Preclinical strategy to reduce clinical hepatotoxicity using in vitro bioactivation data for >200 compounds.

Drug-induced liver injury is the most common cause of market withdrawal of pharmaceuticals, and thus, there is considerable need for better prediction models for DILI early in drug discovery. We present a study involving 223 marketed drugs (51% associated with clinical hepatotoxicity; 49% non-hepatotoxic) to assess the concordance of in vitro bioactivation data with clinical hepatotoxicity and have used these data to develop a decision tree to help reduce late-stage candidate attrition. Data to assess P450 metabolism-dependent inhibition (MDI) for all common drug-metabolizing P450 enzymes were generated for 179 of these compounds, GSH adduct data generated for 190 compounds, covalent binding data obtained for 53 compounds, and clinical dose data obtained for all compounds. Individual data for all 223 compounds are presented here and interrogated to determine what level of an alert to consider termination of a compound. The analysis showed that 76% of drugs with a daily dose of <100 mg were non-hepatotoxic (p < 0.0001). Drugs with a daily dose of ≥100 mg or with GSH adduct formation, marked P450 MDI, or covalent binding ≥200 pmol eq/mg protein tended to be hepatotoxic (∼ 65% in each case). Combining dose with each bioactivation assay increased this association significantly (80-100%, p < 0.0001). These analyses were then used to develop the decision tree and the tree tested using 196 of the compounds with sufficient data (49% hepatotoxic; 51% non-hepatotoxic). The results of these outcome analyses demonstrated the utility of the tree in selectively terminating hepatotoxic compounds early; 45% of the hepatotoxic compounds evaluated using the tree were recommended for termination before candidate selection, whereas only 10% of the non-hepatotoxic compounds were recommended for termination. An independent set of 10 GSK compounds with known clinical hepatotoxicity status were also assessed using the tree, with similar results.

Biopharmaceutics classification system: validation and learnings of an in vitro permeability assay.

The Biopharmaceutics Classification System (BCS) is the scientific basis for classifying drugs based on their aqueous solubility and intestinal permeability that supports in vivo bioavailability and bioequivalence waivers for immediate-release solid dosage form drugs. One requirement of the BCS is that the permeability method must be validated. In order to accommodate the variety of in vitro/in situ permeability models, the BCS Guidance gives a general framework for the validation requirements, necessitating implemented experimental details to be selected by the applicant laboratory. The objective of this work was to define the parameters for a cell based in vitro permeability method (e.g., cell type, pH, transport direction, time, and concentration) and validate the method to support formal BCS classification of drugs. Twenty reference drugs were selected and permeability values determined using the Madin-Darby canine kidney type II cell line heterologously expressing the human P-glycoprotein transporter (MDCKII-MDR1). A rank order relationship was established between the in vitro permeability value and human intestinal absorption values. This relationship was as predicted and validates the MDCKII-MDR1 permeability method as defined by the BCS Guidance. The final validated in vitro permeability method employs the MDCKII-MDR1 cell line incubated with the Pgp inhibitor GF120918. It is a unidirectional apical-to-basolateral transport assay performed at apical pH values of 5.5 and 7.4 and a basolateral pH of 7.4. Four reference standards (metoprolol, pindolol, labetalol and ranitidine) dosed and analyzed as a single cassette are included in each experiment. A strategy on selection of drug concentrations and on how to deal with problematic compounds (i.e., those suffering from poor mass balance) is discussed.