RESUMO
The Colombian Chocó is known for its rich biodiversity and to harbor plant species that are under-explored, including the genus Sloanea. This study aimed to analyze the chemical composition of derivatized ethanolic extracts from S. chocoana and S. pittieriana using BSTFA and TMCS through GC-MS, and to assess cell viability of immortalized human non-tumorigenic keratinocytes (HaCaT) and periodontal ligament fibroblast cells using crude extracts through MTS assay. Antioxidant and photoprotective properties were determined using DPPH assay and spectrophotometry. Antifungal activity of extracts against Candida species was developed following the CLSI standard M27, 4th ed. The sun protective factor (SPF) and UVA/UVB ratio values were calculated using the Mansur equation and the Boots star rating system. The critical wavelength (λc) was determined by calculating the integrated optical density curve's area. The transmission of erythema and pigmentation was calculated through equations that use constants to calculate the flux of erythema and pigmentation. The GC-MS analysis identified 37 compounds for S. chocoana and 38 for S. pittieriana, including alkaloids, triterpenoids, and polyphenolics, among others. Both extracts exhibited proliferative effects on periodontal ligament fibroblasts, did not affect the viability of HaCaT cells, and showed excellent antioxidant activities (46.1% and 43.7%). Relevant antifungal activity was observed with S. pittieriana extract against Candida albicans (GM-MIC: 4 µg/mL), followed by C. auris and C. glabrata (GM-MIC: 32 µg/mL), while S. chocoana extract was active against C. albicans and C. glabrata (GM-MIC: 16 and 32 µg/mL, respectively). High SPF values (31.0 and 30.0), λc (393.98 and 337.81 nm), UVA/UVB ratio (1.5 and 1.2), and low percentage of transmission of erythema and pigmentation were determined for S. chocoana and S. pittieriana, respectively. Results showed that species of Sloanea constitute a promising alternative as ingredients for developing skincare products, and exhaustive studies are required for their sustainable uses.
RESUMO
Sloanea is a plant genus, native to tropical regions, used in medicinal practices for its anti-inflammatory properties. This study aimed to determine the antioxidant activity, sun protective factor (SPF), and antifungal of extracts obtained from two species of Sloanea and to develop extract-based gels with antioxidants, photoprotective, and anti-Candida albicans effects. Ethanolic extracts from S. medusula and S. calva collected in Chocó, Colombia, were used for antioxidant activity and SPF determination using the DPPH assay and the Mansur equation, respectively. Extracts were characterized using HPLC-MS and used to prepare the gels. The viscosity of the extract-based gels was evaluated using an MCR92 rheometer. In addition, the anti-Candida activity of extracts against five yeasts and anti-C. albicans of gels were evaluated following the Clinical and Laboratory Standards Institute M27, 4th Edition. High DPPH radical scavenging activity (42.4% and 44.7%) and a high SPF value (32.5 and 35.4) were obtained for the extracts of S. medusula and S. calva, respectively. Similarly, extract-based gels showed significant DPPH radical scavenging activity of 54.5% and 53.0% and maximum SPF values of 60 and 57. Extract from S. medusula showed an important antifungal activity against C. albicans (minimal inhibitory concentration (MIC) of 2 µg/mL). In contrast, S. calva extract was active against C. krusei, C. albicans (MIC of 2 µg/mL) and C. tropicalis (MIC of 4 µg/mL). Sloanea medusula gel (0.15%) exhibited an important C. albicans growth inhibition (98%), while with S. calva gel (0.3%) growth inhibition was slightly lower (76%). Polyphenolic and triterpenoid compounds were tentatively identified for S. medusula and S. calva, respectively. Both extracts can be considered promising sources for developing photoprotective gels to treat skin infections caused by C. albicans.
RESUMO
In this work, the photo-Fenton process at near-neutral pH was applied for the removal of the ß-lactam antibiotic oxacillin (OXA) in water using artificial and sunlight. Initially, the main variables of the process (Fe(II), H2O2, and light power) were optimized by a statistical factorial design (23 with center points). The experimental design indicated that 90 µmol L-1 of Fe(II), 10 mmol L-1 of H2O2, and 30 W of power light were the favorable conditions for degradation of OXA at 203 µmol L-1. In the photo-Fenton system, the H2O2 alone, UV-light/H2O2, and Fe(II)/H2O2 subsystems presented a significant participation on antibiotic removal. Moreover, based on the primary organic transformation products, a mechanism of OXA degradation was proposed. Under the favorable operational conditions, both the pollutant and the antimicrobial activity were eliminated after 50 min of process application. Although at 480 min of treatment, only 5% of mineralization was achieved, the level of biodegradability of the solutions increased from 0.08 to 0.98. Interestingly, the presence of pharmaceutical additives (glucose, isopropanol, and oxalic acid) had a moderate interference on the efficiency of the pollutant removal. Additionally, the treatment at pilot scale of the ß-lactam antibiotic in a pharmaceutical complex matrix using solar radiation allowed the complete removal of the pollutant and its associated antimicrobial activity in a very short time period (5 min). These results evidenced the applicability of the photo-Fenton process to treat wastewaters from pharmaceutical industry loaded with ß-lactam antibiotics at near neutral pH values efficiently.
Assuntos
Antibacterianos , Peróxido de Hidrogênio , Ferro , Luz , Oxacilina , Águas Residuárias , Purificação da Água/métodos , Biodegradação Ambiental , Indústria Farmacêutica , Humanos , Peróxido de Hidrogênio/química , Concentração de Íons de Hidrogênio , Ácido Oxálico , Oxirredução , Preparações Farmacêuticas , Luz Solar , Raios Ultravioleta , Eliminação de Resíduos Líquidos/métodos , Poluentes Químicos da Água , beta-LactamasRESUMO
This study evaluates the treatment of the antibiotic cloxacillin (CLX) in water by means of electrochemical oxidation, TiO2 photocatalysis, and the photo-Fenton system. The three treatments completely removed cloxacillin and eliminated the residual antimicrobial activity from synthetic pharmaceutical wastewater containing the antibiotic, commercial excipients, and inorganic ions. However, significant differences in the degradation routes were found. In the photo-Fenton process, the hydroxyl radical was involved in the antibiotic removal, while in the TiO2 photocatalysis process, the action of both the holes and the adsorbed hydroxyl radicals degraded the pollutant. In the electrochemical treatment (using a Ti/IrO2 anode in sodium chloride as supporting electrolyte), oxidation via HClO played the main role in the removal of CLX. The analysis of initial by-products showed five different mechanistic pathways: oxidation of the thioether group, opening of the central ß-lactam ring, breakdown of the secondary amide, hydroxylation of the aromatic ring, and decarboxylation. All the oxidation processes exhibited the three first pathways. Moreover, the aromatic ring hydroxylation was found in both photochemical treatments, while the decarboxylation of the pollutant was only observed in the TiO2 photocatalysis process. As a consequence of the degradation routes and mechanistic pathways, the elimination of organic carbon was different. After 480 and 240 min, the TiO2 photocatalysis and photo-Fenton processes achieved â¼45 and â¼15 % of mineralization, respectively. During the electrochemical treatment, 100 % of the organic carbon remained even after the antibiotic was treated four times the time needed to degrade it. In contrast, in all processes, a natural matrix (mineral water) did not considerably inhibit pollutant elimination. However, the presence of glucose in the water significantly affected the degradation of CLX by means of TiO2 photocatalysis.
Assuntos
Cloxacilina/química , Cloxacilina/isolamento & purificação , Peróxido de Hidrogênio/química , Ferro/química , Fotólise , Titânio/química , Purificação da Água/métodos , Antibacterianos/química , Antibacterianos/isolamento & purificação , Antibacterianos/farmacologia , Cloxacilina/farmacologia , Eletroquímica , Oxirredução , Águas Residuárias/química , Poluentes Químicos da Água/química , Poluentes Químicos da Água/isolamento & purificação , Poluentes Químicos da Água/farmacologiaRESUMO
This work studies the sonochemical degradation of a penicillinic antibiotic (oxacillin) in simulated pharmaceutical wastewater. High frequency ultrasound was applied to water containing the antibiotic combined with mannitol or calcium carbonate. In the presence of additives, oxacillin was efficiently removed through sonochemical action. For comparative purposes, the photo-Fenton, TiO2 photocatalysis and electrochemical oxidation processes were also tested. Therefore, the evolution of the antibiotic and its associated antimicrobial activity (AA) were monitored. A high inhibition was found for the other three oxidation processes in the elimination of the antimicrobial activity caused by the additives; while for the ultrasonic treatment, a negligible effect was observed. The sonochemical process was able to completely degrade the antibiotic, generating solutions without AA. In fact, the elimination of antimicrobial activity showed an excellent performance adjusted to exponential kinetic-type decay. The main sonogenerated organic by-products were determined by means of HPLC-MS. Four intermediaries were identified and they have modified the penicillinic structure, which is the moiety responsible for the antimicrobial activity. Additionally, the possible oxacillin sonodegradation mechanism was proposed based on the evolution of the by-products and their chemical structure. Furthermore, the high-frequency ultrasound action over 120 min readily removed oxacillin and eliminated its antimicrobial activity. However, the pollutant was not mineralized even after a long period of ultrasonic irradiation (360 min). Interestingly, the previously sonicated water containing oxacillin and both additives was completely mineralized using non-adapted microorganisms from a municipal wastewater treatment plant. These results show that the sonochemical treatment transformed the initial pollutant into substances that are biotreatable with a typical aerobic biological system.
Assuntos
Penicilinas/isolamento & purificação , Penicilinas/farmacologia , Ultrassom , Poluentes Químicos da Água/isolamento & purificação , Poluentes Químicos da Água/farmacologia , OxirreduçãoRESUMO
Synthetic pharmaceutical effluents loaded with the ß-lactam antibiotic oxacillin were treated using advanced oxidation processes (the photo-Fenton system and TiO2 photocatalysis) and chloride mediated electrochemical oxidation (with Ti/IrO2 anodes). Combinations of the antibiotic with excipients (mannitol or tartaric acid), an active ingredient (calcium carbonate, i.e. bicarbonate ions due to the pH) and a cleaning agent (sodium lauryl ether sulfate) were considered. Additionally, urban wastewater that had undergone biological treatment was doped with oxacillin and treated with the tested systems. The evolution of antimicrobial activity was monitored as a parameter of processes efficiency. Although the two advanced oxidation processes (AOPs) differ only in the way they produce OH, marked differences were observed between them. There were also differences between the AOPs and the electrochemical system. Interestingly, each additive had a different effect on each treatment. For water loaded with mannitol, electrochemical treatment was the most suitable option because the additive did not significantly affect the efficiency of the system. Due to the formation of a complex with Fe(3+), tartaric acid accelerated the elimination of antibiotic activity during the photo-Fenton process. For TiO2 photocatalysis, the presence of bicarbonate ions contributed to antibiotic activity elimination through the possible formation of carbonate and bicarbonate radicals. Sodium lauryl ether sulfate negatively affected all of the processes. However, due to the higher selectivity of HOCl compared with OH, electrochemical oxidation showed the least inhibited efficiency. For the urban wastewater doped with oxacillin, TiO2 photocatalysis was the most efficient process. These results will help select the most suitable technology for the treatment of water polluted with ß-lactam antibiotics.