Discovery and Early Clinical Development of Isobutyl 1-[8-Methoxy-5-(1-oxo-3H-isobenzofuran-5-yl)-[1,2,4]triazolo[1,5-a]pyridin-2-yl]cyclopropanecarboxylate (LEO 39652), a Novel "Dual-Soft" PDE4 Inhibitor for Topical Treatment of Atopic Dermatitis.

We describe the design of a novel PDE4 scaffold and the exploration of the dual-soft concept to reduce systemic side effects via rapid elimination: introducing ester functionalities that can be inactivated in blood as well as by the liver (dual-soft) while being stable in human skin. Compound 40 was selected as a clinical candidate as it was potent and rapidly degraded by blood and liver to inactive metabolites and because in preclinical studies it showed high exposure at the target organ: the skin. Preclinical and clinical data are presented confirming the value of the dual-soft concept in reducing systemic exposure.

Pressurized hot water extraction of insecticides from process dust--comparison with supercritical fluid extraction.

Pressurized hot liquid water and steam were used to investigate the possibilities of extracting insecticides (carbofuran, carbosulfan, and imidacloprid) from contaminated process dust remaining from seed-pellet production. Extraction temperature was the most important parameter in influencing the extraction efficiency and rate of extraction, while varying the pressure had no profound effect. A clean-up procedure of the water extracts using solid phase extraction (SPE) was found to be necessary prior to final analysis by high-performance liquid chromatography (HPLC). Quantitative extraction (compared to a validated organic solvent extraction method) of imidacloprid was obtained at temperatures of 100-150 degrees C within 30 min extraction time. Temperatures above 150 degrees C were required to extract carbofuran efficiently. The most non-polar analyte of the investigated compounds, carbosulfan, gave no detectable concentrations with pressurized hot water extraction (PHWE). One reason might be its low solubility in water, and when attempts are made to increase its solubility by increasing the temperature it may degrade to carbofuran. This can explain recovery values above 100% for carbofuran at higher temperatures. A comparison of the PHWE results and those obtained with supercritical fluid extraction (SFE) revealed that PHWE is advantageous for polar compounds, where the solubility of the analyte in water is high enough that lower temperatures can be used. For non-polar compounds carbon dioxide based extraction is preferred unless the target analyte is highly thermostable.

Harmful azo colorants in leather. Determination based on their cleavage and extraction of corresponding carcinogenic aromatic amines using modern extraction techniques.

This study concerns the possibilities of using microwave-assisted extraction (MAE) or supercritical fluid extraction (SFE) for detection of harmful azo colorants in leather. After degreasing of the leather sample with SFE there follows a reductive cleavage of the azo colorants to their corresponding aromatic amines in the MAE or SFE equipment. The aromatic amines are subsequently extracted using either MAE or SFE and then finally determined by liquid chromatography with diode-array detection. The results have been compared with recoveries obtained using the German DIN method 53316. This standard method, based on conventional solvent extraction, is used in several European countries. Overall much better recoveries were obtained using MAE or SFE. With both MAE and SFE the amine recoveries of spiked leather samples were generally above 50%. The average recoveries were 62% for MAE and 60% for SFE (solvent collection) compared to 24% with the DIN method. For genuine leather samples the recoveries decreased, especially for benzidine. In this case the average values for MAE, SFE and DIN were 54, 38 and 19%, respectively. The quantification limits in leather samples using MAE or SFE were below 1 mg/kg for all amines investigated. The within-laboratory precision was generally better than 10%, varying somewhat with the analyte considered. With the proposed methodology, the amount of hazardous organic solvents used could be decreased and the sample throughput increased with at least a factor of two with less manual handling compared to the DIN method.

Collection in analytical-scale supercritical fluid extraction.

This review is a comprehensive summary of available collection techniques in supercritical fluid extraction (SFE), with emphasis on which parameters are especially important for a successful analyte collection. Environmental, biological and agricultural applications, including several types of sample matrices and analyte groups, are discussed with respect to choice of collection mode and optimization of collection conditions. This review also includes discussions about collection when a modifier is used or when the sample contains large amounts of fat or water, as well as possibilities to achieve enhanced selectivity.