µg/ mL and a lower limit of quantification of 0.022 µg/ mL. The described method was successfully applied for the determination of methocarbamol in its tablets without interference from co-formulated drugs, such as aspirin, diclofenac, paracetamol and ibuprofen, The results obtained were in good agreement with those obtained using the official method (USP 30).The high sensitivity of the method allowed the determination of the studied drug in spiked human plasma with average percentage recovery of 99.42 ± 3.84.