RESUMO
Achieving a high electrocatalytic performance using a completely metal-free electrocatalyst, preferably based on only carbonaceous materials, remains a challenge. Alternatively, an efficient composite of a carbon nanostructure and a non-noble metal with minimum dependence on a metal holds immense potential. Although single-atom catalysis brings superior performance, its complex synthetic strategy limits its large-scale implementation. Previous investigation has shown that atomic dispersion (Fe-Nx-C) is accompanied by higher metal-loss compared to nanoparticle formation (Fe-NPs-N-C). Therefore, to achieve minimum metal loss, we first incorporated iron nanoparticles (Fe NPs) to N-doped carbon (N-C) and then exposed them to a cheap carbon source, melamine at high temperature, resulting in the growth of carbon nanotubes (CNTs) catalysed by those Fe NPs loaded on N-C (Fe-NPs-N-C). Thermogravimetric analysis showed that the metal-retention in the composite is higher than that in the bare carbon nanotube and even the atomically dispersed Fe-active sites on N-C. The composite material (Fe-NPs-N-C/CNT) shows a high half-wave potential (0.89 V vs. RHE) which is superior to that of commercial Pt/C towards the oxygen reduction reaction (ORR). The enhanced activity is attributed to the synergistic effect of high conductivity of CNTs and active Fe-sites as the composite exceeds the individual electrocatalytic performance shown by Fe-CNTs & Fe-NPs-N-C, and even that of atomically dispersed Fe-active sites on N-C.
RESUMO
Even though the anion exchange membrane fuel cells have many advantages, the stability of their electrocatalysts for oxygen reduction reaction (ORR) has remained remarkably poor. We report here on the ultrathin twisty PdNi-alloy nanowires (NWs) exhibiting a very low reaction overpotential with an E1/2 â¼ 0.95 V versus RHE in alkaline media maintained over 200 K cycles, the highest ever recorded for an electrocatalyst. The mass activity of the used NWs is >10 times higher than fresh commercial Pt/C. Therein, Ni improves the Pd d-band center for a more efficient ORR, and its leaching continuously regenerates the surface active sites. The twisty nanowire morphology imparts multiple anchor points on the electrode surface to arrest their detachment or coalescence and extra stability from self-entanglement. The significance of the NW morphology was further confirmed from the high-temperature durability studies. The study demonstrates that tailoring the number of contact points to the electrode-surface may help realize commercial-grade stability in the highly active electrocatalysts.
RESUMO
Selective oxidation of amines to imines using sunlight as clean and renewable energy source is an important but challenging chemical transformation because of high reactivity of the generated imines and lack of visible light-responsive materials with high conversion rates. In addition, oxygen gas has to be purged in the reaction mixture in order to increase the reaction efficiency which, in itself, is an energy-consuming process. Herein, we report, for the first time, the use of Ag3PO4 as an excellent photocatalyst for the oxidative coupling of benzyl amines induced by ambient air in the absence of any external source of molecular oxygen at room temperature. The conversion efficiency for the selective oxidation of benzyl amine was found to be greater than 95% with a selectivity of >99% after 40 min of light irradiation indicating an exceptionally high conversion efficiency with a rate constant of 0.002 min-1, a turnover frequency of 57 h-1, and a quantum yield of 19%, considering all of the absorbed photons. Ag3PO4, however, is known for its poor photostability owing to a positive conduction band position and a favorable reduction potential to metallic silver. Therefore, we further employed a simple catalyst regeneration strategy and showed that the catalyst can be recycled with negligible loss of activity and selectivity.
